查询词典 loadings

When a structure is excited by external loadings or ground accelerations, the structural sidesway can be detected by the device, and control forces are provided or released if pre-defined conditions are fulfilled.

此机构侦测结构物於受外载重或地表加速度所引起之楼层振动位移，当某些预设之条件满足时，此机构即提供控制力於结构物。

A series of SiW_(12)/AC catalysts with different silicotungstic acid loadings supported on acti- vated carbon which was treated with 10% HNO_3 solution were prepared by an impregnation method and the catalytic performance of SiW_(12)/AC for the synthesis of trioxane were investigated.

以10%硝酸溶液处理过的活性炭为载体，采用不同质量分数的硅钨酸SiW_(12溶液为浸渍液，制备了不同负载量的SiW_(12)/AC催化剂，考察了催化剂在合成三聚甲醛中的催化性能，并用XRD、FT-IR、NH_3- TPD、BET、TG-DSC等手段对SiW_(12)/AC催化剂晶粒大小、催化剂表面的酸量及酸强度、比表面积及热稳定性等微观特性进行了表征。

This study performed the three-dimensional nonlinear finite element analyses using a general purpose finite element program ABAQUS to simulate the structural behaviors of two full-scale H-beam to box-column subassemblage specimens in fire test. In the experimental program of this study, the two specimens were tested at elevated temperatures in the furnace and under the specified constant loadings, and the moment connections of the two specimens were made of fire-resistant steel and normal steel respectively for comparison.

本研究针对两支实尺寸H型梁-箱形柱接合之耐火钢与普通钢弯矩接头试体受定载加温的火害行为进行ABAQUS有限元素数值模拟，所得之数值结果分别与两支试体在大型高温炉中所进行的火害试验结果比对，以验证有限元素数值模型之正确性。

The agitation power consumptions in boiling systems decrease uniformly with the increase of agitation speed, whereas the relative power demand (RPD-the ratio of agitation power input of HEDT for gassed system to that for ungassed system and under the same agitation speed) can maintain at a high level for high gas loadings even when the impeller is operating with a high impeller tip speed. The gas hold-up in the boiling system is much lower than that in the cold gassed system, and the gas hold-up in boiling system increases at first and then decreases with the increase of the agitation power consumption per liquid mass P(subscript m. It implies that the boiling three-phase system has a maximum gas hold-up point. The changes of nucleation site of vapour bubble and the character of suspension of the solid particles with the rotational speed of the impeller are responsible for those behaviors mentioned.

在沸腾条件下，搅拌功率消耗随着搅拌转速的增加有所下降，但HEDT桨具有较高的载气能力，即使在高叶端线速度下，相对功率消耗仍能保持在较高的水平；沸腾体系的气含率随单位质量流体输入功率的增加表现出先增后减的规律，即存在气含率的极大值，蒸汽成核位置和固体颗粒悬浮特性随搅拌功率增加而改变是造成上述行为的主要原因；沸腾体系中的气含率远远低于常温通空气体系。

Its subject coverage includes: composites from a wide range of matrix alloys, particulate sizes, and loadings; and wear processes also over a full range, including sliding, abrasion, erosion, and impact, etc., in both lubricated and unlubricated conditions.

它的主题涉及的范围包括：各类基合金合成物、颗粒大小与装入；全面的磨损过程，包括在润滑与无润滑条件下的滑动、磨擦、侵蚀与冲击。

Modest nip loadings in the 80 to 280 kN/m range are applied to these nips.

中度加载在80至280千牛/米范围内适用于这些压区。

When complete a deep and ultra-deep well casing program, especially a gas well, strength design, thread sealing design and anticorrosion design are needed to introduce. Meanwhile, many factors including external loadings, casing strength models selection, plastic rock creep stress, intermediate casing wear, temperature effect, thread air tight ability are necessarily considered.

认为对于深井超深井套管，尤其是气井必须引入强度设计、密封设计、防腐蚀设计，需要从外载的计算、强度模型的选择、塑性岩石蠕动引起的载荷、技术套管磨损、温度效应、螺纹的密封性以及套管本身强度的选择等方面进行研究。

The stress intensity factors of surface crack with various inclined angle subjected to normal and shear contact loadings are obtained.

文中算例分析了不同倾角的表面裂纹在法向和切向接触载荷作用下，裂纹尖端的应力强度因子。

It uses a base wage and up to six additional wage loadings to determine the wage structure.

它使用的基地，工资和多达6个额外的工资荷载，以确定工资结构。

It uses a base wage and up to six additional wage loadings to determine the wage structure.

它是用基本工资和多达六个额外工资荷载，以确定工资结构。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。