查询词典 loss of weight

HD-M6 multi-functional 2 persons far-infrared weight loss slimming Machine combine main and collateral channels and acupuncture therapy,with modern computer technology,Control electric pulse by the procedure,simulate acupunture massage acupunture point,can make human's body organ relating physiological reaction,adjust bio computer and metabolism,increase human body's lactate dehydrogrnase,adjust human body's incretion,improve human body's metabolism, slow down the speed of glucose transformed into fat,especially,to paly the important part to fat metabolism,can hydrolyze most 3 sour and sweet axunge,and make its leave fat cell,through a series of special decomposition approach, 3 sour and sweet axunge will be transfromed into energy Co2 and water being consumed,that fat cell volume will be small,that effect in weight loss and tightening skin

HD-M6多功能双人远红外减肥美体仪结合了中医的经络学和针灸理疗学，应用现代电脑技术，通过程序控制电子脉冲，模拟针灸按摩穴位，让人体相关的器脏产生相应的生理反应，有效调解生物电脑和新陈代谢，增加人体内乳酸脱氢酶活力，彻底调整人体内分泌，改善人体新陈代谢，减缓葡萄糖转化成脂肪的速度，特别是对脂肪代谢的分解发挥作用，可使原有脂肪中绝大部分的三酸甘油脂水解成脂肪酸和甘油，并使之离开脂肪细胞，通过一系列特殊分解途径，最好转化为能量二氧化碳和水被消耗。

Weight loss pills are some kind of appetite suppressant that works well with a good weight loss diet and weight loss exercises.

减肥丸是某种减肥药工程，并有良好的减肥饮食与体重演习中丧失。

The hydrolytic degradation research results showed that the PDLLA molecular weight was first degraded, then the weight loss happened in normal saline, and the water soluble crystallizable oligomers were formed during the process of degradation. The thermal degradation research results showed that the thermal degradation of PDLLA is a random breaking process, the molecular weight was degraded at range of 100癈~250癈, only above 250癈, the weight loss was found.

通过研究PDLLA的生理盐水降解性能和热降解性能，发现PDLLA在生理盐水中首先发生分子量降解，然后产生重量损失，且降解过程中生成具有晶体结构特征降解产物；PDLLA的热降解是一个无规的断裂过程，在100℃～250℃范围内，PDLLA的分子量迅速发生降解，在250℃以上，低聚物相继发生裂解，产生重量损失。

The energy loss through feces was 0.077C (C: food consumption, KJ/d) and the energy loss through excretion was 0.052C at maximum feeding rate. In that the ratios of F and U to C were low in fish energy budget equation (Cui et al., 1997), the energy loss through feces at optimum feeding rate could be estimated by 0.077C〓(C〓: the optimum feeding rate) and the energy loss through excretion at optimum feeding rate could be estimated by 0.052C〓. The relationship between total energy content for immature gibel carp and body weight was lnE=1. 476+1. 127lnW.

最大摄食率条件下，异育银鲫排粪能损失：F=0.077C，排泄能损失：U=0.052C；由于排粪能及排泄能在能量收支方程中所占比例不大（崔奕波等，1997），最适摄食率条件下的排粪能损失可估计为F〓=0.077C〓（C〓：最适摄食能，KJ/d），排泄能损失可估计为U〓=0.052C〓；性未成熟异育银鲫的能量含量与体重的关系为：lnE=1.476+1.127lnW

The support of TPN at least for 7 days in gastric cancer patients with significant weight loss and severe malnutrition going to receiving operation maintained the nutritional status and prevented continuous weight loss. The early enteral feeding through jejunostomy tended to increase serum hemoglobin, hematocrit, and iron levels to prevent deterioration from anemia. Additionally, nutritional support gradually improved the immune function of gastric cancer patients by increasing total lymphocyte counts.

对於准备要接受胃癌手术体重明显减轻的严重营养不良病患，给予七天以上的全静脉营养支持，可维持病患之营养状况且避免体重持续减轻；术后透过空肠造口给予早期肠道营养支持，对於血清中的血色素与血比容和铁质有助上升趋势，避免贫血情况恶化；由总淋巴球数的增加发现营养支持可以渐渐恢复病患之免疫功能。

The results show that antioxidation property of the modified phosphatic coating after oxidized for 30h at 700℃ is superior, weight loss percent of coating sample is only 1.76％. After thermal shock, i.e. for 3 min at 900℃ for 2 min at room temperature circulating about 30 times, for 3 min at 1100℃ for 2 min at room temperature circulating about 10 times, weight loss percent of coating sample is up to 1.97％, and coating don't slough off.

