查询词典 minimum temperature

The average temperature for 13 ~ 15 ℃, the absolute minimum -10 ℃, extreme high-temperature 38 ℃ region.

适宜平均气温13～15℃，绝对最低-10℃，极端高温38℃地区。

The experiment results prove that the boiler coking is largely reduced and the temperature difference of two sides of horizontal gas-pass is very small, when the 330MW boiler operate, the pressure of primary hot air parison is controlled beyond 12.0～12.5KPa, the O2 content of air pheheater is controlled about 3.0%, the door of OFA is opened to 30%, the buffle of the inner secondary air sleeve is adjusted to the minimum, the outer secondary air swirling strength and the baffle of the outer secondary air sleeve is regulated to the maximum and the outlet temperature of pulvervised mill is kept in 70℃.

试验结果表明，330MW运行时，一次热风母管压力控制在12.0～12.5kPa以上、空气预热器实际氧量控制在3.0％左右、燃尽风门开至30％、内二次风量套筒挡板调整在最小、外二次旋流强度和外二次风套筒挡板调整到最大、磨煤机出口温度维持在70℃，此时锅炉结焦大幅度减轻，水平烟道两侧烟温差非常小。优化试验完成后，进行了单烧灵武烟煤对比，结果是：掺烧高灰熔点的银北煤后，炉膛结焦大幅度减轻，锅炉过热器减温水量较小，主蒸汽压力易提高，带负荷能力正常；再热器烟气挡板开度较大、减温水量较小；风机电耗较小。

So the first method is the best one, which makes use of the temperature discrepancy between brick and flue gas during initial stage of combustion to intensify burning by excess coefficient of maximum coal gas against minimum air, so that the temperature at top of arch can reach the highest specified value 1350℃ in 15-30mins.

因此较优的燃烧制度是固定煤气量调节空气的快速烧炉法，即燃烧初期利用砖温与烟气温度相差较大的时机，以最大煤气量和最小空气过剩系数来强化燃烧，尽快在15～30min内将拱顶温度烧到规定的最高值1350℃。

The analytic results obtained from the PCT evaluations revealed that the most limiting accident was the case with a break at the Main Steamline Outside Containment. Its PCT was 1289.15 ℉, which is much below the upper temperature limit of 2200℉ set by the nuclear regulatory authority. The most limiting accident for the minimum water level measured outside the core shroud is the case with a break at the High Pressure Core Flooder Line, the minimum water level drops to 18.4 ft. For this case, even though the water level has dropped to 11.6 ft below the top of the active fuel, the reactor core was still completely covered by the two-phase water.

分析结果显示，对燃料护套最高温度而言，最严重之事故为围阻体外主蒸汽管路破口，其燃料护套最高温度为1289.15 ℉，此温度远在法规10CFR50.46所定之限值 2200 ℉以下；对反应炉最低水位而言，则最严重之事故为高压注水系统管路破口，反应炉降水区最低水位降至18.4 ft，约在有效燃料顶部以下11.6 ft，然而炉心内部仍为双相饱和流体所完全覆盖。

Main features:- Hole spacing 2.25mm-operating voltage: 4.5 V to 24 V-switching offset compensation at 62Hz under - over-voltage Protection - VDD-pin Reverse voltage protection - Short circuit protection open-drain output is hot off - working magnetic field range: DC to 10kHz-output goes low with magnetic south pole contacts marked on the package side, while the higher magnetic flux density and area of S1, As S2-all temperature and supply voltage range magnetic parameters on-chip temperature compensation circuitry of the minimum drift - EMC meet DIN40839.

主要特点：–霍尔片间距2.25mm–工作电压： 4.5 V 至 24 V–开关偏移补偿在62Hz下–过电压保护– VDD-pin反向电压保护–短路保护漏极开路输出被热关断–工作磁场范围：直流到10kHz–输出变低用磁场南极接触封装上有标记边，而更高磁通量密度面积S1，如同S2–全温度和供电电压范围下磁参数的片上温度补偿电路的最小漂移– EMC适应DIN40839。

With increasing of heat treatment temperature,the fraction of ω phase decreases and a phase precipitates,which cause the hardness and elastic modulus decrease.When annealing temperature is close to β transition point,the hardness and elastic modulus presents minimum values.

