查询词典 magnetizing current

Such equipment is the main magnetic power, can provide a one-way communication and half-wave rectifier power magnetizing current, accessories have contact, clamp, opening and closing, and closed-type magnetizing coil and flexible cables that can carry out contact method, clamp power law and the magnetic coil method.

这类仪器主体是磁化电源，可提供交流和单向半波整流电的磁化电流、附件有触头、夹钳、开合和闭合式磁化线圈及软电缆等，能进行触头法、夹钳通电法和线圈法磁化。

For direct magnetization the magnetizing current is passed directly through the part creating a circular magnetic field in the part.

对于直接磁化的磁化电流通过直接通过部分创造一个圆形磁场中的一部分。

Magnetizing current and torque with good linear relationship with the excitation current at a very broad range of is proportional to.

且转矩随激磁电流呈良好的线性关系，与激磁电流在相当广阔的范围内成正比。

It is, again, helpful to use the magnetizing current As explained earlier, the magnetizing current imq can be approximated to be constant.

这是一次有益的利用激磁电流说过磁化电流过量可近似为常数。

When power transformer is in steady state,its magnetizing current is little,and usually the magnetizing current is not more than 3%~\Q% of rated current value.

变压器正常运行时的励磁电流很小，一般不超过额定电流的3％～10％。

Second, and magnetic brakes, clutch: With the development of modern industry, and magnetic clutches and brakes, as a basic component in the industrial field received a wide range of applications and other components shown can not be replaced by the superiority of its high magnetic powder for media job to Change magnetizing current for the control of the means to control transmission, the purpose of braking torque.

二、磁粉制动器、离合器：随着现代工业的发展，磁粉离合器和制动器作为一种基础元件在工业领域中得到广泛的应用，并显示出其它元件无法取代的优越性，它以高导磁粉体为工作媒介，以激磁电流变化为控制手段，达到控制传递，制动扭矩的目的。

It is harmful to the characteristics of the transformers on line. It causes the increasing of magnetizing current, harmonics leakage magnetic flux, and thus the losses, which in turn results in the structures overheating and insulation ageing.

电力变压器的磁动势和磁通出现直流分量的现象称为"直流偏磁"，这一现象将对变压器的正常运行产生不利的影响，诸如励磁电流有效值、高次谐波成分及其相应损耗的增加，铁心高度饱和引起的漏磁通的增加，以及由此引发的局部过热、绝缘老化等问题。

Considering that the load current contains a little portion of the magnetizing current, this paper presents the approach of magnetizing current compensation.

考虑到负载电流中有小部分励磁电流分量，该文提出串联变压器励磁电流补偿(magnetizing current compensation，MCC)的方法。

To improve accuracy of detection of current direction, components of magnetizing current and torque current are transformed into two-phase stationary frame. Therefore compensating voltage vector can be decided according to the sector the current vector is locating.

为了提高电流极性检测的准确性，利用旋转轴系中的励磁电流和转矩电流分量经过坐标反变换，判断电流在两相静止轴系所处的扇区来决定需要施加的补偿电压。

Magnetizing current (i1) flows in the "magnetizing inductance" and causes core reset after primary switch turns off.

磁化电流(i1)流入"磁化电感"，使磁芯在初级开关断开后去磁。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。