结果表明：在700 ℃氧化30 h后，改性磷酸盐涂料的防氧化性能优异，涂层试样的氧化失重率仅为1.76％，经过900 ℃、3 min 室温、2 min循环30次和1100 ℃、3 min 室温、2 min 循环10次连续热震后，涂层试样的失重率为1.97%。

The ECA Stack is a component found in thermogenic weight loss pills, composed of ephedrine, caffeine and aspirin working to speed up the metabolism and thus cause calories to burn faster and result in weight loss.

非洲发现的一个组成部分，是栈热减肥丸组成麻黄素咖啡因和阿斯匹林工作，加快代谢，从而导致更快地燃烧热量造成体重损失。

Firstly the oxidation loss was controlled by the reaction between the coated C/C composites and oxygen. Secondly the oxidation loss was controlled by the producing and vaporing rate of the glass. The oxidation loss was lined with the oxidation time. Thirdly there were cracks in the coating and the deep of the coating was oxidated. The weight loss rate increased linearly and the matrix had been oxidated partly in the end.

氧化初期，涂层的表面开始氧化，氧化失重是一个受氧气和涂层的化学反应控制，表现为氧化增重；氧化中期，氧化失重受玻璃质的形成速度和蒸发速度控制，表现为缓慢的氧化失重，氧化失重与时间的关系为直线型；随后，涂层上出现裂纹的形成和愈合过程，涂层深层被氧化，表现为较快的氧化失重；最后，涂层被局部破坏，基体被部分氧化，氧化失重直线上升。

The results indicate the mutual effect exists between the single coals, which could increase the maximum of thermal weight loss obviously and has a small effect on the temperature extent of the weight loss. The main pyrolysis production of coal is coke, but the main production of waste plastics is tar; the yield of water became decrease and the gas became increase by adding the waste plastics. And the CRI and CSR decreased with the ratio of waste plastics in coal. The main ingredients of tar from blend coal are aromatic hydrocarbon and alkane, while those of waste plastics are alkane and alkene. The result of co-coking with coal and waste plastics make the light tar and the aromatic hydrocarbon increase obviously. The combustible ingredient(CO、H2、CH4) of gas from co-coking with coal increase at different ratio; Co-coking with coal and waste plastics could increase the combustible ingredient and thermal value of gas.

结果表明，废塑料与煤混合物在煤的塑性温度区间内存在明显的相互作用，使最大热解失重峰迁移，热解速率变大，且随着废塑料配比的增加呈现规律性的变化；煤热解产物固体焦炭为主，而废塑料的热解产物以焦油为主，废塑料的添加使得总体焦炭和水产率下降，焦炉煤气和焦油的产率增加，即共焦化呈现出明显的&增油减水&效应；随着塑料添加量的增加，焦炭热强度呈现劣化趋势；废塑料代替瘦煤配煤炼焦可使其比例提高到3%而不影响焦炭的质量；纯煤焦化所得焦油以芳香烃类和烷烃类为主，而废塑料热解焦油以烷烃和烯烃为主；废塑料配煤炼焦，可使得的焦油呈现&环构化&和&轻质化&趋势；废塑料的添加可使煤气中的可燃组分(CO、H2、CH4)的含量均有不同程度的增加；废塑料配煤炼焦可以优化焦炉煤气的组成，增加煤气中的可燃组分，提高焦炉煤气的热值。

High strength: Aluminum-magnesium-silicon alloy wire possesses high strength, its min value of tensile strength is 170% of the value of general hard and round aluminum wire(H8), is a fine armored material;②Low loss:as a non-magnetism material, no eddy current loss will happened on aluminum-magnesium-silicon alloy wire; when under 20℃, itsunit resistance corresponding to 52.3~53.0%IACS (international annealed copper wire standard), so that, the heat loss caused by induced current is very low;③Light weight: the density of aluminum-magnesium-silicon is only 2.7g/cm3 it largely reduced the total weight of armored cable.

该电缆突出的优点是：①高强度：铝-镁-硅合金丝具有较高的强度，其抗拉强度的最小值都是普通硬圆铝线（H8）抗拉强度的170%，是一种较好的铠装材料；②损耗小：铝-镁-硅合金丝为非磁性材料，不存在涡流损耗；其在20℃时的电阻率相52.5~53.0%IACS，因此由感应电流产生的热损耗很小；③重量轻：铝-镁-硅合金丝的密度仅为2.7g/cm3，明显降低了铠装电缆的整体重量。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