查询词典 mode of vibration

The SCC has the following advantages: remarkably reducing the noisy pollution and the worker s labor intensity in construction, deducing the rough surface or segregation because of missing-vibration or excessive-vibration in conventional construction, resolving the quality-defect problems resulting from lacking-vibration in the section of complex shapes and densely-packed reinforcement area. At the same time, large of industrial solid waste such as fly ash and blast furnace slag is utilized in the proportioning of SCC. It is helpful in comprehensive utilization of resource and environment protection, so the SCC belongs to "green concrete", it is a branch of HPC which will be developed in the future.

这种混凝土可以显著降低混凝土施工中的噪音污染；大幅度减轻工人的劳动强度；减少传统混凝土施工中因漏振或过振造成的麻面或离析；解决了配筋密集、结构复杂部位因振捣不足而造成的质量缺陷问题；同时，由于自密实混凝土在配制中，大量利用粉煤灰、高炉矿渣等工业固体废弃物，有利于资源的综合利用和生态环境的保护；从而被誉为&绿色混凝土&，是未来混凝土向高性能发展的方向之一。

In this paper Ⅰ successfully applied these methods to fault diagnosis, and presenting some new innovative machinery fault diagnosis method; First Ⅰ present a new gear wornout fault diagnosis method, this method use the vibration signal's time-frequency attribute and instantaneous phase undulation to accurately detect gear's fault, and by comparing with the traditional frequency domain analysis method, this method reveals that many nonlinear and nonstationary characteristic exist in gear's vibration, this tell us that if we use frequency domain analysis method without pay attention to the signal's characteristic, we could get wrong diagnostic result; Then Ⅰ present a new bearing fault diagnosis method, this method use ATVFD and Hilbert transform to do envelop demodulation,Ⅰ analyze the envelop with time-frequency method and find out that this method is more accurate then traditional method.Ⅰ also explain that the modulation of the fault to the carrier wave may also be non-stationary and nonlinear; Finally Ⅰ present a cylinder pressure measurement method of diesel engine by means of vibration, cylinder pressure is an important parameter of diesel engine fault diagnosis, the pressure measuring is simplified a lot by this method,Ⅰ also use the ATVFD and time-frequency analysis to realize it.

本文中将上述理论方法成功地应用到故障诊断中去，提出了几点创新性的诊断方法；提出了一种齿轮磨损故障诊断的新方法，该方法利用振动信号能量的时频域分布特征与瞬时相位波动特征可以进行精确的齿轮故障诊断，并通过与传统的频域诊断方法的比较，揭示出齿轮振动中存在的明显的非线性与非平稳特征，说明了不加选择地利用频域分析方法进行齿轮故障诊断很可能会得到错误的诊断结果；提出了一种轴承故障诊断的新方法，该方法利用ATVFD分解与Hilbert变换进行包络解调，并对解调得到的包络信号进行时频域分析，可以实现更加准确轴承故障诊断，说明了故障对载波信号的调制往往也是非平稳与非线性的；提出了一种利用振动信号进行柴油机汽缸内压力检测的新方法，柴油机汽缸压力的变化是柴油机故障诊断的重要参数，利用振动方法可大大简化汽缸压力的检测过程，该方法也是综合利用ATVFD分解与时频域分析方法实现的。

The vibration caused by the cylinder and the cylinder head can balance the vibration of the piston. This thesis focuses on an invention test of the vibration of the engines.

本研究针对此一引擎减振发明作实体测试，内容包括对一市售机引擎进改装，使其符合本发明之作动原，然后测此一原型机引擎之振动况。

On the basis of actual blasting vibration field, this paper proposes the method, which can predict the response of the structure to the blasting vibration according to the blasting vibration stimulation and parameters of the structure.

在考虑实际爆破震动场的基础上，本文提出了一种根据爆破震动激励和结构本身参数来预测结构对爆破震动响应的方法。

5The blasting vibration signals are analyzed by time-energy analysis. Identify the time of detonator priming and ascertain reasonable subordinate interval in millisecond delay blasting to decrease blasting vibration and control the damage of blasting. In this paper, wavelet analysis is used to de-noise the blasting vibration signals.

