查询词典 low pressure

During the fracturing for low pressure and low permeability gas reservoirs, there are some main problems in conventional hydroxypropylguar - organic boron cross-linking system: Firstly, the water-lock damage to low pressure and low permeability gas formations by filter liquor; Secondly, the reason for alkali-sensitive damage in alkali-sensitive reservoirs is that conventional hydroxypropylguar - organic boron cross-linking fracturing fluids were cross-linked under alkaline environment, while the permeability of reservoirs is reduced greatly; Thirdly, the formation pressure is low, and the energy of flow back is not enough, at present, the main measure in oil fields is "injecting with liquid nitrogen", but this technique increased the cost of fracturing, making great troubles in operating, and leaving the liquid nitrogen also is a big problem.

在低压低渗透气藏的压裂改造过程中，常规羟丙基胍胶-有机硼交联压裂液体系存在的主要问题，一是压裂液滤液对低压低渗透气层造成的水锁损害；二是常规羟丙基胍胶-有机硼压裂液是在碱性条件下交联的，对碱敏性储层造成碱敏损害，降低储层渗流能力；三是地层压力低，压裂液返排能量不足，当前各油田采取的措施主要是&液氮伴注&技术，但是&液氮伴注&技术增加了压裂的费用，而且液氮存放也存在较大问题。

Ning Boheng tells limited company of hydraulic pressure motor is the professional production company that the design makes equipment of system of actuating device of gyrator of winch of motor of hydraulic pressure of type of incurvate line motor, crankshaft, hydraulic pressure, hydraulic pressure, quiet hydraulic pressure, of all kinds hydraulic pressure and hydraulic pressure.

宁波恒通液压马达有限公司是设计制造内曲线马达、曲轴式液压马达、液压绞车、液压回转器、静液压驱动装置、各类液压系统及液压设备的专业制造公司。

The study shows that the pressure transient curve of fractured wells in closed circular formation can be divided into six different flow regimes. In condition of the same fracture opening width and fracture length, compared to rectangular fracture, the pressure drop with tapered fracture is bigger, and the dimensionless pressure and pressure derivative curves are higher. In condition of the same fracture opening permeability, compared to linear declining and constant conductivity fractures, the pressure drop with exponential declining conductivity fracture is the biggest, and the dimensionless pressure and pressure derivative curves are the highest.

研究结果表明：圆形封闭地层压裂井的压力动态曲线可以划分为6个流动阶段；在相同裂缝开口宽度和相同裂缝长度的条件下，与矩形裂缝相比，楔形裂缝压力消耗大，表现为无因次压力及压力导数曲线越高；在相同裂缝开口渗透率的条件下，与导流能力呈线性降低的裂缝以及常导流能力裂缝相比，导流能力呈幂指数降低的裂缝压力消耗最大，表现为无因次压力及压力导数曲线最高。

Hemodynamic parameters including heart rate, cardiac output, systolic blood pressure, diastolic blood pressure, mean arterial pressure, central venous pressure,right ventricular end-diastolic pressure,left atrial pressure, and left ventricular end-diastolic pressure were monitored and recorded at 5, 60 and 180 min after cardiac resuscitation with PUCA pump.

结果无辅助、延迟辅助和即时辅助复苏持续时间分别为(38.3±5.8) min、(43.5±9.2) min和(48.7±23.8) min，3组比较差异无显著性(P＞0.05)；3组成败比分别为0/3、0/2和5/1，差异有显著性(P＜0.05)。

The most heavy flow ability of barrage swirl is controlled by fastenning device and barrage size, the most heavy discharge is more when barrage aperture is bigger, the influence of barrage position on discharge is not obvious; The pressure of the end of the shaft and fastenning device increases which aroused by barrage, and there is a restraining action to flow waving of the shaft; The barrage aperture is smaller, the increase of pressure is heavier, the influence of position to the increase of pressure is not obvious; The positive pressure of the level section in the hole between fastenning device and barrage increases obviously, the change of press along length reduces, mural press in the hydrosphere separating area of outlet of fastenning device becomes positive pressure, which is propitious to the increase of flow cavitate number in the low pressure area of the outlet of fastenning device; The influence of change of swirl cavum diameter caused by barrage to ventilating state is obvious.

