查询词典 mirror plane

The presterssed anchor cable frame combined with backwall, drainage is necessary due to longtime sability and permanent utilization.Firstly,according the study of engineering of geology situation of the high slope, the mechanism of deformation failure and the major hazard of the high slope of PanMei is analysed comprehensively.And the whole slope is divided into two different geology enginnering areas:Western slope(1160 section plane -1240 section plane)and Eastern slope(1240 section plane -1320 section plane). The result of 3D numerical simulation is the same as geology judgement. Later,slope cut (1:0.75) is implemented based on the engineering comparison and criterion.Meanwhile, Limit equilibrium method , Monte Carlo Probabilistic slope stability the stability , Sensitivity analysis and Finent element method of for assessing the cutted slope stability is carried out. The result indicates that Western slope is instable, Eastern slope is relatively stable.So much attention should be paid to Western slope.Different reinforcement measures in different areas are given according to its stability and meet economical request. Gravity wall is introduced in accordance with landform in order to prevent small falling at the foot of the high slope ,which will be a threat to the high slope stability. Handling measure is also applied to Eastern slope. At last,FLAC3D numerical analysis shows the feasibility and reasonableness of the handling measure of the high slope.

论文首先研究了边坡的工程地质条件，全面分析边坡的变形破坏机制和边坡的主要地质灾害，将边坡分为西段不稳定边坡区(1160剖面～1240剖面)和东段相对稳定边坡区(1240剖面～1320剖面)，通过三维数值模拟再现了边坡在自重作用下的破坏机制和过程；在此基础上通过工程类比和规范要求，确定按照1：0.75进行放坡处理，并分析了放坡后边坡的稳定性状况，分别通过极限平衡法、蒙特卡洛法概率分析、参数敏感性分析和有限元稳定性计算等多种方法对边坡在各种工况下的进行稳定性研究，计算结果表明，西段边坡较之东段边坡稳定情况差，是边坡支护的关键之处，而东段边坡相对是稳定的；边坡的综合治理措施选用的是框架锚索并结合挡土墙和排水工程，治理设计根据不同区段的稳定性情况采用不同的支护结构，做到了经济合理的要求；在边坡的坡脚设置重力式挡土墙，防治边坡小规模的崩塌，会对上部的锚索支护护造成不利影响，进而影响边坡的稳定；东段边坡的填方区也给出了治理对策；最后通过三维显示拉各朗日有限差分程序(FLAC3D)模拟了高边坡放坡和支护效果，论证了治理措施的有效性和合理性。

Results: The atlanto-occipital transarticular screw trajectory was cephalad tilting in sagittal plane and medially tilting in coronal plane; the ideal angle of the trajectory was (53.3±3.4)° upper tilting in sagittal plane and (20.0±2.6)° midline tilting in coronary plane.

结果：寰枕关节经关节螺钉固定的钉道理想角度为：螺钉方向在矢状面的上倾角为(53.3±3.4)°，在冠状面的内倾角为(20.0±2.6)°。

The Go moved backward with 1.35mm and upward with 1.90mm in group I, the gonial angle increased for 3.69°, and angle between palatal plane and mandibular plane was increased for 5.00°; In group II, the Go moved backward with 1.85mm and upward with 3.32mm , the gonial angle increased for 4.06°, and angle between palatal plane and mandibular plane was increased for 5.22°. Both in group I and II, there was a tread for clockwise rotation of mandibular corpus. The length of pterygomasseteric sling was mild increased due to the backward movement of Go.

在Go点的变动方面，在Me点向前位移的族群里，术后Go点平均向后1.35mm，向上1.90mm， gonial angle 平均增大3.69度，腭平面与下颚平面的夹角则是增加5.00度；在Me点向后位移的族群里，术后Go点平均向后1.85mm，向上3.32mm， gonial angle 平均增大4.06度，腭平面与下颚平面的夹角则是增加5.22度，不论是向前或是向后的族群，结果皆显示翼咀嚼肌悬吊带有轻微被拉长的迹象。

Through Hilbert transform, a signal's plane trace can be get. There are two frequencies in the tested signal, so the signal's plane trace may be looked as the track of the out pole's end when two poles rotate around parallel axles. Using the knowledge of motion synthesis in theory mechanics, a formula to describing the change of plane trace's step length and angle for two-frequency be get. So we may prolongate the tested signal's plane trace from the echo's initial arriving moment, and get a certain length of the signal's prolongation.

通过Hilbert变换可得到测试信号的平面迹线，测试信号中只含有两个频率成分，视为双频信号，双频信号的平面迹线相当于两连杆绕平行轴转动时外杆杆端迹线，利用理论力学中运动合成和瞬心知识，推导出双频信号平面迹线步长平方满足余弦线性复合函数，而迹线转角可视为线性变化，据此可对回波到来之前的测试信号平面迹线作延长，得到一定长度的信号延展段，信号延展段与实测段作差可得到一次、二次回波的第一个波峰值。

The thesis is about the research of the updating problem of strip mine geological model that taking contour plane and section plane as the foundation,adopt the Re-development of CAD,through digitization of mine graphs,use geology stetch data,realize contour plane,section plane upgrading each other,on this basis,have developed the geological information management system of production.

本文主要研究传统露天煤矿以平、剖面为基础的生产地质模型的更新问题，采用二次丌发的方法，通过矿图数字化，使用地质写实信息来实现平、剖面的相互更新，在此基础上，丌发了生产地质信息管理系统。

Finally through to the GMRY crisis management present situation analysis and the company interior crisis cause based on the strategic stratification plane and the operation stratification plane two stratification planes, launches the strategic stratification plane and the operation stratification plane research from the management study basic strategy management process frame and the balance idea branch customs station frame to the GMRY enterprise crisis cause, and the method which using the subjective tax power and the objective tax power, qualitative and the quota unifies determined the target the weight, unifies using the level analytic method and the fuzzy synthesis judgment law then constructs the GMRY crisis to forewarn the distinction model, and forewarns the analysis system through the enterprise crisis, surveys crisis condition which GMRY at present locates, And proposed the crisis forewarns the solution and the implementation enterprise crisis early warning system measure and the suggestion.

