查询词典 methacrylate resin

The main contribution of this paper is summarized as follow:1 Copolymer acrylate resin including hydroxyl, carboxylic and amina(-NH_2) is a new type of antifogging system and ahydrophi- lic antifogging constituents which is not found before.2 Water-soluble acrylate resin hydrophilic antifogging coating material is a new-type environmental protection material which takes ethanol as solvent and whose pastiness is adjusted by deionized water.3 The quality rate of accessory soft monomer ethyl acrylate and accessory hard monomer butyl methacrylate is 6 to 4, the quality rate of functional monomers in all monomers is 20 percent, the quality rate of MAA in the functional monomers is 22 percent, the quality rate of β-hydroxyl ethyl acrylate in the functional monomers is 8 to 10 percent and the remainder of functional monomer is acrylic acid.4 Cross-linking agent methylol acrylamide belongs to self-cross-linking system.

本文的主要贡献概述如下： 1 含有亲水羧基、羟基和氨基(-NH_2)丙烯酸共聚树脂是一种新型高效的防雾体系，用的亲水防雾组分是前所未有的。 2 以乙醇为溶剂制得水溶性丙烯酸树脂具有很好的水溶性能和防雾性能，只需加入去离子水就可以调节它的粘度，是一种新型的环保型防雾材料。 3 辅助软单体丙烯酸乙酯和辅助硬单体甲基丙烯酸甲酯最佳配比为质量比6∶4；官能单体占单体总量的20%，甲基丙烯酸占官能单体总量10～15%，甲基丙烯酸β-羟乙酯占官能单体总量的8～10%，剩下的为丙烯酸。

The effects of MMA and alumina trihydrate on properties of oligourethane methacrylate resins were investigated. And the curing reactivities of unsaturated polyester resin, vinyl ester and UM resin were compared by various methods.

研究了甲基丙烯酸甲酯和三水合氧化铝含量对聚氨酯甲基丙烯酸酯树脂性能的影响，比较了不饱和聚酯树脂、乙烯基树脂和UM树脂的固化反应活性。

Two series of polyurethane acrylate grafted acrylic resins (Acr-g-TPU-PETA and Acr-gPPU-PETA) self-emulsifying systems are obtained by grafting -NCO group modified polyurethane acrylates with acrylic copolymer prepared from n-butyl acrylate, styrene,βhydroxyethyl methacrylate and acrylic acid The self-emulsifying systems showed Newtonian fluidity with viscosity closed to that of water, the solid contents were around 30% The T〓 of 15～4℃ for dried film before photocuring favored film formation at room temperature DSC and DMA results showed that PU-PETA is compatible with acrylic resin in the grafted resin The TG and dTG curves for Acr-g-PU-PETA samples were substantially different from the corresponding blends, and the brodened dTG peaks for photocured grafted resin suggest that there might be multiple interactions among chain segments The photocued film of the grafted resins self-emulsifying system exhibited good overall properties with polyurethane acrylate grafts ranging from 30% to 50%, and Acr-g-TPU-PETA series showed better properties than Acr-gPPU-PETA series The adhesion of the photocured film was 1～2 grade, impact strength was 50kg-cm and flexibility was 1mm The Shore hardness and the adhesion of the film decreased markedly if PETA was replaced by HEMA as photoactive group due to the lower C=C double bond content in the grafted resin The polyhydroxy amine-linked thioxanthones photoinitiators can be evenly dispersed in self-emulsifying system without color spot appearing in the dried film The films photocured with IV〓～IV〓 generally exhibited higher Shore hardness, gloss and solventresistance than that cured with Irgacure 2959 and did not induce the rusting of the iron substrate Pigmenting with titanium oxide had no effect on the photocuring The polyhydroxy amine-linked thioxanthone IV〓 and IV〓 can be new candidates for the formulation of titanium oxide pigmented photocurable water-borne coatings for their pale-yellow appearance and slight interference with the color of the coatings WB 4759 with high water-solubility coalesced and separated from the dried resin film, and even induced the rusting of iron substrate.

