查询词典 maximum change
- 与 maximum change 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Previous research indicated a drastic ontogenetic change in behavior, habitat, body shape, and recombination of tissue during metamorphosing from leptocephalus to juvenile stages. A maximum otolith increment width and sharp decreasing in otolith Sr/Ca ratios resulting from glycosaminoglycan broken–down were observed during metamorphosis.
研究指出,柳叶鱼仔鱼转换到稚鱼的变态过程,须经历行为、栖地转换与身体组织重组等个体发生的剧烈变化;在此过程将观察到耳石日周轮明显变宽、耳石Sr/Ca比因GAGs降解而急速下降等现象。
-
Add the clauses of appearance, lixivium ion content and pipe shell eccentricity, improve the thermal conductivity and dimension allowable indexes, add the safe service aphorism, modifies the regulation of inspection and change the "the maximum service temperature" to "temperature for shrinkage under hot load".
增列了外观、浸出液离子含量及管壳偏心度条款,提高了部分板的导热系数及尺寸允差指标,增列安全使用警语,修改了验收规则,并将"最高使用温度"改为"热荷重收缩温度"。
-
Doctor-formulated RapidSlim SX is the world's fastest weight loss solution designed with maximum strength to deliver dramatic weight loss quickly without a drastic change in lifestyle.
医患制定RapidSlim取是世界上最快的体重减轻解决方案,以最大的力量来提供戏剧性的迅速减重没有急剧变化的生活方式。
-
Optical density d of the material or the density of photographic film itself d field part of density d the density of the deep and change some of the most high density (h-red, green, or blue channels in maximum density) L intermediate density density (red, green, or blue channels in minimum density) M minimum density (red, green, or blue channels in the middle of the density) T transmission 4.2Murray-Davies formula in the measurement of surface films, film dot business card printing and membership card making dot area usually is the most important parameters.
光学密度 D 材料或片基本身的密度 D 实地部分的密度 D 深浅变化部分的密度 H 最高密度(红,绿或蓝通道的最大密度) L 中间密度密度(红,绿或蓝通道的最小密度) M 最低密度(红,绿或蓝通道的中间密度) T 透射率 4.2Murray-Davies公式在测量胶片的表面网点面积时,胶片制卡和会员卡制作网点面积通常是最重要的参数。
-
The problem of multi-objective usually meet many conflict each other and can not use the objective of the same standard unit, then to employ membership function of fuzzy theory,at first each objective function to change fuzzy set and express with membership function, membership function include the maximum constraint, minimum constraint, the decrease function of monotonic property, to become optimal of the multi-objective function, but still to scanty of weighting value with regard to adjustment of objective function, thus this thesis proposes the method of combine orthogonal arrays and particle swarm optimization to solve the problem of multi-objective optimal power flow, each objective function separately add weighting value, to setting each weighting value of objective function in order to the result of anticipating.
多目标最佳化的问题通常会面临到许多互相冲突且不能用同ㄧ标准单位的目标,於是利用模糊理论中的归属函数,首先将各目标函数转换成模糊集合并以归属函数表示,归属函数包含了最大限制值、最小限制值、单调的递减函数所组成,将各目标函数利用归属函数表示,形成单一目标函数的最佳化,但是仍缺乏权重值对於目标函数的调整,於是本篇论文提出ㄧ种权重值设定与粒子群优演算法的方法去解决多目标最佳电力潮流的问题,将各目标函上分别加上权重值设定各目标函数的权重值,得到预期的效果。
-
Another change from Mines of Moria is that our Tactical Skills do not do fixed damage, but have a range between a minimum and maximum.
另外一个同莫里亚矿坑的改变是我们的法术技能不再伤害固定,而是有了一个范围,在最小值和最大值之间。
-
Axis of maximum moment of inertia = the axis of figure: because the Earth is not a perfect sphere, but is physically an oblate spheroid, the position of the axis of figure is not a precise constant, but is affected by the constant change in the earth's distribution of total mass:(ie, by ocean tides, atmospheric cond- itions, plate tectonic movements, etc.).
轴最大转动惯量=形状轴:因为地球不是完全的球形,而是一个扁球体,形状轴的位置不是精确的常量,而是受地球总质量的分配持续变化作用:(也就是,受海洋潮汐、大气环流、地质板快运动等等)。
-
Similarly, the AMR begin to increase and then decrease with increasing the thickness d of the seed layer, and has a maximum value at a critical thickness d of 5.32nm. Compared to the permalloy films deposited on Ta seed layer ,the AMR enhancement of 10%-46% is observed in the permallay films deposited on (Ni0.82Fe0.18)1-xNbx seed layer.(2) The coercivity Hc1 obtained for magnetic field H applied paralley to the easyaxis is large than Hc2 for H applied perpendicular to the in-plane easy axis, and both of coercivity are consistent with the change of x.
2沿样品易轴方向的矫顽力Hc_1比难轴方向的矫顽力Hc_2大,两者随Nb原子的百分含量x的变化是一致的,饱和磁化强度Ms随x的增大先增大后减小,在x=27.1%处,Hc_1和Hc_2都比较小,而Ms则达到最大;种子层厚度d不能明显改变坡莫合金薄膜的磁性能;与以传统材料Ta为种子层的坡莫合金薄膜相比,以Ni_(0.82Fe_(0.18)_(0.829)Nb_(0.271)为种子层的坡莫合金薄膜的矫顽力只有轻微减小,但是Msg 以w讪Fq.t)lkNk为种于层的坡莫合全薄膜的各向异性戳电阻及磁性能研究却要大,mk坡莫合金层厂度!
-
When treat-ing the spectra, transition, scattering problems, we must use the semi-microscopicapproach. The main new conclusions in this thesis are following:We found the different shrinking effect in ∧ hypernuclei and 〓 hypernuclei, the shrink-ing effect in ∧ hypernuclei are confirmed in a recent experiment;We also found a new approach to treat the configuration mixing of ∧∧ hypernuclei and〓 hypernuclei and that the conversion process may change the spectra and widths of〓 hypernuclei;For the first time, we investigate the neutron star matter without the ∑ hyperon butwith the new meson 〓(975) and φ(1020), we found the contribution of 〓 and φ canmake the equation of state of neutron star soften, and the maximum mass of neutronstar reduces;we extract a set of optimum parameters of the optical potential for the scattering of 〓with nucleus, we found that the 〓 nucleus optical potential need a bigger imaginarypart.
本论文所取得的主要新成果是:独立揭示∧超核和〓超核的不同的收缩效应,其中∧超核的收缩效应被最新实验证实;提出了处理∧∧超核与〓超核混合态的新方法,并发现conversion过程使〓超核能谱和宽度改变;首次在中子星研究中在不包含∑超子的同时考虑新介子〓(975)和φ(1020),并发现这可使中子星物质的状态方程变软、中子星半径变大、质量变小;独立提取了〓核光学势的一组最佳参数,并证明〓+核光学势要求一个较大的虚部。
-
The direction of the maximum principal stress is N 54.2°±3.3°E and does not change with depth.
最大主应力方向为N 54°±3.3°E,且方向不随深度变化。
- 推荐网络例句
-
I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""
客人们在卡罗利娜·埃凯家里,举止就文雅一些,因为卡罗利娜的母亲治家很严厉。
-
Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.
由著名品牌 Herm è s 设计,这件高贵的制服是香港本土制造,是我们第一套不配帽子的制服。
-
Do not 'inflate' your achievements and/or qualifications or skills .
不要 '夸大' 你的业绩或成果,条件或者技能。