查询词典 lower-case

Dawsonite of Mesozoic strata in Northeast China and adjacent area distribute in Lower Cretaceous strata from Hailaer basin,Tamtsag basin, Erlian basin, Kailu basin and Fuxin basin, and Upper part of Lower Cretaceous and Lower part of Upper Cretaceous from southern Songliao basin.

东北及邻区中生代地层中的片钠铝石分布于海拉尔盆地、塔木察格盆地、二连盆地、开鲁盆地和阜新盆地的早白垩世地层及松辽盆地南部的早白垩世晚期-晚白垩世早期地层中。

The lower berth in a double tier should be not less than 30 centimetres above the floor; the upper berth should be placed approximately midway between the bottom of the lower berth and the lower side of the deckhead beams.

如安置双层床，则下床在地面上的高度不应小于30厘米；上床应大约位于下床床板与天花板甲板梁底部的中间位置。你知道它的英文吗？

objective: to evaluate the efficacy and safety of expectorant mucosolvan aerosol inhalation in lower respiratory tract infections.method: 86 patients' clinical symptoms with lower respiratory tract infections were observed to identify the difference during the treatment.result: two groups efficiency comparison differentiae exits palpability (p.01), obvious side effect was not found in mucosolvan.conclusion: mucosolvan will be effective to treat lower respiratory tract infections, it's safe and reliable.

目的：评价祛痰剂沐舒坦雾化吸入治疗下呼吸道感染的临床疗效及安全性。方法：观察 86例下呼吸道感染患者治疗治疗前后咳嗽、咳痰等临床症状的变化。结果：两组有效率比较差异有显著性(p.01)未发现沐舒坦有明显副作用。结论：沐舒坦治疗下呼吸道感染疗效确切安全可靠值得临床进一步推广使用。

Committed cohabiters are more downscale than married parents -- they have lower incomes, lower education levels and lower rates of home ownership.

与已婚夫妇相比，非婚同居伴侣的社会阶层较低，他们收入少、教育水平低、住房拥有率也低。

A water baffle is vertically arranged in the vessel, which divides the vessel into an intake region and an exhalant region; because the lower part of the water baffle and the lower part of the vessel are provided with a gap, the intake region is communicated with the exhalant region; an inlet and an outlet are respectively arranged on the upper part of the intake region and the upper part of the exhalant region; a drain is arranged at the lower part of the vessel, on which a drain valve is arranged.

一种茶浴炉炉外储垢排垢器为一密闭容器，容器内竖向装有阻水板，将容器分隔成进水区和出水区，阻水板与容器底部有一定间隙使进水区和出水区相通，进水区和出水区上部设有进水口和出水口，容器最低部设有排污口，其上装有排污阀。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.08-0.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.02-0.05 and 0.2 mm^3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2立方公厘左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.080.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.020.05 and 0.2 mm3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2 mm3左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

In the different zoning of xenoliths, molybdenum and tungsten contents is lower and homogeneous,and be lower than the world\'s average abundance; tungsten compared to molybdenum,the content more homogeneous in xenoliths, compared to mantle\'s average abundance more less. This explains the geochemistry incompatible character homophyly and diversity of molybdenum and tungsten determined their trend enrichment in crust in the course of the mantle evolution and magmatism, among molybdenum more trend enrichment in lower crust but tungsten in middle-upper crust.

包体不同带中，钼、钨的含量较低且较为均一，并低于世界均匀丰度；钨和钼相比，其在包体中的含量更为均一，相对于地幔均匀丰度更小，说明钨、钼的地球化学不相容性的类似性和差异性决定了它们在地幔演化和岩浆过程中倾向富集于地壳中，其中钼更倾向富集于下地壳，钨则更倾向富集于中上地壳。

In general, the design work with traditional measures is done by hand, which cannot meet the needs of the technology and manufacture. So the author has developed a CAD hydraulic design software fit for lower specific speed axial flow runner, which is easily operated by users.The main research work of this paper is as follows:1 Analyzing the main reason of axial flow power station cannot work well under littler volume of flow in some season and putting forward an improving scheme, pointing out the characters of design under abnormal factors.2 Combined with the development of the industry in our country, the abnormal hydraulic design method of propeller turbine is discussed based on present literature, data and experiment results.3 Guided by the design method of software engineering, a suit of hydraulic design software of Lower Specific Speed Axial Flow Runner is programmed by the object-oriented programming language Visual Basic and a straightforward, concise and standard Windows human-computer dialogue interface is designed for the system, which makes the operation of the system very convenient.4 ActiveX Automation technology is adopted as the interface with AutoCAD and the hydraulic drawings are edited, modified by AutoCAD until hydraulic model drawings according with the demand of engineering practice are output.5 To resolve practice problem, the author has designed a lower specific speed axial flow runner for Duowa Power Station through an example.

论文的主要内容有：1 深入分析很多轴流定桨式水电站枯水季节小流量下不能发电的主要原因，提出减容改造方案，并指出超常规条件下的改造设计特点。2 结合国情及行业发展需要，参考现有资料、文献和前人的研究成果，进行低比转速轴流式转轮叶片水力设计方法的研究，对轴流式转轮叶片的奇点分布法水力设计进行了全面的探索，结合现代计算机技术，找到了一种针对特殊条件的轴流式转轮叶片水力设计方法。3 仔细比较多种AutoCAD二次开发工具后，结合本课题的特点，选用Visual Basic语言，综合应用软件工程的设计思想，进行低比转速轴流式转轮叶片水力设计软件的编制，为系统设计了直观、简洁和标准的Windows人机对话界面，便于用户操作；编程时在考虑到设计条件特殊性的同时，尽量做到程序的通用性，使之可用于解决同一类问题；另外，大部分程序还可移植到普通轴流式转轮叶片水力设计中，具有良好的适应性。4 利用ActiveX Automation技术与AutoCAD接口，对AutoCAD进行二次开发，在AutoCAD下实现水力图的自动生成和编辑，直至输出符合实际工程要求的木模图。5 通过算例，为多哇水电站设计了一个低比转速轴流定桨式转轮，解决其在枯水期小流量下不能发电的问题。

Lower chest wall indrawing lower chest wall goes in when the child breathes in: if only the soft tissue between the ribs or above the clavicle goes in when the child breathes, this is not lower chest wall indrawing

注意：当孩子吸气时低胸腔吸进，这时会发生低胸呼吸：如仅有肋骨和锁骨间的软组织吸进的话这时便不是低胸呼吸。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。