查询词典 luminous beam

New box design with durable 0.5 inch (13 mm) paving skin Vertically-adjusting mold mount for precise leveling of mold to machine Telescoping end sections with 12 inches (305 mm) of width variation on each side are available Standard paving depth is zero to 24 inches (610 mm)Edge slump adjustment Hydraulic Vertical Hinged Sideplates, self-contained inside the mold for track clearance Split, pressure-compensated sideplates Folding side plate wings for transporting without removing Pivoting mold mounting beam to eliminate stress points Self-supported TA is hydraulically driven with 3.5 inch (89 mm) ACME screws for up to a six inch (152 mm) crown Front and rear top T-bar on mold for attaching accessories and structural integrity Inserts are bolted together with front and rear alignment pins for easy mold assembly New vibrator mounting tube attaches to T-bar on mold – Vertical vibrator lift – Rear lubrication system with grease zerks accessible from the work bridge New strike-off – Mounted on paver frame T-rail, independent of the mold – New modular design with wedge lock system for ease in changing widths – 10 inches (254 mm) of hydraulic height adjustment – Hydraulic crown adjustment Spreader plow mounted to paver frame T-rail, optional auger available Tamper bar optional

与耐久性的新的箱子设计铺精密水准测量的0.5英寸(13 mm)皮肤垂直调整的模子登上模子用机器制造挤撞与12英寸(305 mm)的末端部分在每边的宽度变异是可利用的标准铺的深度是零对24英寸(610 mm)边缘暴跌调整水力垂直的取决于的Sideplates，独立性在轨道清除分裂的模子里面，折叠运输的pressure-compensated sideplates旁边板材翼没有去除在轴上旋转的模子架置射线消灭重音点Self-supported TA水力驾驶与3.5英寸(89 mm)由六英寸(152 mm)冠决定的尖端螺丝在前后冠上在模子的T酒吧附有的辅助部件并且结构正直插入物与容易的模子汇编新的振荡器架置管随员T酒吧的定位销一起在前后被闩上在模子–垂直的振荡器推力与油膏zerks的–后方润滑系统容易接近从新工作的桥梁触击–在摊铺机框架足迹，模子的独立登上了与楔子锁系统的–新的模块设计在改变的宽度的舒适的– 10英寸(254 mm)水力高低调整–水力冠调整分布器犁登上了对摊铺机框架足迹，任意任意木钻可利用的堵塞器的酒吧

US satellite reconnaissance photo of suspected Soviet beam weapon installation near Semipalatinsk.

美国卫星侦察照片的怀疑苏联光束武器安装的塞米巴拉金斯克附近。

The silica surfaces polished with ion beam of 400ev energy and 100mA density in 35°incident angle for 2hrs was found to have a roughness less than 0.5nm . The SFM was also used to measure the surfaces to be bonded by SAB method and the deformations of the surfaces during contact each other. The micro roughness of the surfaces was found to produce great effect on the SAB strength. The rougher the surfaces are, the weaker the bonding forms.

本文首先将原子力显微镜应用于一种新的超光滑表面离子束抛光的工艺研究，搞清了表面纳米级微观形貌与离子束抛光参数之间的关系，在离子能量为400V、束流密度为100mA和入射角为40°时，经过两个小时以上的抛光，硅（111）表面微观形貌在1μm×1μm的范围内从抛光前的5nm下降到0.4nm。

When the troops master Fort Knox they can beam themselves to another location by choosing from the computer's menu.

部队征服了诺克斯堡之后，可以通过电脑菜单的选择把自己传送到另外一个地点。

When the troops master Fort Knox they can beam themselves to another location by choosing from the computer's menu.

等到部队掌握了Fort Knox的地形之后，他们可以把自己传送到另外一个地点上去，而要做的就只是在电脑菜单上进行拣选就好了。

Step Fresnel lens of high diffractive efficiency is fabricated by ion beam etching.

使用离子束刻蚀法成功制作高衍射效率16阶菲涅耳透镜。

The distribution of the rolling pressure on H-beam is a very important problem.

H型钢的轧制压力分布是研究人员非常关心的问题。

China to vigorously promote the use of H-beam, with the associated technical information for customers obtain.

为大力推广国产H型钢的使用，备有相关的技术资料供客户索取。

The mechanism and conditions of web-wave formation during hot rolling of H-Beam were studied.

对H型钢轧制过程中腹板波浪的产生机理及形成条件进行了研究。

The structure of H-Beam products is nearly same , but sizes not .

这样不但得到质量合格的产品，而且能耗最低、产品质量较高。

According to our present broadcasting situation,the thesis proposes using new technology to update and reform the present HFC. It also suggests broadcasting using self-advantage and arranging EPON in order to win the supermarket.

论文从我国广电的现状出发，结合实际，积极倡导采用新技术更新、改造我国现有的HFC网络；倡导广电现阶段利用自身优势，部署EPON网络来赢取市场。

A new general kinetic equation was derived in which the effect of the removal of condensation water was taken into account completely, and was applied to the polyesterification kinetic study of AA/HPHP and AA/NPG. It was found that the reaction order of self-catalyzed polyesterification was not constant. For these polyesterifications, the reaction order was 2.5 at a low temperature, while 3.0 at a high temperature.

考虑缩合水的排除对反应体系的影响，用体积浓度单位推导出一个新的聚酯反应总包动力学方程，并应用到AA/HPHP和AA/NPG两个聚酯化反应的动力学研究中，研究发现，自催化聚酯反应的反应级数并不是固定值，对于AA/HPHP和AA/NPG两个聚酯化反应而言，低温时反应级数为2.5，高温时反应级数为3.0。