查询词典 manual input

The input bias currents CAN now flow freely to ground and do not build up a large input offset as before.

此时，输入偏置电流可以顺畅地流入地线而不象以前一样会产生大的输入失调电压。

In addition, the ratio of flow rate to input power has maximum value when input power is in the range of 1.2～1.8W.

功率小时，预应力使流量降低，功率大时，预应力使流量增加，泵的流量与输入功率的比值与输入功率的关系曲线有最大值，约在1.2～1.8W之间。

Original non-dominant multi-objective genetic algorithm applied to a number of objective function input, a number of input variables.

原始非支配多目标遗传算法，适用于多个目标函数的输入，多个变量的输入，非常经典的，基于非支配解排序。

Input offset current can be determined by capping the input connector and selecting the lowest current range.

输入偏置电流可以通过盖上输入连接器并选择最低的电流量程来决定。

With its extremely low input offset current and minimal input voltage burden, it can detect currents as low as 1fA (10-15A).

基于极低的输入偏置电流和输入端压降，静电计能够检测低至1fA（10-15A）的电流。

The readout system can efficiently reduce the influences from leakage current, input offset, process parameter instability, and other causes. The value of input weak current signal can be obtained simply through demarcation.

读出电路系统可以有效地减小漏电流、输入失调、外来干扰和工艺参数不稳定等带来的影响，通过简单的标定和换算即可得到微弱电流信号的大小。

Note that the input offset current can be partially nulled by enabling the INSTRUMENT current suppress with the input terminals disconnected and ZERO CHECK open.

要注意，在仪器电流抑制的条件下，即输入端不连接和"ZERO CHECK"开路时，输入失调电流可部分无效。

This system is designed based on SPCE 061A microcontroller to measure the close loop parameters of the amplifier. The system can measure the input offset voltage、the input offset current、the open loop AC differential mode voltage gain、the AC common mode rejection ratio and unit gain bandwidth,using the measure method of assistant amplifier. What is more, data printing is completed in this system.

摘要本系统是基于SPCE 061A 单片机的运算放大器闭环参数测试系统，该系统采用辅助运放测试方法，可对运放的输入失调电压、输入失调电流、交流差模开环电压增益和交流共模抑制比以及单位增益带宽进行测量，并具有将测试数据打印输出的功能。

At an input resistance of 1 M relative to the ground, the input signal is not grounded.

此输入端的输入阻抗为1M，而输入信号则为接地。

An electrometer preamplifier is used at the input to increase sensitivity and raise input resistance.

在其输入端采用一个静电计前置放大器以提高灵敏度并提高输入电阻。

The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.

论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。

I have not really liked him,I do not like his this kind of disposition.

我没有真的喜欢他，我不喜欢他的这种性格。