利用基于小波变换的时－能密度法具有的良好的突出被分析信号能量突变的特点，有效地识别微差爆破中各段雷管的起爆时刻，从而确定微差爆破中合理的微差延时，达到降低爆破震动，控制爆破震动危害的目的。

Confirming the space place of weakness plane, potential failure model of slope and comprehensive choosing of rock mechanical properties are discussed in the paper. The blasting vibration is tested and the consults are analyzed by regression analysis, binging forward the velocity and acceleration attenuating law of slope rock mass. The stability of two typical slope profile and sensitivity-analysis of the influence blasting vibration to slope stability are analyzed by Sarma method. Bring forward the technical measures of reducing the influence of blasting vibration to slope stability.

本文针对兰尖矿营盘山高陡边坡的工程地质特点，查明其边坡工程、水文地质条件，弄清控制边坡稳定性的F_(108)、ω_6、泥化夹层等软弱结构面的空间位置和边坡潜在的破坏模式以及岩石力学指标的综合选取；对生产爆破振动进行了测试，并对测试结果进行了回归分析，得出边坡岩体质点振动速度及加速度的衰减规律；用Sarma法对两个典型的边坡剖面进行了稳定性分析和爆破震动对边坡稳定性影响的敏感性分析；提出了降低爆破震动对边坡稳定性影响的技术措施。

After studying casting process from ladle to pouring box and protection casting supporting mechanical structure, vibration dynamics model of supporting structure is founded, also variation of steel water impact force and influencing factors of inspecting spot vibration are discussed. Primary analysis is done for steel water vibration signal by the way of basal wavelet processing method, and the deeply feature extraction is finished to realize the effective recognition for steel water status using wavelet package method.

通过对钢包到中间包保护浇注的过程及其支承结构的相关研究，建立保护浇注支承结构的振动动力学模型，并且考虑对钢液冲击力的变化及影响测振点振动的因素，利用基本小波处理方法对钢水振动信号进行初步分析，并通过小波包技术进行进一步的特征提取，最终实现对钢液状态的有效识别。

Because the current monitoring network cable is complicated and the cost is very high,this paper puts forward to a wireless vibration monitoring node design based on digital accelerometer ADXL202, with MSP430 and CC1100, respectively, as microprocessors and wireless communication module, thereby forming a wireless vibration monitoring networks, realize the vibration monitoring for coal washery plant machinery.

该论文针对当前有线振动监测网络布线复杂、成本高等问题，提出一种基于数字式加速度传感器ADXL202，以MSP430 和CC1100 分别作为微处理器和通信模块所组成的无线振动监测节点设计，进而组成一个无线振动监测网络，实现对洗煤厂机器设备的振动监测，并进行了简单地测试。

The results show that the vibration intensity of the substructure has a connection with the depth of the well, the geological condition and the density of drilling fluid; the horizontal vibration of the substructure is mainly caused by bent kelly; the included angle between the axis of cardan shaft and the derrick floor is also the cause of the vibration in three directions, and the cause of t...

分析结果表明，底座的振动强度与井深、地质条件和钻井液密度有关；弯曲的方钻杆是造成底座水平方向振动的最主要原因；万向轴因与钻台面存在夹角，从而引起底座在三个方向的振动；采用四挡钻进时，万向轴的工频及其倍频接近底座垂直方向的固有频率是引起底座在该方向振动强烈的原因。

5Study on vehicle-bridge coupled vibration program of multi-beams bridgeThe vehicle-bridge coupled vibration equation is detruded on the base of three axisvehicle,and the vehicle-bridge coupled vibration program is established with iteration method,which is used for analyzing the dynamic response of the assembly slab bridge.

5板桥车-桥耦合振动程序研究以三轴车辆为例建立车-桥耦合振动方程，采用分离迭代法，编制了板桥车-桥耦合振动程序，并以实例验证了其计算结果的正确性，为装配式板桥动力响应分析提供计算平台。

Finally it offers the analysis of the fault-tolerance system as well as its test verification.

这样，运行于空间环境中的系统的设计目标就是在保证系统实时性

However, it is still difficult to find out the real reason of the increase of the keratinized gingiva during the orthodontic extrusion whether it is due to the proliferation of the gingival tissue or to its elastic nature, that is because the proliferation of the fibroblasts as well as the connective tissue changes in volume and the intra-fibers spaces were all immeasurable in most of the studies.

然而，仍然难以找到真正的原因增加的角化牙龈在正畸挤压它是否是由于扩散的牙龈组织或其弹性性质，这是因为增殖的成纤维细胞以及作为结缔组织的变化量和内部纤维空格都是不可估量的，大多数的研究。