最后通过对GMRY公司危机管理现状的分析及公司内部危机诱因基于战略层面及运营层面的两个层面，从管理学基本的战略管理过程框架和平衡计分卡框架对GMRY公司企业危机诱因展开战略层面与运营层面的研究，并运用主观赋权和客观赋权、定性与定量相结合的方法确定出指标的权重，运用层次分析法及模糊综合评判法相结合进而构建出GMRY公司危机预警判别模型，并通过企业危机预警分析系统，测算出GMRY公司目前所处的危机状态，并提出危机预警解决方案和实施企业危机预警系统的措施和建议。

The mechanism of instability wrinkling in the process based on minimum energy principle is revealed, uniform mathematic description of the wrinkling wave on the strip of in-plane bending is established, the internal and external energy is deduced by energy method, and a uniform criteria of internal and external wrinkling is established; then how to combine the criteria with the FEM simulation system to make the numerical prediction of wrinkling into reality is also resolved in the paper. The effects of the forming parameters on the deforming result are analyzed by the uniform predict criteria. The results show as follows: as the compress width increase, external wrinkling first come into being, then internal winkling do, and finally in-plane bend occur; the loading wedge angle increase, internal winkling first come into being, thenin-plane bend do, and finally external wrinkling occur; in-plane bend is possible to occur with a increase of the strain-hardening exponent and the strength coefficient; and the effect of the friction factor may be ignored.

2揭示了板带不均匀压下面内弯曲成形过程基于能量原理的失稳起皱机理，提出了统一的描述内外缘起皱波形的函数，采用变分法推导了服从该波形函数的内外缘起皱能，建立了统一的起皱预测准则；将新建立的统一的起皱预测准则引入到数值模拟系统IBS中，数值预测结果与实验结果的吻合较好；分析了成形过程各参数对起皱的影响规律：随着接触变形区宽度的逐渐增大，先是发生外缘起皱，然后发生内缘起皱，进而才出现稳定成形；随着实际加载楔角的增大，先是发生内缘起皱，然后发生稳定成形，进而出现外缘起皱；硬化指数和强化系数增大，易于稳定成形；摩擦因子对起皱的影响不明显；而且接触变形区宽度对起皱的影响最大。

The Plane of Spiritual Balance, The Plane of Human Spiritual Knowledge, The Plane of Spiritual Austerites, and The Plane of Ultimate Truth.

佛陀教导我们修习的《慈心观》---善护诸根、正直、温和、简朴生活。

Results show that the morphology of HNS changes from short plane-like shape to long plane-like shape when non-solvent temperature changes from 25℃ to 50℃. The morphology comes through the variety of ellipsoid, short plane-like and club-shaped with pH value of non-solvent from acidity to neutral and finally basical, with the particle size distribution in 50-300 nm, 50-500 nm, and 50-600 nm, respectively. Ellipse plane-like and long club-shaped morphology HNS were obtained using white dextrine and sodium carboxymethyl cellulose as surfactants in non-solvent, with the particle size distribution in 50-300 nm and 50-600 nm.

结果表明：非溶剂温度由25℃升高到55℃后，HNS晶体形貌由短片状变为细长片状；pH值由酸性变化到中性再到碱性时，亚微米HNS的晶体形貌经历椭球状、短片状、棒状的系列变化，粒度分布分别处于50~300 nm、50~500 nm、50~600 nm；白糊精和羧甲基纤维素钠作为晶形控制剂修饰后的亚微米HNS晶体形貌分别椭圆片状和长棒状，粒度分布分别处于50~300 nm、50~600 nm。

Introduce the cohesion-friction model of rock strength theory, and extend the model to select the strength of sliding plane, discuss the variation rules of peak strength and residual strength under different normal stress, and then present the selection model of shearing strength. After the result of cohesion-friction model is compared with Coulomb Criterion, it is found that when the results of shearing strength are many and adjacent the strength parameters can not be regressed by least square method, instead the results should be divided into some beelines at that time according to the cohesion-friction model.(4) Discuss the characters of hard structural plane and weak structural plane: The adhesive friction theory is applied to research the changing course of shear area of hard structural plane and its influence on shear stress.

3介绍了岩石强度理论中的粘接摩擦模型，运用此模型分析依附型滑动面的演化过程，并将其推广到边坡岩土体抗剪强度的选取，讨论了不同法向应力下峰值强度和残余强度随法向应力的变化规律，在此基础上给出抗剪强度的选取模式，讨论了对实际取值结果的影响，并与传统的Coulomb准则进行了比较分析，指出直剪试验的法向应力在小应力区的点较多且抗剪强度结果差异不大时，不宜直接运用最小二乘法回归抗剪强度参数，此时应结合粘接摩擦模型对结果进行线性分段。

Article 144 The Government of the Hong Kong Special Administrative Region shall maintain the policy previously practised in Hong Kong in respect of subventions for non-governmental organizations in fields such as education, medicine and health, culture, art, recreation, sports, social welfare and social

第一百四十四条香港特别行政区政府保持原在香港实行的对教育、医疗卫生、文化、艺术、康乐、体育、社会福利、社会工作等方面的民间团体机构的资助政策。原在香港各资助机构任职的人员均可根据原有制度继续受聘。

Small wonder, then, that the Chinese spend more in the shop than any other group of foreign visitors do .

这样的小惊喜，使中国顾客比任何国家的人消费得更多。