查询词典 major axis

Using the rotational coordinate axis, the complex multi-swing process can be studied on simple one-dimensional axis.

通过旋转一维坐标轴，复杂多机电力系统摇摆过程通过投影变换可以转化为一维坐标上简单运动来研究。

Postoperatively, the cornel astigmatism axis rotated over 45 degree in 7 eyes (54%) and the total astigmatism axis rotated over 45 degree in 6 eyes (46%).

手术后全眼散光轴改变45°以上6眼（46%），角膜散光轴变化45°以上7眼（54 %）。术后1，3，6 mo的角膜散光轴和全眼散光轴的差异均无显著。

In harsh environment, the precision measurement of the axis angle is critical for the development of space system. The factors such as temperature variations and platform vibration severely limit the accuracy and life time of axis angle measurement device in space.

在复杂恶劣的气候条件下进行高精度的轴角测量已经成为发展空间应用技术的主要瓶颈，其中空间温度交变和振动环境，严重制约着空间用轴角测量装置的精度和使用寿命。

However, the greater the displacement of the input shaft axis from the crown wheel axis, the lower the mechanical efficiency.

然而，更大的车轮从冠轴输入轴轴线位移，机械效率降低。

High density stacking faults are induced into Al-Co-Ni decagonal quasicrystal by using high temperature deformation. It is found that their fault planes are perpendicular to the ten-fold axis and their displacement vectors R are lying in the fault planes and parallel to a two-fold axis A2D.

通过高温形变的手段在Al-Co-Ni十次准晶中引入了高密度的层错，并发现这些层错的层错面与十次轴垂直，层错的滑移矢量R在层错面内并与二次轴A2D平行。

Experimental study of stress-strain relationship of normally consolidated intact soft clay in Hangzhou under undrained fixed shear of principal stress direction and monotonic rotation of principal stress axis had been done, which was used to reflect the soil properties response to the monotonic rotation of principal stress axis under real engineering conditions.

为反映真实工程条件下主应力轴旋转应力路径引起土体性状的变化，对杭州地区正常固结原状软黏土在固结不排水的主应力轴定向剪切和主应力轴单调旋转条件下的应力-应变关系进行试验研究。

The authors used gravity gradient anomalies to interpret the Southwest sea basin of the South China Sea and obtained the domal structure plane with the NE-trending spreading axis of the sea basin as the symmetric axis.

本文利用重力梯度异常对南海西南海盆进行了解释，得到大致以西南海盆北东向扩张轴为对称轴的穹隆状构造面。

The eyepiece has an optical axis , and this axisshouldbe aimed at the center of the main mirror for best performance - though in practice it is the center axis of the focuser drawtube that you aim at the primary mirror .

目镜和主镜一样也有光轴，光轴应该对准主镜的中心--尽管实际上，目镜的光轴对准的是调焦筒的中心。

The computer separately connects and controls the I/O end and A/D converter; the I/O end connects and controls the X, Y axis driving circuit and the semiconductor laser; the X, Y axis step-by-step driving circuit connects and controls the X, Y step-by-step electrical machines to control the dimensional platform; the beam of the semiconductor laser passes through the focusing drawtube with 0.1mm diameter to form the facula with the diameter less than 0.1mm; the facula irradiates on the detector surface of the XY dimensional displacement platform to produce the corresponding electric signals; the detector surface connects the A/D converter through the amplifier; the electrical signal is amplified and is converted into the data signal by the A/D converter and is sent to the computer for processing.

由计算机分别连接并控制I/O端口和A/D转换器，I/O端口分别连接并控制X、Y轴步进电机驱动电路和半导体激光器，X、Y轴步进电机驱动电路分别连接并控制X、Y轴步进电机，从而控制二维位移平台，半导体激光器的光束经过设有直径0.1mm小孔的聚焦镜筒形成＜0.1mm直径的光斑，光斑照射于设在XY二维位移平台上的探测器表面使其产生响应的电信号，探测器表面经放大器连接A/D转换器，电信号经放大器放大后，由A/D转换器转换为数据信号送计算机处理。

Similarly, the cotton root-length density reduced gradually from the root axis to both sides of it, and the maximal length density of root was observed at the position of root axis in soil and was diminished by increased dripper discharge.

水平方向上，棉花根长密度由根轴向两边逐渐减小，而且根轴处的根长占总根长比率随滴头流量的增大而变小。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。