查询词典 metric coefficient

In addition, skewness coefficient and flatness coefficient were also measured.

为了探讨射流的统计特性，对偏态系数和平坦系数也进行了测量。

In this paper, a traditional boundary following is improved by using a new algorithm with a criterion to control search. A describes symbols method is proposed by use Fourier coefficient. The way how to calculate these coefficients from chain code is given. Then the calculation formula is further ameliorated. And how to extract shape feature invariant from Fourier coefficient is introduced also.

为此，本文利用带搜索控制准则的新边界跟踪算法改进了传统的边界跟踪算法，提出了用傅立叶系数描述符号，给出了如何由链码计算傅立叶系数，并对计算公式作了进一步改进，以及由傅立叶系数提取形状特征不变量。

At last, the envelop of geometry coefficient is drawn, and the Fourier formula coefficient is given.5. Study of wind-induced interference effects on three adjacent cooling-towers.

绘制了不同风向角下体型系数沿环向分布的包络线，并给出了包络线的傅立叶展开式系数。5、冷却塔三塔干扰的研究。

The wedge feature maximum of Fourier coefficient gives the direction of every texture layer of X-ray tyre image; the algorithm will map the ring feature maximum of Fourier coefficient to the scale parameter of gabor filter, and then automatically search the refined scale and accurately direction parameters in the guide line of energy convergence.

根据这些特点，提出了一种方向Gabor滤波器参数的自动选取方法。根据楔特征人工指定纹理的大致方向，算法将环特征映射到Gabor滤波器的尺度参数，并按能量收敛原则搜索最好的尺度和纹理的准确方向。

According to actual condition, a model of wall thickness of rotary kiln is established. The constant coefficients in the model, including thermal conductivity, heat transfer coefficient, Fourier coefficient and contact resistance, are closely calculated. A formula of contact resistance is draw from a great deal of data of surface and inner temperature of rotary kiln. The wall thickness of rotary kiln is simulated by MATLAB. The simulation result is transmitted from MATLAB to DELPHI through a group of interface functions compiled by VC++. The basic graphs-circle and line are analyzed by the means of the technique of Visualization in Scientific Computing and the Bresenham arithmetic, and are realized the visualization of the wall thickness. The contents of communication between master computer and slaver computer are designed and the error control technique, the idea of multi-thread and the embedded assembly language are applied to realize the temperature data transmission and graph transmission, which largely improved the speed of transmission and the reliability and stability of system.

建立了符合现场实际的回转窑壁厚数学模型；结合现场采用红外测温仪测量所得的温度数据和回转窑的实际结构数据，确定出适合该模型的定常系数(包括导热系数、换热系数、傅立叶系数、接触热阻等)，并得出与回转窑工况的相近的接触热阻公式ln=T~(0.5154)-36.7868；利用MATLAB软件仿真出回转窑壁厚，并将运算结果通过在VC++的编译环境下编译出MATLAB和DELPHI的接口函数传输到该监测系统中，实现了温度数据的转换和交换；运用科学计算可视化技术和Bresenham扫描转换算法对基本图形——圆和直线进行分析，从而实现了仿真后的壁厚数据可视化；在研究异步串行通信方式的基础上，设计了该系统上下位机功能和通信内容，并运用差错控制技术、多线程思想以及嵌入式汇编语言实现了温度数据和图形数据在上下位机之间的远程传输，提高了数据传输的速率和系统的可靠性、稳定性。

The correlation test on pressure, speed and temperature of brake friction coefficient are performed, the results indicate that the stability of friction coefficient is enough.

按照制动标准VW TL 110规定的试验程序，进行了制动衬片摩擦系数的压力、速度、温度相关性试验，试验结果表明，制动摩擦系数随压力、速度、温度的变化范围在规定的离散带范围内，摩擦系数的稳定性是符合要求的。

Indicated according to the near two year gauge block anti-curved experiment, when the design intensity takes 435 N/mm2, under the normal running condition the reinforcement stress probably is 343 N/mm2, the corresponding average crack opening approximately in the 0.14~0.15mm scope, if takes 1.66 to multiply the big coefficient, the short-term maximum crack opening reaches 0.24mm, considered the long-term function rides 1.5 to multiply the big coefficient again, final crack opening approximately in 0.36mm.

根据近两年对板的抗弯试验表明，当设计强度取 435 N / mm2，正常使用状态下钢筋应力大约为 343 N / mm2，对应的平均裂缝宽度大约在0.14～0.15mm 范围，如取1.66倍增大系数，短期最大裂缝宽度达 0.24mm ，考虑长期作用再乘1.5倍增大系数，最终裂缝宽度大约在0.36mm 。

The Genii coefficient is established to evaluate the allocation scheme. The results show that the Genii coefficient of all indices are below 0, 2 and the allocation is equitable for every district.

应用经济学中衡量收入公平的基尼系数概念，对分配结果的公平性进行评估，给出综合体现社会性、经济性和历史性的水环境容量分配方案。

If average values before or after catastrophe point when the pressure at both ends reduces exceed the threshold value, judging that there is leak and positioning: calculating approximate wavelet transformation coefficient of pressure data at both ends, initializing searching interval, calculating a signal time delay value corresponding to approximate wavelet transformation coefficient in the searching interval from maximal scale N; converting the time delay value under scale N to that under N-1 by geometric proportion relation; updating the searching interval, repeating above processes until the scale is 0 and positioning based on the time delay value.

若两端压力下降突变点前后的均值变化均超过阈值，判定有泄漏并进行定位：计算两端压力数据的近似小波变换系数，初始化搜索区间，从最大尺度N开始在搜索区间内计算对应近似小波变换系数的信号时延值，利用等比关系将尺度N下的时延估计值转换为N-1下时延估计值，以该值更新搜索区间，重复以上过程至尺度为0，以此时延估计值进行定位。

Then the ductility demand spectrum, which comprises a group of ductility coefficients or yield strength coefficient versus natural period curves for different yield strength coefficient or ductility coefficients are obtained.

在分析总结几种常见的非线性静力分析侧向力分布形式的基础上，提出两个基于多自由度体系振型的侧向力分布计算方法：30％方法和部分SRSS方法。

You can snipe the second and third union leaders from this position.

您可以鹬第二和第三工会领袖从这一立场出发。

Aiming at the currently shortage of XML streams quality detecting, this paper proposes a new forecasting method of XML streams quality by least squares support vector machines, which is used the method of XML keys' vector matrix as windows, and vector product wavelet transform to multilevel decompose and refactor the XML streams series, that can fulfill real-time checking demand of XML quality, and ensure constraint, consist- ency and integrality. For even more adapting net load, it proposes a control strategy by weight and adaptive adjustment to ensure XML streams quality.

针对当前XML数据流质量检测存在的不足，提出构建XML键的矢量矩阵作为窗口，利用矢量积小波变换多级分解与重构XML数据流，再结合最小二乘支持向量机对XML数据流质量进行预测的一种方法，满足XML数据流质量重构时实时检测的要求，保证XML数据的约束性、一致性与完整性；为了更好的适应网络负载，采取加权与自适应窗口调整等调度策略充分保证XML数据流的质量检测。