查询词典 micro-minicomputer

Oral micro- ecological niche is composed of many kinds of microorganism, which inhabit ,grow and multiply,compote and inhibit with each other by the Quorum Sensing in the oral cavity.

口腔微生态环境是由许多微生物组成，这些细菌长期在口腔内定居、生长繁殖、不断地进行竞争和拮抗，其间竞争主要是靠密度感应系统。

The compound of active substance after micro encapsulation treatment can be dissolved in organic solvent and its pH value is near to 6. The jointing properties of the flux made by it are perfect and the IMC is thin and transparent.

微胶囊化后的复配活性物质易溶于有机溶剂，pH值接近6以其制备的助焊剂的助焊效果良好，IMC层薄而明晰。

The polymer blends were melt-spun on micro compounder microinjector instruments. Through testing PHBV/TiO2 fibers, it was found that TiO2 could overcome the filament sticking phenomenon and brittleness, improve the tenacity of PHBV fiber, and the draw ability could he kept in several days also.

通过测试PHBV/TiO2共混纤维的强度、脆性等基本性能，表明添加TiO2不仅能克服纺程中PH-BV单丝间的粘连，而且有效地提高了纤维的强度，降低了纤维的脆性。

The results of micro-indentation and fracture show that the influence of compressibility can not be ignored.

结果显示在微压痕和断裂问题中可压缩性的影响不可忽略。

The results of micro-indentation andfracture show that the influence of compressibility can not be ignored.

结果显示在微压痕和断裂问题中可压缩性的影响不可忽略。

Research on correlation between compressibility and micro-structural form of cohesive soil ［J］.

某黏性土压缩性与微细结构形态之间关系的研究［J］。

The dispersion caused by the division of grid and the computational error becomes weak after using micro-damp in computation.

文中还通过在计算中加入微量阻尼的方法，大大减弱了由网格剖分、计算误差造成的频散现象。

It utilized a concave lens to reflect the incident light in lithography process and controls the exposure dosage in photoresist. Micro-pyramid array in photoresist is then developed onto the substrate.

利用凹透镜改变曝光机入射光的角度，控制曝光剂量於光阻中，以成型出四角锥柱微结构，并将其应用在导光板制造技术上。

By analyzing experimental data, it was found that wear patterns of nano-TiAIN coated cemented carbide tools in high speed milling AerMet100 steel included rake face wear, flank wear, breakage of coating, micro-chipping of cutting edge, boundary groove wear, conchoidal avalanche. Wear mechanisms included abrasion, adhesion, diffusion and chemical wear.

研究表明纳米TiAIN结构涂层硬质合金刀具在高速面铣削AerMet100钢时磨损破损形式主要为前刀面磨损、后刀面磨损、涂层材料的破损、微崩刃、边界沟槽磨损，贝壳状崩落；磨损机理主要是磨粒磨损、粘结磨损、氧化磨损和扩散磨损。

The space configuration of micro-facies and flow units determines the diversity of remaining oil distribution.

其与流动单元的空间配置关系决定了剩余油分布的差异性。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。