查询词典 mm.

The minimum thickness of the drift eliminator piece is no less than 1.2 mm, and the service life≥20 years.

收水器片最薄处的厚度不小于1.2 mm，使用寿命≥20年。

Result: The best process of cutting was: the amount of solvent is 0.6 times, soaking for 24 h and the thickness of piece is 2 mm. Conclusion: The obvious difference was displayed by the comparing of HPLC fingerprints.

结果：板蓝根软化切制的最佳工艺为：0.6倍量的水，浸润24 h，饮片厚度为2 mm；结论：建立了板蓝根药材醋酸乙酯萃取物HPLC指纹图谱。

This is taken as either of the following, whichever is exceeded first; deflection of L/20 rate of deflection = L2/(9000d) mm/min where L is the clear span of the specimen and d is the distance from the top of the structural section to the bottom of the design tension zone.

下面任意一项无论哪一项先超出限制： L/20 形变 L2/(9000d) mm/min的形变率，这里L是样品的净跨而&d&是设计的张力区域结构型面上下之间的距离。

The results showed that: planting two crops in a year under the condition of 640 mm annual mean rainfall in the Loess Plateau conduced to the substantial use of solar and water resources in summer fallow, the biomass yield, economical yield and water use efficiency was improved in different degrees, and the material cycle was enhanced.

结果显示：在黄土高原东南部年降雨量达640 mm左右的旱作农田，发展&一年二熟&种植能较好地利用夏闲期的水热资源，不同程度地提高了全年的生物产量、经济产量、水分利用效率，加强了农田物质循环。

Crevice tool, NT all-purpose floor tool (300 mm), Bumper bar, 2 x 0.5 m metal suction tubes , 2.5 m suction hose, Bend, Cartridge filter , Stainless steel container.

吸缝扒头、过滤器装置、NT通用地面吸尘扒头（300 mm）、2根0.5米长的金属管、不绣钢容器。

Through building the FSW heat source model of 4 mm sheet 7075 aluminum alloy, the thermo-mechanical numerical analysis for the temperature field and stress-strain field in the process of FSW was carried out using ANSYS, the distribution of the temperature field and surface residual stress of the sheet aluminum alloy FSW was interpreted.

本文通过建立4 mm薄板7075铝合金搅拌摩擦焊热源模型，利用ANSYS对搅拌摩擦焊接过程中的温度场和应力应变场进行热机耦合数值分析，解释了薄板铝合金搅拌摩擦焊的温度场和表面残余应力的分布。

Mark a point on the steering wheel cover that is longitudinally and transversely, as measured along the surface of the steering wheel cover, within ±6 mm (±0.2 in) of the point that is defined by the intersection of the steering wheel cover and a line between the volumetric center of the smallest volume that can encompass the folded undeployed air bag and the volumetric center of the static fully inflated air bag.

S26.2.2 在方向盘面上划一点作记号，这个点是在沿方向盘的表面测量而确定的。这个点的位置由方向盘表面和能装下未充气折叠气囊最小空间的中心与静止状态下充分冲气气囊的空间中心之间的一条线所交叉的那个点来确定。前面的那个记号点在这个交叉点的纵横±6 mm (±0.2 in)处。

The solution: take a few minutes every day to force their own time, to concentrate on the five official flu - the feeling of holding the steering wheel, engine rotation speed up the voice of the MM next to the car brought about by visual stimulation ......

解决办法：每天迫使自己花几分钟时间，把精力集中在五种官感上——手握方向盘的感觉，发动机加速旋转的声音，隔壁车里的MM带来的视觉刺激……总是对一个问题纠缠不休会增加肾上腺素的分泌。

Taking no account of aberrations,the optical spot size of the lens whose diameter is 1.80 mm is 1.2 μm.Compare the measurement value which is 1.5 μm with the theoretical one,they are almost identical with each others.It also proves the theoretical analysis is reasoned.

在不考虑像差的情况下，直径为1.8 mm的透镜其出射光斑直径为1.2 μm，利用狭缝扫描法进行了实际测量，测量值为1.5 μm，理论值与实验值基本吻合，从而说明理论分析的合理性。

Weapon 1: If the face is not the spots into a block or a sheet, just a little bit sporadic, it is recommended to use Blemish mm were affixed, or high concentrations of Blemish essence attached to the spot, or put a cotton pad and cut a small piece of stained Blemish essence deposited at the spot, so that can reduce the burden on other parts of the skin, more focused and efficient way to lessen his "newborn" spots, killing them at the source.

支招一：如果脸上斑点还不是成块状或者片状，只是零零星星一点点，建议mm们使用淡斑贴或者浓度高的淡斑精华，贴在斑点上，或把化妆棉剪成一小片沾上淡斑精华敷在斑点上，这样可以减少对其他部位肌肤的负担，更集中高效地淡化&初生&斑点，把它们扼杀在源头。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。