查询词典 m.

Results CPC-30%vol%PLGA had the best mechanical capability,σ=40.5 Mpa,Ε=13.8 Gpa;Intercommunicative holes which size was among 100 μm���300 μm was observed in...

结果CPC-30%vol%PLGA力学性能最好，抗压强度40.5MPa，弹性模量13.8Gpa；模拟体液下降解6周材料形成100～300μm相互连通孔隙；骨髓间充质干细胞在支架材料表面生长良好，并通过降解产生的孔洞内材料深部长入。

The interlay thickness between the altar and laohudong celadon appears in 100μm difference, which may relate with the chemical composition, diffusive behavior of the elements and the firing temperature.

从釉层、中间层、和胎层的al2o3和cao的含量变化数据表明，郊坛下官窑和老虎洞官窑的青瓷制品有厚度分别为120-140μm和230-240μm的中间层，反映出烧造工艺上有一定的差别。

The M- radical of V is determined and a criterion for irreducibility of an admissble module for an arbitrary vertex operator superalgebra V is given.

设V是一个顶点算子超代数，M是一个可容许的V-模。刻划了V的M-根，并给出了一个可容许V-模不可约性的差别准则

Theorem Let M be a orientable or non-orientable closed surface, and f a C°-flow whose every singular point is isolated. Then f has POTP if and only if the following three conditions hold

定理 设M是任一个可定向或不可定向的闭曲面，f是M上任一个奇点均孤点的C〓-流，则f具有伪轨跟踪性质的充分必要条件是

M'kay, children, this is what I'm talking about.

M'kay，孩子们，这就是我要讲的

Here pis 1 or 2.In chapter 8. we extend the Runge-Kutta methods to variable delay differentialalgebraic system. It is proved that if the Runge-Kutta method which is algebraicallystable and diagonally stable is consistent with order p , the extended Runge-Kuttamethod with Lagrange interpolation procedure is D_A-convergence with order M. HereM=min{p, u + q + 1 }, and u + q is the degree of Lagrange interpolation polynomial.

第八章将求解常微分方程的Runge-Kutta方法改造后用于求解变延迟微分代数系统，并且证明如果代数稳定且对角稳定的Runge-Kutta方法对于常微分方程初值问题在经典意义下是p阶相容的，那么具有Lagrange插值过程的该方法是M阶D_A-收敛的，M=min{p，u+q+1}，u+q为Lagrange插值多项式的次数。

BMW development driver Bernd Limmer says,"I'm completely convinced this is a real M car."

宝马发展司机贝恩德米Limmer说，"我完全相信这是一个真正的M车。"

Test results of EMP-steel frictional pairs showed that the wear rate h of EMP, press p andvelocity v are suited to equations separately: h =m .p n and h =a .v b.

试验证明EMP复合材料瓦与钢对磨时的磨损率h与压力p、速度v之间分别满足h=m.pn和h=a.vb关系式，给出了相应系数m、n、a、b的值；磨损率与钢试件表面粗糙度Ra之间满足h=A·RaB关系式，给出了A、B的有效范围值。

Though 100 μMATRA exerted a remarkable tumor killing alone, 100 μM ATRA plus GCV elicited asignificantly increased killing effect when there were more than 5% of C6tk cells in thecell mixture.

单纯应用100μM ATRA对C6细胞也可以产生很强烈的杀伤作用，然而当100μM ATRA与GCV伍用时，5％以上的C6tk细胞就导致细胞杀伤作用的进一步加强。

When the value of m is on a neighbourhood of 2, the value of η can achieve maximum, on this condition, strength-size effect is very obvious.

在1.65≤m≤3范围内变化最为剧烈，所以当非均质参数m在此范围内时，岩石材料的强度尺寸效应在明显和不明显之间变化幅度最大。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