查询词典 maxillary joint

The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.

在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。

The results are as follows:(1) With the imposing of orthopedic force of simulating maxillary protraction on maxilla, in the sagittal direction, the maxillary complex of the SD Rats in experimental group grows more quickly than that in two control groups, and the extent of the maxillary complex increases more evidently. The maxillary complex displays anti-clockwise forward and upward rotation.(2) With the imposing of orthopedic force on maxilla, upper incisors exhibit labial-inclined, labioclination of lower incisors changes insignificantly, and the shape and the dimension of skull are not affected significantly.(3) The expression of TGF-3 , in frontomaxillary sutures and palatomaxillary sutures shows different intensity in different extent of time. But The expression of TGF-{3, in experimental group is more intensive than that in two control groups, and that in operated control group and natural growth group has no significant difference.

结果如下：在模拟上颌前牵引矫形力作用下，(1)生长发育期大鼠上颌复合体在矢状方向生长加快，长度明显增加，并表现出向前向上的逆时针旋转；(2)上切牙唇倾，下切牙的唇倾度没有明显变化，颅脑的形态与大小不受影响；(3)额颌缝和腭颌缝中TGF-β_1的表达，同一时段实验加力组要强于手术对照组与自然生长组，而手术对照组与自然生长组之间无显著性差异。

Results The penumatization rate of total or inferior part of middle turbinate correlated positively to the inflammation of anterior ethmoid and maxillary sinuses. Compared with patients with normal frontal sinuses, the vertical diameters of agger nasi cells of patients with frontal sinusitis were larger(11.70±5.50 mm and 8.54±3.67 mm respectivevy, p＜0.01).Compared with patients with normal maxillary sinuses, the Haller's cells of patients with maxillary sinusitis were larger (77.8% and 33.3%,P＜0.05)and the amount of inflammatory Haller's cells of the latter was more abundant than that of the former(91.6±17.8 mm2 and 41.6±12.6 mm2, respectively, P＜0.05). The deviation of uncinate process was one of the factors of maxillary sinusitis .The sizes of ethmoid bullae increased with the soft tissue thickening in anterior ethmoid sinus, the large ethmoid bulla may cause anterior ehmoid sinusitis.

结果 全中甲或中甲下部气化的发生率随前筛、上颌窦内软组织影增厚而升高；有额窦炎组病人的鼻丘气房最大纵向垂径明显大于无额窦炎组(分别为11.7±5.5 mm和8.5±3.7 mm，P＜0.01)；Haller气房在上颌窦炎组和非上颌窦炎组的发生率无显著差异，但前组发生炎症的Haller气房明显多于后组(分别为77.8%和33.3%，P＜0.05)，且前组Haller气房的冠状位截面积明显大于后组(分别为91.6±17.8 mm2和41.6±12.6 mm2，P＜0.05)；钩突角度随上颌窦内软组织增厚而减小；筛泡冠状位截面积随前筛窦内软组织增厚而增大(P＜0.01)。

The heritability of maxillary arch length (71.26%) was higher than the mandibular one (31.33%). The intraclass correlation coefficients were similar in dental crowding between MZ and DZ, with the lower in DZ. Low heritability of dental crowding was found in both maxillary (4.73%) and mandibular (10.3%) teeth. Conclusion The maxillary teeth MD, the mandibular teeth MD and the length of maxillary dental arch are controlled under strong genetic factors.

上下颌牙量遗传度较高，上颌为69.97%，下颌为75.73%；上颌牙弓弧长的遗传度(71.26%)明显高于下颌(31.33%)；单卵双生子和二卵双生子上下颌牙齿的拥挤度的对内相关系数较为接近，二卵双生子略低，遗传度很低，上颌为4.73%，下颌为10.3%。

Like thread joint, wedge joint, pin coupling, key joint, spline joint, full coordinate joint, elastic link joint, riveted joint, welding and glued joint and so on.