阻塞旋流最大泄流能力由起旋器及阻塞体型共同控制，降低了泄洪洞的泄流量，孔径大的阻塞最大下泄流量较大，阻塞位置对泄流量的影响不明显；阻塞引起竖井及起旋器端头压力增大，对竖井部分的水流波动具有抑制作用；阻塞孔径越小，压力增加越大，位置对压力增大影响不明显；起旋器与阻塞之间水平洞段的止压力明显增加，沿程压力变化减小，起旋器出口的水气分离区壁面压力变为正压力，有利于起旋器出口低压区水流空化数的提高；阻塞引起的旋流空腔直径变化对通气状态产生明显影响。

When the pressure is low, the role of Poppet head pressure sufficient to overcome the pressure regulator spring force, Poppet Head is closed at this time there is no pressure on the oil through the damping holes on the balance of the piston movement, so a balance piston, the next two cavity pressure equal, balanced piston under the action of the spring force gently on the top of the seat, pressure port and overflow port unreasonable.

当压力较低时，作用在提动头上的压力不足以克服调压弹簧力，提动头处于关闭状态，此时没有压力油通过平衡活塞上的阻尼孔流动，故平衡活塞上、下两腔压力相等，平衡活塞在弹簧力的作用下轻轻地顶在阀座上，压力口和溢流口不通。

When the loop there are two or more hydraulic cylinders, and one of which require much less work pressure, while others still need high-pressure hydraulic cylinder operation, you have to use pressure reducing valve to provide a system pressure less than the the pressure to low pressure cylinder.

当回路内有两个以上液压缸，且其中之一需要较低的工作压力，同时其他的液压缸仍需高压运作时，就得用减压阀提供一个比系统压力低的压力给低压缸。

The calculation and experiment results show that the maximum lifting pressure performance decreases with the increase in throat diameter of channel of variable section, water flux of low pressure and pressure ratio of steam nozzle, and has its minimum value with water nozzle annular space. The coefficient of maximum lifting pressure performance may be as high as 26. In the design of steam injector, the larger pressure ratio of steam nozzle and the smaller water nozzle annular space are selected, the higher lifting pressure performance could be obtained.

计算及研究表明：极限升压能力随变截面混合腔喉部直径、被升压的低压水流量和蒸汽喷嘴压比增加而降低，随环形水喷嘴间隙的变化出现了最小值；计算得出变截面超音速汽液两相流装置的极限升压能力可达26；在设计升压装置时应尽可能选取较大的蒸汽喷嘴压比和较小的环形水喷嘴间隙。

Two hundred 16-day-old of age commercial broiler chickens were randomly divided into 4 groups as follows: 50 birds were exposed to normal temperature (20℃) and peritoneally injected with normal saline as control group; 50 birds were exposed to low temperature (7-9℃) and peritoneally injected normal saline as low temperature group; 50 birds were exposed to low temperature and peritoneally injected with low dose BQ123 as low temperature low dose BQ123 group; 50 birds were exposed to low temperature and peritoneally injected high dose BQ123 as low temperature high dose BQ123 group.

本试验采用高选择性ETA受体拮抗剂BQ123预处理低温肉鸡，探讨ET在低温诱发AS模型的肺血管重塑和肺动脉高压发生发展中的作用。200只16日龄AA肉鸡随机均分为4组：常温(20℃)对照组、低温(7～9℃)对照组、低温低剂量BQ123组和低温高剂量BQ123组。23日龄、30日龄时进行肺动脉压的测定，肺组织取材、石蜡切片，Weigert间苯二酚复红染色。

The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.

在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。

In the days of sailing vessels the crew were afraid they would be becalmed on the ocean.

在使用帆船的时代，船员们担心他们会因为无风而无法在海洋上航行。

As long as foreign donors pay the PA's salary bill, few expect a new intifada.

只要外国继续为巴权力机构的薪水买单，希望发动新暴动的人便寥寥无几。