查询词典 magnitude

Some asymmetric vortex solutions are obtained, which yield the side forces and yawing moments having the order of magnitude agreeing with experimental data.

本文获得了大迎角旋转体在不同非对称边界条件下的非对称涡解，其中一些非对称涡解的侧向力和偏能力非符合实验数据的量级。

This article describes the frequency and magnitude of the control of the generators.

本文介绍的是一种频率和幅度可以控制的信号发生器。

As a result, the first magnitude reported is usually based on a small number of recordings.

因此，第一次报道的地震级数通常基于很小一部分的数据。

An MR fluid is in a free-flowing liquid state in the absence of a magnetic field, but under a strong magnetic field its viscosity can be increased by more than two orders of magnitude in a very short time and it exhibits solid-like characteristics.

它在无外场作用下表现为流动良好的液体状态，然而在强磁场作用下可在短时间

MAGNITUDE Essential Oil: Allspice 16、广度精油:多香果 Allspice is a scent often associated with the holidays and is found in holiday candles or room fresheners.

多香果是一种经常与假日有关的香气，可在假日蜡烛或空气清新剂中找到。

Different axleload causes different pavement damage, and the damage is not linear with the magnitude of axle load.

轴载不同对路面造成的损害也不同，而这种损害与轴载的大小呈非线性关系，现有的轴载换算公式不能解决这一问题。

Different axle load causes different pavement damage, and the damage is not linear with the magnitude of axle load.

轴载不同对路面造成的损害也不同，而这种损害与轴载的大小呈非线性关系，现有的轴载换算公式不能解决这一问题。

Finally, the forming and localization course of shear band of tungsten alloy material have been analyzed. The influence of thermodynamics parameter of density, static yield stress, specific heat coefficient and heat conducted coefficient on shear-localized of tungsten alloy has been contrastively and individually analyzed through changing magnitude of each parameter. The result has shown that static yield stress and specific heat coefficient have bigger influence on the shear-localized of tungsten alloy.

最后对钨合金材料中的剪切带的形成和局部化过程进行了分析，并且在分别改变密度、静态屈服应力、比热容及热导率等热力学参数下，对比分析了它们对钨合金剪切局部化的影响程度，结果表明改变静态屈服应力和比热容对钨合金剪切局部化的影响较大。

The present paper is intended to offer a method that can be used to revise measured value of cam outline according to the identified mounting eccentric magnitude of the camshaft,as well as the given base circle radius of the cam.

凸轮轴在检测仪上的安装偏心量会影响凸轮轴上凸轮廓形尺寸测量的准确性和复现性。本文提出了根据辨识获得的安装偏心量和已知的凸轮基圆半径来修正凸轮廓形测量值的方法。此方法在实际测量中获得了满意的效

The results showed that the output beam was Gaussian while the center of the envelope shifted, the shift magnitude was determined by angle errors and beam size.

研究表明：出射脉冲仍然是高斯型脉冲，但包络中心发生偏移，偏移量由角度偏差最和光束口径决定。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。