查询词典 methacrylate

Results The mixing, loading and storing processes of the construction, might generate lots of occupational hazards, including toluene, dimethylbenzene, trimethylbenzene, isopropanol, butyl alcohol, propanol, methyl methacrylate, butyl acetate, methyl isobutyl ketone, methyl ethyl ketone, acetic ether, nitro-cotton, n-hexane, n-heptane, carbinol, ethanol, ethyl propionate, diisobutyl ketone, glycol ether, isoamyl acetate, 2,4-toluene diisocyanate, isophorone, noise, power frequency electric fields.

结果 该项目在混兑生产和装卸、仓储过程中，可能产生的职业病危害因素主要有甲苯、二甲苯、三甲苯、异丙醇、丁醇、丙醇、甲基丙烯酸甲酯、乙酸丁酯、甲基异丁基甲酮、丁酮、乙酸乙酯、硝化棉、正己烷、正庚烷、甲醇、乙醇、乙酸丙酯、二异丁基甲酮、乙二醇乙醚、乙酸异戊酯、2，4甲苯二异氰酸酯、异佛尔酮、噪声、工频电场。

In the terpolymerization of polyoxyethylene macromer , methyl methacrylate and butyl acrylate the polymerization rate and the effects of various factors on grafting efficiency and molecular weight of the terpolymers were studied.

研究了聚氧乙烯大单体与甲基丙烯酸甲酯及丙烯酸丁酯的三元共聚中大小单体的聚合速率和引发剂用量、大单体分子量及投料比对接枝效率及共聚物分子量的影响。

Methyl methacrylate - butyl acrylate graft copolymer with uniform branched chain was synthesized using a macromer technique.

采用大单体技术合成了以聚甲基丙烯酸甲酯为主链，聚丙烯酸丁酯为支链的规整接枝共聚物。

Amphiphilic graft copolymers were synthesized by the copolymerization of polyoxyethylene macromer with butyl acrylate and methyl methacrylate in benzene using azobisisobutyronitrile as initiator.

以偶氮二异丁腈为引发剂，将大单体聚环氧乙烷与小单体丙烯酸丁酯、甲基丙烯酸甲酯在苯溶液中进行共聚，合成了两亲性接枝共聚物。

The macromer, methoxy polyethylene glycol methacrylate, used for polycarboxylate based superplasticizer was prepared by esterification of methacrylic acid and methoxy polyethylene glycol.

以聚乙二醇单甲醚和甲基丙烯酸为主要原料，通过酯化反应制备聚羧酸系减水剂大单体聚乙二醇单甲醚甲基丙烯酸酯。

New type ZPW21A ZPW21B is desinged to meet GMP standard .An inproved type of ZPW21.Its pressing area is sealed with four polymethyl methacrylate doors to be isolated with outside environment.The parts contact the material are made of stainless steel or their surface is specially antisepticized to avoide pollution.

ZPW21A、ZPW21B是按药品GMP要求设计的新机型，压制室采用四开门有机玻璃封闭结构，与外界环境隔离，室内与物料接触的各构件均采用不锈钢制成或者表面经过特殊防腐处理，避免物料受污染提高片剂质量和方便清洁。

Its drug release rate is rather slow for its higher glass transition temperature. In Chapter Four, a series of polymers with various Tg were prepared by copolymerizing butyl methacrylate with MMA.

本论文第四章中通过共聚将甲基丙烯酸丁酯引入到PMMA中，制备得到不同Tg的聚合物，同时制备得到不同载药量的以PBMA为载体的基质。

Then we studied the double phase transition behavior of three-layer nanostructures with double thermoresponsive shells. Successive RAFT polymerization of NIPAM and 2-ethyl methacrylate or DMA and NIPAM were conducted using PS macroRAFT agent. The PS-b-PNIPAM-b-PDMA and PS-b-PDMA-b- PNIPAM triblock copolymers can self-assemble into PS-core micelles, which possess a three layer \'onion-like\' structure, with PDMA and PNIPAM blocks forming the inner layers or outer coronas.

另外我们还合成了含有PS、PNIPAM、PDMA三嵌段聚合物，也利用芘标记的方法可以得出：对于PS-b-PNIPAM-(来源：A29BC论文网www.abclunwen.com)b-PDMA胶束存在两个明显的相转变过程，第一个是内层的PNIPAM这一个很宽的温度(20-32℃)的塌缩过程，接着是32-50℃下的PNIPAM和PDMA的混合塌缩或聚集过程。

Methyl methacrylate were passed through an alumina column, dried over molecular sieves, deaerated by bubbling argon and stored under argon.

