查询词典 micro-form

In this paper, the system construction of a micromanipulation robot based on hybrid control of micro-vision and micro-force was introduced, and the micro-vision system and micro-force system and their principle were described.

简单介绍了一种基于显微视觉和微力觉柔顺混合控制的微操作机器人的系统构成，并重点介绍了显微视觉系统和微力控制系统的组成及工作原理。

The micro mechanism considers that the inclusion in material, called micro defect crack, is the nucleus of internal crack initiation, interaction, between the stress field of the micro defect crack tip as loading and strain field of crystal lattice caused by crystal point passim (as vacancies or interstitial atom, H, O, N et al), will trap the point passim, and cause the enrichment of point passim around the micro defect crack.

其中疲劳裂纹内部萌生的核心是材料中的第二相粒子、夹杂物或微空洞，称为微裂纹；而微裂纹的长大是材料中间歇原子或空位等点缺陷在微裂纹尖端富集沉淀的过程，微裂纹的长大速率受到点缺陷富集扩散速率和疲劳载荷的双重影响。

This system included s light micro-scope to magnify the image of the micro-structure and project the image of the CCD camera; froze the high speed motion station of micro-structure based on stroboscopic principle to get a serial of dynamic images; and used the optical algorithm based on label field and neighborhood optimization method to motion estimation for sequential images of micro-structures to obtain dynamic characteristics parameters.

系统包括：利用光学显微镜来实现微结构的放大，并将图像投影到CCD摄像机上；基于频闪成像原理来冻结微结构的高速运动状态，获取一系列动态图像序列；基于提出的标号场和邻域优化法相结合的光流算法对微结构的运动序列图像做运动估计，获取其重要动态特性参数。

Computer micro-vision, Mirau microscopic interferometry, stroboscopic photography and laser Doppler vibrator are integrated into this platform. In-plane and out-of-plane periodic motion characteristics of micro-resonator are measured, and out-of-plane transient motion of micro-mirror is analyzed. In-plane displacement, motion phase and resonance frequency can be measured by integrating computer micro-vision with stroboscopic photography, and the repeatable accuracy of in-plane displacement is 30 nm.

实验结果表明，利用计算机微视觉和频闪成像技术能够实现微结构的平面位移、运动相位及谐振频率等周期运动参量的测试，位移的重复精度为30 nm；利用显微干涉和频闪成像技术可实现微结构的离面位移及表面扭曲等周期运动参量的测试，位移的重复精度为3 nm；激光多普勒测振技术具有在频域上对微结构瞬态运动进行分析的优点，是时域上周期运动测试的重要补充。

In order to analyze experimentally the back-scattering micro-spectrum difference between human normal stomach epithetic cell and the cancerous cell to provide optical technique for clinical checking,a micro-spectral measurement setup for checking cell was established based on fiber confocal microscopically imaging technique combined with cell light scattering theory. It could provide micro-imaging and micro-medical spectral information simultaneously.

为了在实验上分析人正常胃上皮细胞与癌变细胞的显微后向散射光谱的区别，为临床医学检测提供实验依据，在光纤共聚焦显微成像技术基础上，结合细胞散射理论，建立了一套基于光纤共聚焦的细胞检测显微光谱分析装置，能够同时获取细胞显微图像和显微光谱医学信息。

We led the density function into the data structure as the weight, and use dense micro-cluster to describe the arbitrary-shaped clusters in data streams. In addition, we propose candidate core-micro-cluster and isolated micro-cluster synopses to maintain and distinguish the potential micro clusters and isolation point in data streams.

我们把密度函数以权值的形式引入数据结构中，并利用核心微簇描述数据流中任意形状的簇，并提出候选核心微簇和孤立微簇结构分别用于维护并区分数据流中潜在的核心簇和孤立点。

Since the force change during operation must be sensed more sensitively, stiffness of micro manipulator and force sensors must be repartitioned properly. The micromanipulation system developed is introduced in detail, including the working principle of micro gripper, micro vision system and micro force system.

