查询词典 maximum term
- 与 maximum term 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
When the underlying error term for tobit model is known to be normally distributed and homoskedasticity, maximum likelihood estimation is consistent and asymptotically normally distributed.
半参数估计是一种参数和非参数估计的混合,比相应的参数模型更能一致的估计参数,而且比非参数模型估计更精确,其优点是无需假定误差项分布,所以它对非正态和异方差是稳健的。
-
In the insurance trade, the term "average" simply ways "loss" in maximum cases.
在保险业中"average"一词一般是"海损"的意义。
-
In the insurance business, the term "average" simply ways "loss" in maximum cases.
在保险业中"average"一词一般是"海损"的意思。
-
Taking the overall crop yields or overall net profits on the whole planned area to be maximum as the targets respectively, the paper gives calculating formulae of rational irrigation quota in accordance with that the constant term of Y=f is smaller or greater than zero and the water use coefficient of irriga...
分别以整个灌区上的总净收益和总产量最大为目标,在假定仅种植单一作物,且地力及其它因素一致的条件下,给出了与Y=Y中的常数项a大于或小于零以及灌溉水利用系数随灌溉面积变化与否相对应的作物合理灌溉定额的计算式。
-
Indicated according to the near two year gauge block anti-curved experiment, when the design intensity takes 435 N/mm2, under the normal running condition the reinforcement stress probably is 343 N/mm2, the corresponding average crack opening approximately in the 0.14~0.15mm scope, if takes 1.66 to multiply the big coefficient, the short-term maximum crack opening reaches 0.24mm, considered the long-term function rides 1.5 to multiply the big coefficient again, final crack opening approximately in 0.36mm.
根据近两年对板的抗弯试验表明,当设计强度取 435 N / mm2,正常使用状态下钢筋应力大约为 343 N / mm2,对应的平均裂缝宽度大约在0.14~0.15mm 范围,如取1.66倍增大系数,短期最大裂缝宽度达 0.24mm ,考虑长期作用再乘1.5倍增大系数,最终裂缝宽度大约在0.36mm 。
-
Judged from the studies of other omnivorous fish species (Cui et al., unpublished), the total metabolism at the maximum feeding level (R〓+R〓, KJ/d) determined in the short term respiration trials for gibel carp was equal to half of the total metabolism calculated by the difference through long term growth trial.
由其它杂食性鱼类的研究结果推测,通过短期呼吸实验测定的最大摄食率条件下异育银鲫总代谢仅相当于生长实验中通过差减法计算的总代谢的1/2。
-
The relationship between standard metabolism (R〓, mgO〓/h/fish), wet weight and temperature was: lnRs=0.830+0.021T+0.670lnW in short term respiration trials. The relationship between feeding metabolism rate (R〓, mgO〓/g/d) and feeding rate was R〓=0.264C+36. 740 determined in short term respiration trials. The relationship between feeding metabolism , body weight and temperature for gibel carp at maximum feeding rate was R〓=-6. 237+0.697lnW+1. 940lnT.
异育银鲫标准代谢(R〓,mgO〓/h·fish)与水温及体重的关系可表述为:lnR〓=-0.830+0.021T+0.670lnW;异育银鲫摄食代谢率(R〓,mgO〓/g/d)与摄食率的关系可表述为:R〓=0.264C+36.740;结合以上两个模型进行推测,最大摄食率条件下异育银鲫摄食代谢与水温及体重的关系可表述为:R〓=-6.237+0.697lnW+1.940T
-
In the model, the characteristics of fast attenuates and update and being sensitive to outside information of instantaneous memory were used to detect abnormal data promptly and prevent intrusion at an early time. The short-term and long-term memory can adjust memory intensity with anomalous accesses, and interconvert with each other that attempts to achieve maximum effect.
在本模型中,利用瞬时记忆衰减更新速度快且对外界信息反应敏感的特点,对异常数据进行及时检测,尽可能较早地阻止入侵的发生;短时记忆和长时记忆可以随着异常访问频度调整记忆强度并进行相互转化,以达到最佳的记忆效果。
-
A constitutive model was developed on the base of Ohno–Wang kinematic hardening model Int. J. Plast. 9 (1993 375, 391. In the developed model, the rate dependence of the material was reflected by a viscous term; the steady cyclic flow was reflected by the evolution of kinematic hardening rules with critical state of dynamic recovery developed by Ohno and Wang Int. J. Plast. 9 (1993 375, 391; the cyclic hardening was only characterized by the evolution of isotropic hardening and an evolution rule of isotropic hardening with a term of dynamic recovery was used; the effect of loading history on the ratcheting was also considered by introducing a fading memorization function for maximum plastic strain amplitude into the model.
基于Ohno-Wang模型建立了一个新的、考虑材料的率相关特性的本构模型,模型中通过具有临界面的随动硬化律来反映稳态的循环流动,并通过带动态恢复项的各向同性硬化演化率来反映循环硬化的影响以及采用最大塑性应变幅值的衰减记忆函数来反映棘轮行为的加载历史记忆效应。
-
AThe term "butter" means natural butter, whey butter or recombined butter (fresh, salted or rancid, including canned butter)derived exclusively from milk, with a milkfat content of 80% or more but not more than 95% by weight, a maximum milk solids-not-fat content of 2% by weight and a maximum water content of 16% by weight.
一&黄油&,仅指从乳中提取的天然黄油、乳清黄油及调制黄油(新鲜、加盐或酸败的,包括罐装黄油),按重量计乳脂含量在80%及以上,但不超过95%,乳的无脂固形物最大含量不超过2%,以及水的最大含量不超过 16%。
- 推荐网络例句
-
It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.
从鲍尔点的形成原理出发,分析对称连杆曲线上鲍尔点的产生条件,提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。
-
The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.
集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品,年生产总值3000万美元,产品价廉物美、选料上乘、质量保证,深受国内外客户的青睐
-
The eˉtiology of hemospermia is complicate,but almost of hemospermia are benign.
血精的原因很,以良性病变为主。