查询词典 measured

The system parameters of the compound pendulum are calibrated in slow loading condition; and the maximal angle is measured in impact loading condition.

本文分析了编码器的基本特征，建立了一套以编码器为核心的复摆冲量测量系统，给出了编码器在冲量缓慢加载阶段复摆系统参数标定及冲击加载阶段最大摆角测量的应用结果。

Recovery factor is defined to reflect the recovery effect of air compressure and is measured along the heat transfer surface with different nozzle-to-plate spacing and jet velocity at nozzle exit.

以恢复系数来表示因气体压缩性而引起的恢复效应影响，测量其在传热表面的分布规律以及射流喷射间距和射流出口速度等对恢复系数的综合影响。

The method has clearer physics meaning,and practice results show that this method is much more convenient,economic and precise than Xu-White methods,and the error between computational value and measured value is less than 5 percent

计算结果与实测结果对比表明，平均相对误差限在5%左右，与Xu-White模型相比，该方法物理意义更为明确，使用更简便计算精度提高一倍左右。

With the corresponding flow parameters measured through the experiments and the criterion equation mentioned above,the correlation formula of degassing efficiency of flow of gas/liquid two-phase flow through corrugated multicup isoflux gas anchor is obtained through the regression analysis using the least square method and the Gaussian elimination.The influences of the number of arris and concave depth and angle on degassing efficiency are analyzed.

利用量纲分析方法建立了气液两相流体在瓦棱状多杯等流型气锚中流动的准则方程；根据室内实验测得相应参数和准则方程，利用最小二乘法及高斯消去法进行回归分析，得到气液两相流体在瓦棱状多杯等流型气锚中流动时脱气效率的关联公式，并分析了棱数、凹入深度、角度对脱气效率的影响。

"F" is the distance between point P' and the tangent to the concave area in the maximum point of concavity measured in projection view on the plane of symmetry Y.

"f"为在对称面Y上的投影视图上测量的点P'和最大凹状点上的对凹入区域的切线之间的距离。

Must ensure that the car has concentric outer circle with the machine tool spindle (Micrometer can be measured on the surface of the workpiece has been processed on the side of the bus and bus).

必须保证已车外圆与机床主轴同心（可用千分表测工件已加工表面的侧母线和上母线）。

Such as measurement of refractive index distribution is one of the most important test, and thus can be measured optical fiber preform of a series of geometric parameters such as core / package ratio, concentricity, roundness and so on.

比如折射率分布测量就是其中一项最重要的测试，并由此可测得光纤预制棒的一系列几何参数，如芯/包比、同心度、不圆度等。

The original design of coaxial maximum deviation of 0.1mm, measured concentricity deviation after removal of about 0.4mm.

原设计中同轴度最大偏差为0.1mm，拆除后实测同轴度偏差约为0.4mm。

So-called "the objective time" means time is a kind of existences, such as we can not see the Earth's magnetic field which it can be measured by instruments; time, also, we can capture by the chronometers, i.e. time is not conceptive or imaginary "thing."

所说的客观时间就是一种客观存在，正如我们看不到电磁场，但我们可以通过仪器测量到它；时间，同样，我们也可以通过仪器测量到它的变更，所以，时间并不是概念上或想象的'东西'。

This can also be measured by the concordance index.

这也可以通过一致性的指标被测量。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了