结果表明，当合金中存在ω相时，合金的的硬度和弹性模量最高，随着热处理温度的提高，合金中的ω相消失，代之而来的是a相，而且越接近β转变温度，a相含量越少，对应的弹性模量和硬度越来越低。

Lever Ball Float Steam Traps biggest advantage is not subject to pressure,temperature,cooling water flow fluctuations,continuous drainage,a water that row,the minimum cooling degree 0℃,能使best efficiency heating equipment;lever float steam trap valve seat total in the following level,forming awater seal,no steam leakage;itsPlug Valves minimum working pressure 0.01Mpa,the maximum back pressure rate of≤85%;interior with exhaust,lever float steam traps use the most advanced components as the automatic emptying of diaphragm valves,can automatically exclude non-condensing gas,very sensitive,high quality work and long service life.

杠杆浮球式蒸汽疏水阀的最大优点是不受压力、温度、冷凝水流量波动的影响，连续排水，有水即排，最小过冷度为0℃，能使加热设备达到最佳工作效率；杠杆浮球式蒸汽疏水阀的阀座总处于液位以下，形成水封，无蒸汽泄漏；它的最低工作压力0.01Mpa，最大背压率≤85%；内部带有排气装置，杠杆浮球式蒸汽疏水阀采用最先进的膜盒元件做为自动排空气阀，能自动排除不凝结气体，非常灵敏，工作质量高，使用寿命长。

Lever Ball Float Steam Traps are not subject to the greatest advantage of pressure, temperature, condensate water flow fluctuations, continuous drainage, water that is exclusive, the Butterfly Valves minimum undercooling of 0 ℃, heating equipment can achieve the best efficiency; Lever Ball Float Steam Traps seat total in the level below, the formation of water seal, no steam leakage; its minimum working pressure 0.01Mpa, the biggest back-pressure rate of ≤ 85%; house with an exhaust device, lever float steam trap uses the most advanced components as the automatic emptying of diaphragm valves, can automatically rule out non-condensing gas, very sensitive, high-quality work and long service life.

杠杆浮球式蒸汽疏水阀的最大优点是不受压力、温度、冷凝水流量波动的影响，连续排水，有水即排，最小过冷度为0℃，能使加热设备达到最佳工作效率；杠杆浮球式蒸汽疏水阀的阀座总处于液位以下，形成水封，无蒸汽泄漏；它的最低工作压力0.01Mpa，最大背压率≤85%；内部带有排气装置，杠杆浮球式蒸汽疏水阀采用最先进的膜盒元件做为自动排空气阀，能自动排除不凝结气体，非常灵敏，工作质量高，使用寿命长。

Proposes a method for selecting optimal chiller unit configuration in design phase, in which the energy consumption of chillers is simplified to the function of actual cooling capacity and entering water temperature of the condenser, then the all-year building load frequency distribution under different outdoor wet-bulb temperature that determines the minimum entering cooling water temperature is obtained by dynamic load calculation, and finally, calculates the all-year energy consumption and energy consump...

提出一种在设计阶段对冷水机组方案进行优化配置的方法。首先，冷水机组的能耗计算简化为制冷机的实际制冷量和冷却水进口温度两个独立变量的函数。进一步，通过建筑动态负荷计算获得全年冷负荷频率特性以及相应的室外湿球温度分布，其中湿球温度决定了冷却水最低进口温度。最终，计算出各种冷水机组配置方案的全年以及不同冷负荷需求工况下的运行电耗，并得出最优化的节能方案。

The experiment shows that:(1) In certain light intensity and electric field ranges (145～305V/cm) the material Si∶ with a resistivity of 1E4Ω·cm exhibits a current oscillation phenomenon at liquid nitrogen temperature;(2) At a certain electric field,the waveform of the current oscillation is stable and does not change with time;(3) The dependence relation between the oscillation frequency and light-intensity can be expressed by f=f0(L/L0)α where L0 is the minimum light-intensity needed to stimulate oscillation,f0 is the frequency under L0,L is the intensity of the light,and α is a coefficient that increase with electric field;(4) The modulating coefficient K K=(Imax-Imin/Imax decreases as the light increases;(5) The maximum value of the oscillation Imax decreases with the increase of the light-intensity while the minimum value of oscillation Imin increases slowly.

结果表明：在一定光照和电场范围内（276～305V/cm ，电阻率为10.4Ω·cm的材料在液氮温度下显示出电流振荡特性；在一定的电场下，电流振荡波形是固定的，不随时间变化；振荡频率随光照强度的增大而线性增大；调制系数随着光强的增强而减弱；振荡的最大值随着光照强度增大而减小，最小值随着光强增大而缓慢增大。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