基于上述原则，研制出具有宏微运动能力的双手结构微操作机器人系统，包括六自由度步进电机驱动宏动机器人、三自由度智能微操作手、微夹持器、显微视觉监视系统和微力觉系统。

Kempers' study , the more layers the mesh screen type had, its resistance against gravity was higher, but its heat resistance and flow resistance were comparatively augmented. As mentioned in the preceding paragraph, it is extremely difficult for a single micro structure based on any of the three types to possess both low flow resistance and strong capillary force. Faced with this fact, the researchers have tried to mix the three micro structures in Table 2 into as many combinations as possible so that a composite micro structure with low flow resistance and great capillary force may be fabricated. After a thorough analysis, the groove combined with sintered metal or mesh screen has been found to be a better alternative. However, the groove combined with sintered metal will raise the flow resistance of the channel, and the aluminum substrate employed in this research cannot be sintered into a micro structure. As a result, the groove combined with mesh screen is finally chosen as the composite structure to enhance its capillary force and at the same time maintain its high permeability. In this way, the heat pipe will not fail due to the working angles.

Kempers 的研究当中提到，当网格结构越多层时，其对抗重力的能力也越强，但相对的其热阻以及流阻也越高，就如同前段所述，我们很难在单一结构当中找出一流阻低且毛细力之微结构；因此本研究便以表2中之三种微结构进行组合，找出一低流阻且毛细力强之复合式结构，经分析发现，沟槽搭配烧结以及沟槽搭配网格为较佳之组合方式，但由于烧结搭沟槽构造将会提高流道之流阻，且本研究使用铝做为基材，并无法使用烧结最为其微结构，故将采用网格搭配沟槽之复合式结构提高结构的毛细力，并维持沟槽结构的高渗透性，解决因角度造成热管失效的问题。

The research results are highly reproducible owing to the repeatable micro-model technique.(2) Quantifying the Kr-S-P curves in two-phase flow. The validity and adaptability of multi-phase curves are verified using micro-model testing bed tailored to adequate scale of pores. Results obtained from the P-S micro-model tests generally agree with the threshold values of displacement mechanism offered by researchers using geometric shapes. The hysteresis of .experimental Kr-S curves of numerous two-phase flows are depicted in terms of connectivity and humidification. The P-S and Kr-S curves of two-phase flow are well-derived in conjunction with micro-model test results and empirical van Genuchten model. For the curve expressing the relation between saturation and capillary pressure, experimental results of water-air flow system corresponds to the theoretical data.

2二相流体对微模型实验之Kr-S-P关系：包括以孔颈尺寸比例组成微模型板实验平台去证实多相流流动主要特性曲线正确性与适用性；验证水和空气二相流之P-S微模型实验，与前人以几何形状所推估出来的置换机制门槛值大致吻合；以连通性及润湿性等解释多组二相流体对Kr-S曲线实验之迟滞现象；以微模型实验结果配合van Genuchten特性曲线经验式互推估二相流体对之P-S与Kr-S 曲线，推估结果良好；以比例原则推估多组二相流体於毛细压力-饱和度曲线的结果，显示在水和空气二相流体对为参考流体对时，推估其他组流体对吻合度最佳。

As a special micro-power source, thermoelectric micro-generator is of interest for its applications in Micro-Electro-Mechanical Systems. Electrochemical deposition method took the advantage at the fabrication of thermoelectric material in micrometer scale. In this paper, the detailed reduction processes of Bi~(3+) and HTeO~(2+) were studied for the first time. And thermoelectric nanowires were also prepared by electrochemical deposition. On the basic study of thermoelectric material, detailed exploration was made to the design and fabrication process of thermoelectric micro-generator.

作为一种特殊的微动力能源，微型温差发电器在微机电系统中的应用前景引起了人们极大的兴趣，电化学沉积方法在制备微米级尺寸的温差电材料方面具有显著的优势，本文对Bi~(3+)和HTeO~(2+)离子的电化学还原过程展开了详细的研究，并尝试了利用电化学沉积方法制备Bi_2Te_3纳米线材料，在温差电材料研究的基础上，对微型温差发电器的结构设计和制造过程进行了详细的探讨。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。