查询词典 mini-cycle

During this period, variance contribution rate of quasi 100 ka cycle is up to 37.44%, and quasi 100 ka cycle has a leading role.

P。也发现地球轨道三要素中的偏心率准100 ka周期2、1 ka岁差周期及55 ka、8.3 ka、3.5 ka非轨道准周期，偏心率准100 ka周期具有主导地位（方差贡献率达37.44%）；3尽管黄土记录的东亚夏季风100 ka周期的产生机制已有多种假说，古气候学界还是普遍认为它产生于某些尚不清楚的过程，有待进一步研究。

A three-dimensional world ocean carbon cycle model with ocean biota pump is developed. In the model, the atmosphere is represented by a well-mixed box of CO 2 , where CO 2 is exchanged with CO 2 from the surface water. The carbon cycle model has been numerically integrated for 1 200 years to a quasi-equilibruium state.

建立了一个带生物泵的三维全球海洋碳循环模式，该模式在海气界面上与一个CO2 充分混合的大气箱进行CO2 交换，模式积分 1 2 0 0年达到准稳定态的海水总CO2 、碱度及溶解氧的浓度、表层新生产力、海气分压差等的分布与实测相接近。

One cycle of operation to take Silo body construction, the construction procedure as follows: steel banding to Silo body gantry beams assembled below -→ one-time pouring concrete 700mm high -→ early slide three trips (that is 75mm high)-→ check off the concrete slipform system appropriate degree and working conditions -→ continue pouring concrete 500mm high -→ then slip trip or three -→ pouring concrete to template missing -→ normal sliding each slide or 500mm high -→ stratified cross - lap steel banding -→ pouring concrete 500mm high -→ Waterloo or 500mm high -→ 4 in accordance with the procedure after Silo body pouring until the completion of cycle.

其中筒身施工采取循环作业，其施工程序为：绑扎筒身钢筋至组装好的门架横梁下面—→一次性浇筑混凝土700mm 高—→初滑三个行程（即75mm 高度）—→检查滑出混凝土合适度及滑模系统工作状况—→继续浇筑混凝土500mm 高—→再滑升三个行程—→浇筑混凝土至模板上口—→转入正常滑升，每次滑升500mm 高—→分层交圈绑扎钢筋—→浇筑混凝土500mm 高—→滑升500mm 高—→按后四道程序循环往复直至筒身浇筑完成。

One cycle of operation to take construction, the construction procedure as follows: steel banding to gantry beams assembled below -→ one-time pouring concrete 700mm high -→ early slide three trips (that is 75mm high)-→ check off the concrete slipform system appropriate degree and working conditions -→ continue pouring concrete 500mm high -→ then slip trip or three -→ pouring concrete to template missing -→ normal sliding each slide or 500mm high -→ stratified cross - lap steel banding -→ pouring concrete 500mm high -→ Waterloo or 500mm high -→ 4 in accordance with the procedure after pouring until the completion of cycle.

其中筒身施工采取循环作业，其施工程序为：绑扎筒身钢筋至组装好的门架横梁下面—→一次性浇筑混凝土700mm 高—→初滑三个行程（即75mm 高度）—→检查滑出混凝土合适度及滑模系统工作状况—→继续浇筑混凝土500mm 高—→再滑升三个行程—→浇筑混凝土至模板上口—→转入正常滑升，每次滑升500mm 高—→分层交圈绑扎钢筋—→浇筑混凝土500mm 高—→滑升500mm 高—→按后四道程序循环往复直至筒身浇筑完成。

It focused on the cycle of blast furnace production of two town gas from coal gasification process and the basic requirements for the production cycle time of their choice and some indicators of a comparative analysis of gasification.