以丙烯酸丁酯，甲基丙烯酸-β-羟乙酯，丙烯酸及苯乙烯合成厂丙烯酸共聚树脂，并与含-NCO端基的聚氨酯丙烯酸酯接枝反应，经水性化后，得到两个系列（Acr-g-TPU-PETA和Acr-g-PPU-PETA）各5个不同配比的丙烯酸树脂接枝聚氨酯丙烯酸酯自乳化体系，粘度与水相近，为牛顿流体，固含量30％左右。光固化前干燥涂膜的玻璃化转变温度在-15℃～4℃之间，有利于室温下成膜。DSC及DMA谱表明两种树脂基本相容。Acr-g-PU-PETA的热失重行为明显不同于共混材料，接枝样dTG峰明显宽化，表明接枝样中链段之间的相互作刚有多重性，丙烯酸树脂与聚氨酯之间有一定的相容性。接枝树脂自乳化体系光固化涂层的综合性能以聚氨酯丙烯酸酯成分为50％～30％者相对较好，且以Acr-g-TPU-PETA系列更理想。光固化膜的附着力为1～2级，冲击强度为50kg·cm，柔软性多为1mm。以HEMA代替PETA作为接枝树脂的活性基团，碳—碳双键密度太低，光固化膜交联点太少，硬度和附着力均较差。多羟基胺连硫杂蒽酮光引发剂能均匀分散于树脂自乳化体系和接枝树脂干膜中，不出现色斑，光固化膜肖氏硬度一般高于以Irgacure 2959为光引发剂的光固化膜，光泽度及耐丁酮溶剂性能均有所提高，不会诱导铁基生锈，钛白着色对光固化结果几乎没有影响。本论文所合成的多羟基胺连硫杂蒽酮光引发剂IV〓与IV〓为浅黄色，对光固化涂层的颜色干扰较小，为配制钛白着色光固化水性涂料提供了新的光引发剂。水溶性太强的WB 4759在干膜中易聚结析出，且对所附着的铁基有诱导锈蚀作用。

The authors' laboratory once compared the effects of embeddings with the homemade paraffin and epon resin on the morphometric study of testicular structures, and, recently, also compared effects of embeddings with the internationally commonly-used Leica paraffin and methacrylate resin and magnifications on the morphometric study of renal structures.

笔者实验室以前对比过国产石蜡与环氧树脂包埋对睾丸组织形态定量研究的影响，最近又对比了国际上常用的Leica石蜡和甲基丙烯酸树脂包埋以及放大倍数对肾脏组织形态定量研究的影响。

Methods: Paraffin (7 μm in thickness) and methacrylate resin (25 μm) embedded renal sections were observed using 40× objective lens and 100× oil lens, respectively, and the volume fractions and diameters of the renal tubules and the tubule nuclei were estimated with stereological methods.

分别用高倍镜(40×物镜)和油镜(10 0×)观察石蜡(7μm厚)和甲基丙烯酸树脂(2 5 μm厚)包埋的肾脏切片，利用体视学方法测量肾小管的体积分数和直径以及肾小管细胞核的体积分数和直径。

In this work, methyl methacrylate, epoxy resin and unsaturated polyester resin were modified by industrial bismaleimides and liquid crystalline bismaleimides to increase the thermal stability and mechanical property of the three materials. So the ranges of the three materials useness will be enlarged.

本文采用双马来酰亚胺改性甲基丙烯酸甲酯、环氧树脂和不饱和聚酯树脂，以期提高这三种材料的耐热性能和机械性能，从而拓宽聚甲基丙烯酸甲酯、环氧树脂和不饱和聚酯树脂的应用范围，所以这一课题的研究具有重要的理论和实际意义。

Methyl methacrylate dental base resin was the most frequently used clinical dental base resin because of its good physical, chemical, mechanical and biological properties. Heat treatment was an indispensable step in the manufacturing of dentures with MMA base.

甲基丙烯酸甲酯义齿基托材料因其具有良好的理化、机械和生物性能及稳定的色泽、易于加工成型等诸多优越性一直被广泛应用，目前仍是临床上最常用的义齿基托材料，而加热聚合则是该材料固化不可缺少的步骤。

UV curing powder coatings ; acrylic resin ; methacrylic acid ; glycidyl methacrylate ; photosensitive resin

UV固化粉末涂料；丙烯酸树脂；甲基丙烯酸；甲基丙烯酸缩水甘油酯；感光树脂

The experimental results show that the composite emulsion of nitrocellulose -alkyd resin acrylate, which is prepared by modifying the nitrocellulose with non -drying or alkyd resin, methyl methacrylate and butyl acrylate monomer under the optimized experimental conditions have good stability and excellent performance.

实验结果表明，以不干性油醇酸树脂、甲基丙烯酸甲酯和丙烯酸丁酯单体为主要原料，在优化的实验条件下对硝基纤维素进行改性，可制得稳定性好的硝化纤维素-醇酸树脂-丙烯酸酯复合乳液。

Using N,N′-dimethy-p-toluidineas the catalyst,bisphenol A-glycidyl methacrylate,the resin matrix in most dental composite restorative materials,was synthesized by the reaction of bisphenol A and glycidyl methacrylate,and characterized by FTIR,~1HNMR and M S.

以N，N-二甲基对甲苯胺为催化剂，双酚A和甲基丙烯酸缩水甘油酯为原料合成了一种常用的口腔修复材料树脂基质———双酚A双甲基丙烯酸缩水甘油酯，并用FTIR1、HNMR和质谱对其结构进行表征。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新