查询词典 maximum error

Simulation results show that the model has higher precision and faster convergence speed and the maximum absolute value of the relative error for the model is

仿真结果表明，该模型相对误差的最大绝对值仅为0.06812%，收敛速度快。

Maximum allowable overprinter error detection range is 18 mm.

最大不准的套印不差错检测边界是18毫米。

This thesis proposes to use optimal method to search for the interpolation that matches with the allowable maximum range of chord error to build a curve of near field photolithographic fabrication.

同时本文提出最佳化搜寻合乎允许最大弦误差范围内之插值点方法，以建立近场光学微影加工之曲线。

We employ maximum principle argument to get an error of size O.

3.3中考虑一类非线性对流扩散方程的特征差分格式。

In view of methods for calculating asphericity of optical aspheric surface are nonuniform, a least maximum residual error method for calculating asphericity of high-order optical aspheric surface is proposed on the basis of analyzing common calculating methods.

针对现有光学非球面度计算方法不统一的问题，在分析常用方法特点的基础上，对於高次光学非球面度的计算提出最小最大残差法。

When the underlying error term for tobit model is known to be normally distributed and homoskedasticity, maximum likelihood estimation is consistent and asymptotically normally distributed.

半参数估计是一种参数和非参数估计的混合，比相应的参数模型更能一致的估计参数，而且比非参数模型估计更精确，其优点是无需假定误差项分布，所以它对非正态和异方差是稳健的。

This thesis proposes a novel method of retiming E1 signal of the SDH output and using it as a reference synchronization signal for Trunking Gateway. The proposed retiming method can generate the E1 signal of TG input in comply with the maximum relative time interval error requirement of 52.5ns specified in the PRC-Generation standard. The method successfully reduces the E1 signal error level to a smaller margin of 300ns than that of the PRC-output standard.

本论文提出将同步数位阶层输出E1信号做时序重整，做为中继闸道器的做参考同步信号；这样可使输入中继闸道器的E1信号在最大相对时间间隔误差达到主参考时钟产生的52.5奈秒标准；更能让中继闸道器输出的E1信号，由超出同步数位阶层自由振荡4.6微秒，改善到低於主参考时钟输出的300奈秒标准。

To guarantee tracking precision, the relation between the tracking control error and the output torque of the controller is analyzed from the point of engineering. Then an effective replanning scheme is presented, where fuzzy logic is used to weight the maximum joint torque according to the control error.

为保证跟踪精度，从工程的角度分析了跟踪控制误差与控制器输出力矩的关系，提出了根据控制误差对关节最大力矩进行模糊加权的二次规划方案，是一种便于实际工程应用的有效方法。

Theoretically, the error model of maximum direction is more rigorous for describing error of transition curve lines.

通过实例说明了εm模型是理论上更加严密的缓和曲线误差模型，而εσ模型是一种简化的描述模型。

For chirp radiator direction-finding using an ARM interferometer seeker, the cause of the direction-finding error using traditional direction angle estimation is studied, and the relationship between the direction-finding error and the integration time is analyzed, especially for the boundary condition that the integration time of phase discriminators gets the maximum value.

针对ARM干涉仪导引头对chirp信号辐射源的测角问题，从几何关系与信号分析两方面揭示了传统方向角估计方法产生测角误差的机理，分析了干涉仪测角误差随鉴相器积分时间变化的关系，重点对积分时间最长这一极端情况开展研究。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。