查询词典 micro-

Results indicate that radial distance of the bushing from the rotor center and the radius of the hemispherical bushing significantly affect wear rate,and minimzing both two values will result in lowest wear for micro-rotor systems in MEMS.However,it is noted that the bearing radius sets a lower limit on the hemispherical bushing radius since the bushings are located beyond the rotor inner radius.It is desirable to reduce their effects on friction and wear on micro-rotors by regulating the radius of the bushing and the radial distance of the bushing from the rotor center within permissive range of micro-fabrication.Severe wear exists with increasing applied load and rotating speed of the rotor.Stress distributions in the contact region are different from Hertz solutions due to the convergence stresses apearing on the uncontinuous curvature line and the contact pressures display symmetrical parabola in the contact region.

结果表明：在MEMS微转子系统中，微转子轴衬偏心距离和转子轴衬半径影响线磨损率，以两者减至最小为较理想，但须注意设计中轴承半径的限制，并使轴衬偏心距离大于轴承内半径；在转子加工制造许可的范围内，可以通过调整转子轴衬的半径和偏心距离来减少摩擦磨损对微电机的影响，随着转子所承受载荷和转子旋转速度的增加，其磨损严重；接触区的应力分布不同于经典Hertz解，这是由于应力集中出现在不连续的曲率线上，且接触区的接触压力呈现轴对称抛物线状分布。

Many swarm parameters have been obtained such as the electron density distribution, the energy and spatial distribution of the emitted electrons from the MHCD at various voltage and different dimension of micro-hollow cathode. Micro-hollow cathode discharges with slot and cylindrical cathode have been done, results show that pressure, cathode structure and the gas mixture will affect the stability of glow discharge. Micro-hollow cathode discharge array was obtained by individual ballasted discharge unit.

进行了槽型和孔型微空心阴极放电的实验，不同的气压、电极结构以及气体配比对放电稳定性有着明显的影响；采用分段镇流的方法，进行了微空心阴极阵列放电的实验研究，得到了均匀放电；做了大气压下MHCD自持的辉光放电研究。

Inertial force still plays leading role under micro-metre scale, it could move the particles in micro-fluid so as to eliminate the chocking phenomenon of micro-nozzle.

惯性力在微米尺度下仍然起主导作用，可以驱动微流体中微粒的移动，消除微喷嘴堵塞现象。

Under the optimum conditions, the lactobacillus bulgaricus microcapsule was madeby single agglomerate, and precipitated the wall with located in rapeseed oil with 50%ammonium sulfate solution; The preliminary micro-emulsion filtrated, then drawsome microcapsule from the micro-emulsion and progressing the second emul-sification, injecting a mixture with 3% CAP and 1.5% gelatin into the micro-emulsion,and keep the stirring speed 200r/min for 5 minutes, adjusting pH as 3.0 with aceticacid, then desiccating with the spray drier after 30 minutes. At last, got the prodtictof microcapsule powder.

通过最佳乳化条件制备的乳液，采用单凝聚法制备保加利亚乳酸杆菌微胶囊，用50％硫酸铵溶液，使菜籽油中的壁材CAP析出，形成初步的微胶囊，过滤，取上层微胶囊油液，缓慢注入3％CAP和1.5％明胶混合液中，进行第二次乳化，在200r／min的搅拌速度下乳化5min，用冰醋酸调节乳液的pH值至3.0，固化30min，取乳液置于喷雾干燥机中进行喷雾干燥。

Institute of Petroleum Exploration and Development,PetroChina,Lanzhou 730020,ChinaEarthquakes occured overmuch and seismites developed in southwestern Qaidam basin. The seismites made serious seismic-related soft-sediment deformation structures,including pillow structure,ball structure,pillow bed,liquefied sand-stone vein,liquefied mudstone vein,micro-fault,micro-fracture,micro corrugated lamination and sandstone fungus.

研究表明，柴达木盆地西南地区地震活动强烈，深、浅层均发现一系列与古地震有关的震积岩，形成一系列软沉积物变形构造，主要包括震积砂枕、砂球构造、枕状层、液化砂泥岩脉、层内错断、地裂缝、微褶皱纹理、沙侵蘑菇等。

It is specialized in manufacturing micro electret condenser microphone, micro silicon microphone, micro speaker, receiver and electroacoustic array module, which are widely used in mobile phone, digital device, computer, music player, earphone as well as car communications.

主要产品为微型驻极体传声器，硅微传声器，微型扬声器，受话器及微型电声阵列模组。产品广泛应用于手机，数码产品，电脑，音乐播放器，耳唛及汽车通讯领域。

Is the production of variety of specifications,"Ke-wei" brand micro-computer Induction Cooker, micro-computer digital infrared heaters gagaku, baked Pa (multifunctional infrared electric oven), home appliance products such as micro-computer rice cooker.

现生产多款规格的&科卫&牌微电脑电磁炉，微电脑数码红外雅乐炉，烤霸、微电脑电饭锅等家用电器产品。

Application Flexibility- Low-flow requirements can be satisfied with standard restricted-capacity trim or with Micro-Form, Micro-Flute, or Micro-Flow valve plugs.

应用灵活性，低流量的要求与标准，可以限制容量的装饰或微表，微笛，或微流量阀插头满意。

This research applies the micro forming process with other mass production techniques to construct the key components of the micro/meso gear transmission. The final prototype is the planetary gear transmission with outer diameter 6mm and gear module less than 0.15mm developing in 3 years. The purposes and developing technologies of this project are as follows: 1. setting up the design and analysis of parts and system; 2. the mold design of gear and planet plate; 3. assembly modules of planetary gear train; 4. inspection of gear profile and gear train; and 5. heat treatment of micro parts.

本研究将以精微成形技术搭配其他量产制程，逐步开发微型减速机内的所有关键零件，预计在3年内最终完成外径≦ψ6mm、齿轮模数m≦0.12mm之的行星式齿轮减速机的开发，研发目标包含有微型传动系统结构/机构与零组件设计分析技术，试量产型精微行星/太阳齿轮、传动盘、环齿轮等原型件模具设计与开发，行星臂、太阳齿轮、行星齿轮与环齿轮等组装模组技术，微型齿轮齿形及相关微型齿轮箱检测技术，以及精微元件热处理技术等关键技术。

Micro-engine is composed of premixing- chamber and combustion-chamber. Flow and diffusion in micro-chamber are important influence factors of premixed catalytic combustion in the micro-engine.

微型发动机由预混腔和燃烧腔组成，而微型预混腔内流体的流动和传质是影响微型发动机预混催化重整燃烧的重要因素。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。