查询词典 lowest temperature

They could be divided into three kinds of species when Genetic distance was0.36, six kinds when 1.9 (5) Chromatography factors of Determination of capsicin by high performance liquidchromatography: The mobile phase was V(CH_3OH): V(H_2O)=75:25 with a flowrate of 1.2ml/min, UV detector set at 280nm, columniation temperature 25℃. Thecapsicin contents of 12 hot peppers were 0.07 to 8.02 mg/g. The hottest wasWild-hill-pepper-1 in Yaan, which contained the highest capsicin. In the next placesof capsicin contents were Wild-hill-pepper-2, To-sky-pepper-2 andTo-sky-pepper-1.The Jiaozhou-long-pepper from Jiaozhou in Shandong provincecontained lowest capsicin.

5高效液相色谱法测定辣椒素的色谱条件：流动相为V甲醇：V水=75：25，流速为1.2ml／min，UV检测器检测波长为280nm，柱温25℃。12份辣椒样品辣椒素含量在0.07～8.02之间，辣椒素含量最高的为来源于四川雅安的野山椒-1，其口感为极辣，其次为野山椒-2、朝天椒-2、朝天椒-1，辣椒素含量最低的为来源于山东胶州的胶州长海椒。

At the target surface impinged by the synthetic jet, the temperature field is symmetric with the lowest filed in center. The heat transfer coefficients also take on the same trends with centrosymmetric waves, which means that the best cooled area is the stagnation.

在冲击靶板上，整个冲击区域呈现出中心温度最低的近似圆形的对称性分布，对流换热系数曲线呈现出中心对称的波峰分布形状，表明自耦合射流驻点区换热最强。

Although this lowest cooling temperature is higher than that achieved by using a double-inlet valve, the cooling power obtained by the refrigerator with an inertance tube is higher than with a double-inlet valve, which demonstrates the excellence of inertance tube.

虽然最低制冷温度高于双向进气型脉管制冷机的制冷温度，但是当制冷温度在75K以上时，惯性管型脉管制冷机的制冷量大于双向进气型脉管制冷机的制冷量，从而体现了惯性管的优越性。

Results show that, following the leaching time extending, the leaching concentrations of heavy metals and lixiviate toxicity of heavy metals increase in the fly ash. When the ratio of liquid and solid add, the leaching concentrations of heavy metals obviously become big, and the Cd's leaching concentration is the biggest, when the ratio of liquid and solid is 90, the Cd's leaching ratio exceed the percent of 70. At the time pH is about 7, the leaching concentrations of heavy metals are the lowest. When the grain size is the bigger or little, the leaching concentrations of heavy metals are lower, however when the grain size is 250-900 μm, the concentrations are higher. After fly ash melt in the high temperature, the lixiviate toxicity of heavy metals greatly reduce, which explains that the effect of melting on heavy metals' stabilization is very good.

结果表明，随着浸出时间的增加，飞灰绝大部分重金属的浸出浓度增高，浸出毒性增强；液固比增加，大部分重金属的浸出率大大提高，其中重金属Cd的浸出率最大，在液固比为90时，飞灰中的Cd的浸出率达到70%以上；pH为中性左右的时候，医疗垃圾飞灰中的大部分重金属的浸出液浓度最低；颗粒尺寸在较大或者较小时，医疗垃圾飞灰中的大部分重金属浸出浓度较小，大部分重金属在颗粒尺寸250～900 μm时，重金属的浸出浓度较高；飞灰高温熔融后，重金属的浸出毒性大大降低，说明熔融对重金属有很好的固化效果。

The metabolic energy and fodder unit of Arthraxon pricnodes per unit area reached a peak of 4.88×103 kJ*m-2 and 3891 FU*hm-2,77.5%and 80.8%higher than the lowest value. The effect of temperature on dry biomass of Setaria faberii and S. sudanense in each growing season was not significant, nor was relative humidity.

不论是单个生长季的温度，还是几个生长季温度的组合，对于狗尾草和苏丹草干重的影响都是不显著的，相对湿度也是如此。

Using electric operation controlled lifting system so that the floating plate safe, stable, powerful stress job to ensure that the molding, simpler and quicker. 2 strong suction system without phase vacuum suction, negative pressure may have been the ideal state, the use of more convenient. 3 equipment, power can achieve the best working state of the lowest electricity consumption standards. 4 soften me with automatic temperature control system can be made under different heating plate settings required. 5 operating system, the use of numerical control system to operate, effective improve the efficiency of the operator. 6 advanced technology can be a cooling suction pressure molding, may also be under the light box, the different effects of the word alone or in a separate suction pressure, so that light boxes, forming a word.