文中着重介绍了循环鼓风两段炉生产城市煤气的工艺流程和对气化用煤的基本要求，对其生产循环时间的选择和部分气化指标作了比较分析。

The results indicate that weight factor had significantly effect on gait speed, steps per minute, gait cycle time, the ratio of stance time and swing time, maximal flexion angle of knee joint and the range of motion of elbow joint. Shelf height had significantly effects on hip flexion and elbow ROM. Box size factor had significantly effect on stride length, gait cycle time, the ratio of stance time and swing time, knee joint elbow ROM. For the muscle activity levels with EMG, load weight and shelf height both affected the %MVC significantly. When the subjects carrying a load of 14kg, the muscle activity and the subjective body part discomfort rating are both higher than that of 7kg. The box size had effect on the body part discomfort rating of upper extremity and back. For the kinetic and kinematics analysis, the shelf height around elbow height was better than the other two height levels.

研究结果显示，对步态时间与空间参数而言，重量因子显著影响步速、步频、步态周期时间与站立期摆荡期比值，箱型因子显著影响步长、步态周期时间与站立期摆荡期比值；关节活动度而言，重量显著影响膝关节最大弯曲角度、肘关节屈伸角度范围，高度因子显著影响髋关节前后倾角度、肘关节活动各变项，箱型因子影响膝关节弯曲最大最小值以及肘关节活动各变项，对肌肉活动度而言，重量与高度因子皆显著影响MVC%值，14公斤重者肌肉活动度与主观不舒适程度皆较7公斤者高，箱型因子虽无明显影响肌肉活动度，但是在主观不舒适程度上却明显影响上肢与背部，终点放置高度应设在肘高附近为佳。

Through distancing to the tunneling working surface auxiliary fan switch and the wind electricity closed-cycle control switch too far,the wind electricity closed-cycle control does not play the role question to carry on the analysis.

主要通过对掘进工作面局扇开关与风电闭锁开关相距太远，风电闭锁不起作用的问题进行分析，巧用猴车电控箱实现远距离风电闭锁，从而保证远距离风电闭锁能可靠工作，实现安全生产。

The results show that the life of low cycle large strain fatigue N of nitinol is between 102 -104 cycles; The less the cycle strain, sheet thickness, wire diameter and range of strain angle are, the more the life of fatigue is. Heat treatment of nitinol pl...

结果表明：TiNi合金低周大变形疲劳寿命在102-104之间；板厚、丝径、形变角幅度愈小，寿命愈长；热处理制度对疲劳寿命有重大影响，采用热拉伸工艺和400-500℃回火，合金有较好综合性能；合金中杂质含量和成分组织均匀性对合金性能有着重要作用。

Comparison results show that heat pipe work is not continuous but fluctuant in one work cycle about five months,its actual working time is two-thirds of one work cycle,the cooling effect of heat pipe subgrade in winter is obvious,which is good for the contained cool increase of soil body and improves subgrade heat stabilization,there is a decrease for its cooling strength with the increase of horizontal distance,its effective operating radius is 2.25 m,its maximum cooling strength is in evaporation segment in depth direction,which low the thaw sensitivity of permafrost in the seasonal thaw layer about permafrost table.

研究发现，热棒在约为5个月的工作周期内并非连续工作而呈波动式，实际工作时间为工作周期的2/3；热棒路基冬季降温效果明显，有利于路基土体冷储量增加，提高路基热稳定性；热棒在路基中的降温强度，水平方向随距离增大而衰减，有效作用半径为2.25 m，深度方向在热棒蒸发段最大，降低上限附近季节融化层冻土热融敏感性。

This paper shows the method of short-cycle reverse , and putsforward the main points in developing short-cycle software .

阐述了短循环换向方法和实现短循环换向的系统软件设计要点。

As of Tuesday, Google's results were still censored in China.

截至周二，谷歌的搜索结果仍受中国审查。

In order to make the positive action increase and negative one decrease, the sub-forces of the social factors must be adjusted to form a centripetal force.

在这一过程中，人的主体性发挥是社会有机体健康发展的灵魂。