这个氧化铝柱为我没用过，是什么样的呢？在一个玻璃柱里填充氧化铝可以吗？

Two series of polyurethane acrylate grafted acrylic resins (Acr-g-TPU-PETA and Acr-gPPU-PETA) self-emulsifying systems are obtained by grafting -NCO group modified polyurethane acrylates with acrylic copolymer prepared from n-butyl acrylate, styrene,βhydroxyethyl methacrylate and acrylic acid The self-emulsifying systems showed Newtonian fluidity with viscosity closed to that of water, the solid contents were around 30% The T〓 of 15～4℃ for dried film before photocuring favored film formation at room temperature DSC and DMA results showed that PU-PETA is compatible with acrylic resin in the grafted resin The TG and dTG curves for Acr-g-PU-PETA samples were substantially different from the corresponding blends, and the brodened dTG peaks for photocured grafted resin suggest that there might be multiple interactions among chain segments The photocued film of the grafted resins self-emulsifying system exhibited good overall properties with polyurethane acrylate grafts ranging from 30% to 50%, and Acr-g-TPU-PETA series showed better properties than Acr-gPPU-PETA series The adhesion of the photocured film was 1～2 grade, impact strength was 50kg-cm and flexibility was 1mm The Shore hardness and the adhesion of the film decreased markedly if PETA was replaced by HEMA as photoactive group due to the lower C=C double bond content in the grafted resin The polyhydroxy amine-linked thioxanthones photoinitiators can be evenly dispersed in self-emulsifying system without color spot appearing in the dried film The films photocured with IV〓～IV〓 generally exhibited higher Shore hardness, gloss and solventresistance than that cured with Irgacure 2959 and did not induce the rusting of the iron substrate Pigmenting with titanium oxide had no effect on the photocuring The polyhydroxy amine-linked thioxanthone IV〓 and IV〓 can be new candidates for the formulation of titanium oxide pigmented photocurable water-borne coatings for their pale-yellow appearance and slight interference with the color of the coatings WB 4759 with high water-solubility coalesced and separated from the dried resin film, and even induced the rusting of iron substrate.

以丙烯酸丁酯，甲基丙烯酸-β-羟乙酯，丙烯酸及苯乙烯合成厂丙烯酸共聚树脂，并与含-NCO端基的聚氨酯丙烯酸酯接枝反应，经水性化后，得到两个系列（Acr-g-TPU-PETA和Acr-g-PPU-PETA）各5个不同配比的丙烯酸树脂接枝聚氨酯丙烯酸酯自乳化体系，粘度与水相近，为牛顿流体，固含量30％左右。光固化前干燥涂膜的玻璃化转变温度在-15℃～4℃之间，有利于室温下成膜。DSC及DMA谱表明两种树脂基本相容。Acr-g-PU-PETA的热失重行为明显不同于共混材料，接枝样dTG峰明显宽化，表明接枝样中链段之间的相互作刚有多重性，丙烯酸树脂与聚氨酯之间有一定的相容性。接枝树脂自乳化体系光固化涂层的综合性能以聚氨酯丙烯酸酯成分为50％～30％者相对较好，且以Acr-g-TPU-PETA系列更理想。光固化膜的附着力为1～2级，冲击强度为50kg·cm，柔软性多为1mm。以HEMA代替PETA作为接枝树脂的活性基团，碳—碳双键密度太低，光固化膜交联点太少，硬度和附着力均较差。多羟基胺连硫杂蒽酮光引发剂能均匀分散于树脂自乳化体系和接枝树脂干膜中，不出现色斑，光固化膜肖氏硬度一般高于以Irgacure 2959为光引发剂的光固化膜，光泽度及耐丁酮溶剂性能均有所提高，不会诱导铁基生锈，钛白着色对光固化结果几乎没有影响。本论文所合成的多羟基胺连硫杂蒽酮光引发剂IV〓与IV〓为浅黄色，对光固化涂层的颜色干扰较小，为配制钛白着色光固化水性涂料提供了新的光引发剂。水溶性太强的WB 4759在干膜中易聚结析出，且对所附着的铁基有诱导锈蚀作用。

By the time of its fall, most of the prisoners were writers who had written against the corruptions of the government.

到它被攻陷的时候，里面多数的犯人是写了反对政府贪污文章的作家。

The most obvious variation to ovum morphological character was that the color was changed from light green to sepiaceous in embryonic development, and all the ovums were almost hatched after 96h.

在胚胎发育过程中卵的形态特征最明显的变化是颜色从淡绿到深褐色，卵在发育96h后卵基本全部孵化。