产品特点：1。采用电操作控升降系统，使浮动板安全，平稳，工作压力强大，确保成型更简便，快捷。2 吸气系统功能强劲，无需阶段吸真空，可一直处于理想负压状态，使用更方便。3 设备功率可达到最佳工作状态的最低电耗标准。4 软化箱装有自动恒温控制系统，可根据板材不同的加温需要设定。5 操作系统采用数控系统操作，有效的提高了操作人员的工作效率。6 技术先进，可吸压冷却一次成型，也可根据灯箱，字的不同效果，单独吸或单独压，使灯箱，字一次成型。

Results: 1. The value of all experimental indexes decreased significantly after heat stress, and reached the lowest at the time 2-8 hours after heat stress. This indicates that the immunity of the mice is damaged to the largest extent at 2-8 hours after heat stress. 2. L-arginine supplementation with appropriate dose could remit the acute atrophying of thymus and spleen tissue caused by heat stress. 3. After L-arginine supplementation with appropriate dose, the lymphocyte proliferation, the level of concentration of IL-2 and * expression of IL-2R raised in the group with room temperature; in the heat stress group the level of three indexs decrease significantly. Furthermore, the decrease of the group given 1 .Smglg.bw L-arginine is the smallest. This result indicates that the concentration of 1 .Smglg.bw L-arginine supplementation could remit the depressment of the immunity caused by heat stress. 4. The [Ca2~] in activated thymocytes of the group with L-arginine -2- supplementation is significantly higher than that of the group with water supplementation. This indicates that L-arginine supplementation could protect thymoeytes of mouse under heat stress. We also found that the fluorescence intensity of [Ca2~] in activated thymocytes of the group given 1 .Smglg.bw L-arginine is the highest.

结果：1、热应激后小鼠的各项免疫指标均有显著性下降，其中在2.8小时降到最低，提示在这个时间段小鼠的免疫功能受到最大损害；2、适量补充精氨酸有助于缓解热应激导致小鼠胸腺和脾脏的急性萎缩；3、常温组，补充适量精氨酸后小鼠淋巴细胞增殖活性、IL-2的浓度及IL-2R的表达均有显著性上升，而热应激后三指标均显著降低，其中在精氨酸给予浓度为1.5mg/g.bw时三指标的降低程度最少，提示该浓度可最大程度缓解热应激对小鼠免疫功能的抑制；4、补充精氨酸组的活化胸腺细胞［Ca~(2+)］较给水组有显著性上升，说明精氨酸对热应激小鼠胸腺细胞具有保护作用，并发现在精氨酸给予浓度为1.5mg/g.bw时活化胸腺细胞的胞浆钙离子荧光强度达到最大；5、热应激后小鼠血清NO的浓度均有不同程度的上升，补充精氨酸后血清NO上升更加明显，但并非随精氨酸给予浓度的增加而增加。

The results confirm that NH3 slip increases with both higher ratio of NH3 to NO n(NH3/n and higher concentration of a reducing reagent, while it decreases with the increase of temperature. Initial NO concentration and its residence time can also affect the NH3 slip. A higher initial NO concentration lead to higher NH3 slip, but added residence time has the opposite effect. Among urea, ammonium carbonate and ammonia liquor, the NH3 slip of urea is the highest and that of ammonia liquor is the lowest.

试验结果表明：温度越高，漏失氨含量越低；随氨氮物质的量比的增加，NH3漏失含量不断增加；还原剂质量浓度越低，NH3漏失含量越低； NO初始浓度和停留时间对漏失氨浓度也有影响，NO初始浓度越高NH3漏失浓度越高，停留时间越长漏失氨浓度越低；不同还原剂NH3漏失浓度不同，尿素、碳酸氨、氨水3种还原剂中，尿素的NH3漏失浓度最高，氨水的NH3漏失浓度最低。

Frigon was chosen as the experimental, According the quality of the heavy oil materials which have high oil content and low sericin content, technical conditions were initially set at the level of low pH value 、low temperature and enforced presoaking process. And then, these surfactants and builders were chosen to test in the presoaking and refining process, getting some kinds of surfactants with lowest oil content on refined waste silk. Following that, they were tested for best oil-removing effect in mixture.

实验中，选择了滞头原料为试验原料，根据绢纺愿料冶胶量低，含油量高的特点，初步确定了低pH值、低温和加强预浸的工艺方案，然后对所选的各类表面活性剂和助剂进行了预浸、精练工艺试验，从中选出较好的几个品种进行不同类型的复配试验，在复配的基础上试验工艺条件—温度、时间、碱用量对残油率、残胶率的影响确定小样最佳工艺。

The results show that DEHP can migrate into all water food simulants from PVC film and the migration rate was the highest in 65% aqueous ethanol with the range 0.85%～6.31% and a big increasing amplitude when contacting temperature over 30℃, the rate was lower in 20% aqueous ethanol and distilled water with the range 0.19%～0.45% and 0.19%～0.37%, respectively; and the rate was the lowest in 4% aqueous acetic acid with the picked out rate 17% and the value ＜0.4%.

研究结果表明，PVC膜中DEHP在几种水性溶剂中均有溶出，在65%乙醇中溶出率最大，范围为0.85%～6.31%，当浸泡温度超出30℃后，溶出率增幅较大；在20%乙醇和蒸馏水中的溶出率较小，范围为0.19%～0.45%和0.19%～0.37%；4%乙酸对DEHP的溶出作用最小，70个样品中，检出率为17%，检出溶出率。4%。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