如螺纹联接、楔联接、销联接、键联接、花键联接、过盈配合联接、弹性环联接、铆接、焊接和胶接等。

The first three largest number of missing teeth is as follows: maxillary first molar, maxillary second molar and mandibular first molar. The first three largest number of resident teeth is as follows: mandibular cuspid, mandibular bicuspid and maxillary cuspid. The cases without occusal relationship account for 19.51%; and the cases which need occlusal reconstruction or occlusal elevation account for 19.51% of all the cases, while food impaction exists in 21.84% cases.

结果：本组老年人平均缺失牙齿9.10颗，缺失最多的前3位牙齿是上颌第一磨牙、上颌第二磨牙和下颌第一磨牙；余留最多的前3位牙齿是下颌尖牙、下颌第一双尖牙和上颌尖牙。19.51%的病例颌骨间无咬合接触关系，19.51%的病例修复时需咬合重建或咬合抬高；21.84%的病例修复前存在食物嵌塞。

In maxilla, DO has been involved in maxillary advancement, maxillary expansion, maxillary alveolar reconstruction and midfacial and/or cranial distraction.

此外，还有上下颌骨的同时牵引延长、面中部和／或颅骨的牵引等。

In this research, the pubertal five-week-old SD rats were chose as experimental object to establish the animal model for simulating maxillary protraction, on which was imposed the orthopedic force of 85g with utilizing the self-devised maxillary protraction appliance. Located lateral X-ray cephalograms were taken to measure and analyze the changes of maxillary development after exerting the orthopedic force for 4 weeks. The technique of immunohistochemistry was used to investigate theexpression of TGF-, in frontomaxillary sutures and palatomaxillary sutures with identical force performing for different extent of time. The average hue was selected as indicator, which was measured by the means of the analysis system of pathological color images. The measuring data were analyzed by the one-way ANOVA in software SPSS 11.0 version.

本研究采用自行设计的上颌前牵引装置，以生长发育期5周龄SD大鼠为实验对象，施加85g的矫形力，建立了模拟上颌前牵引的动物模型，通过X线头影测量分析，观察施力4周后上颌骨的生长发育情况；应用免疫组织化学技术，检测同一力值作用不同时段下TGF-β_1在上颌骨的额颌缝、腭颌缝的表达，彩色病理图象分析系统测定每张切片中阳性染色细胞的平均灰度值，结果采用SPSS 11.0进行方差分析。

The proportion of maxillary center incisors, maxillary lateral incisors, maxillary canines curved in mesiodistal were 11.17%, 16.19% and 21.43%, in labio-lingual were 39.59%, 40.00% and 29.59%, both in labiolingual and mesiedistal directions were 4.60%, 35.24% and 24.49%.

大约50％左右的上颌前牙根管存在中度弯曲：与上颌切牙相比，上颌尖牙的弯曲度略大而弯曲半径略小。

Among the sampling methods used to investigate the pathogens responsible for rhinosinusitis, maxillary sinus puncture is considered to be the gold standard. Although endoscopic middle meatal culture seems to correlate well with the results obtained by maxillary sinus puncture, the reliability of documentation of bacteria by endoscopic culture in children with rhinosinusitis is still unknown. Finally, because studies on current bacterial resistance patterns in pediatric patients are limited, we employed maxillary sinus puncture to obtain sinus secretions for bacterial culture and analysis of antibiotic resistance in children with chronic rhinosinusitis.

关於鼻窦的培养方法，一般而言上颌窦穿刺为公认获得鼻窦细菌培养的准则，虽然证据显示在成人使用内视镜中鼻道培养的结果与上颌窦穿刺所获得的培养结果相关性很高，不过目前儿童使用内视镜中鼻道培养的可信度依然不明，因此我们的研究也比较鼻及鼻窦炎病童上颌窦穿刺与内视镜中鼻道培养的结果，以厘清在儿童使用内视镜中鼻道采样培养鼻窦致病菌的可信度。

A carrier gas such as nitrogen is directed through line 20 and valve 22 to connect with line 26 and mix with the gas sample.

如氮气之类的载体通过管线20和阀22引入，与管线26相通，与气体样品混合。

But for the most part, knaves and parasites had the command of his fortune

然而支配他的家产的大多是恶棍和寄生虫。