查询词典 machine tool

Wind generator engine "wheel processing special-purpose numerically-controlled machine tool"

风力发电机&轮毂加工专用数控机床&

Wind generator engine " FER base special-purpose processing numerically-controlled machine tool"

风力发电机&前机舱底座加工专用数控机床&

Because of the complexity and diversification of mold cavity curve surface, today, its finishing still must be done by hand work of well-skilled workers, though most of mold manufacturing procedures have automated by the introduction of NC machine tool and CAD/CAM system.

由于模具型腔曲面的复杂性和多样化，其光整加工仍然停留在手工加工方式上。

We have to use modern production equipment, the operation of well-refined flow, regulate the management, to meet the needs of the community, Sihai CNC Machine Tool Factory will strive for excellence, not paragraph efforts to produce more, higher quality products, for users provide the best services.

我们应用现代化的生产设备，精细周密的操作流程，规范的管理，最大限度地满足社会的需求，四海数控机床厂将精益求精，再接再厉不段地生产出更多、更高品质的产品，为用户提供最佳的服务。

For large and medium-sized mechanical processing plants, where possible, should consider adopting more than one focus of the circulatory system for the machine tool cutting fluid supply, but each is the same type of cutting fluid.

对于大、中型机械加工厂，在可能的情况下，都应当考虑采用集中循环系统为多台机床供应切削液，但必须各台是采用同一种切削液。

In this paper, the design of using a PLC control system in modular machine tool s power sliding table instead of the conventional relay control system is introduced, and the electric control schematic diagram and ladder diagram procedure of PLC are given.

本文介绍了在组合机床动力滑台中用PLC代替传统继电器的控制系统设计，并给出了相应的电气控制原理图和PLC梯形图程序。

Point-to-point or Positional Control In point-to-point control the machine tool elements tools, table, etc.

对于一件事物，它被不连续直流电压脉冲驱使，是来自数传计算机和其他的自动化的非常方便的输出控制系统。

The paper contributes to heat design and dynamic design of the machine tool spindle system.

论文成果为机床主轴系统的热设计和动态设计作出了有益的贡献。

Advanced electro-spindle, machine tool spindle design and manufacture technology, excellent equipment, reliable quality.

拥有先进的电主轴、机床主轴设计和制造技术，设备精良，品质可靠。

In addition to the strength and rigidity, the dynamic properties of machine tool spindle should be considered.

机床主轴的设计除了要考虑其强度和刚度外，尚须考虑其动态特性。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。