查询词典 load

According to heat load source of die cavity, temperature distribution gradient equations and heat flux equations and the peak value equations of temperature load at die cavity surface have been obtained with research of temperature distribution and transfer laws of die surface by unsteady heat transfer theory.

新闻摘要：根据锻模型腔热负荷来源，通过非稳态传热理论，分析研究了模具工作表面层的温度分布与传递规律，给出了型腔表面温度分布梯度和热流密度公式，并给出了锻模型腔表面的温度负荷峰值的计算公式。

Comparing with the existing load balance in any point, analyzing the advantage and disadvantage of many tactics,In accordance with the effect and run environment of this CDN system, we have chose a a suitable local load balance tactic----HTTP redirector.

通过对现有的各种负载均衡技术的横、纵向对比，通过分析比较各种策略的优劣，以及结合本系统的用途及其所在的环境，提出了一种合适的局部负载均衡策略——HTTP重定向。

Based on the ultimate equilibrium theory, the ultimate cross-section bearing capacity formula of the column under axial-load was given. Moreover, the main influencing factors on increasing the axial-load bearing capacity were analyzed to determine the relationships between the stress of different components and hoop confining index.

采用极限平衡理论建立组合柱截面的力学方程，确定了短柱轴压承载力计算方法；并进一步分析了提高组合柱轴心抗压承载力的主要影响因素，确定了极限状态下各部分应力值与套箍指标之间的关系。

In order to make solutions for system stable influence of the three phase unbalance current by the increasing of unbalance load, the unbalance load integrated theory is described and the balance compensation algorithm based on STATCOM and SVC has been adopted.

随着不对称大负荷增加，三相不平衡电流对系统的稳定性影响也日益严重。

Final, some problems about axial compression member under impact load are studied, which focus on the form of impact load, damage of material, local dynamic buckling of plate. Some calculation method and research viewpoints are presented.

最后，就冲击荷载作用下轴心受压构件的若干问题进行了研究，重点集中在冲击荷载形式、材料损伤、板件局部动力屈曲三个方面，给出了一些相关计算方法和研究思路。

In order to function as a single compression member, the C-sections should be connected at a close enough spacing to prevent buckling of individual C-sections about their own axes parallel to the web at a load equal to or smaller than the buckling load of the entire section. For this reason, Sec.

为了起到单个抗压构件的作用，两段U型钢要贴得足够紧，以避免各段U型钢对平行于筋的自身轴的纵向弯曲——它是自身轴的荷载等于或小于整个断面的临界纵向荷载而造成的。

The concrete dam displacement is studied considering the factors such as foundation modulus increasing with depth, seepage coefficient reducing as depth, seepage coefficient anisotropic, curtain and drainage in the dam heel and seepage field and stress field coupling. Some conclusions are obtained: if the foundation is considered only with the seepage volume load, the dam top horizontal displacement of the reference base point develops upstream. When the foundation size increases, the reference base point's horizontal displacement increases. However, the value measured by the reversed pendulum anchored to the rock foundation is often regarded to be absolute displacement. The above practice is estimated to be limited when the water load on the dam foundation is taken into account.

分析了地基变形模量随深度逐渐增加、渗透系数随深度逐渐减小、坝基渗透系数各向异性、坝踵设置帷幕排水，以及考虑渗流场和应力场耦合等对混凝土坝位移分量的影响，得出如下结论：作用在地基上的水荷载，使混凝土坝坝顶相对参考基点（倒垂锚固点或坝踵正下方1倍坝高处）的水平位移指向上游，而参考基点的水平位移随地基截取范围的增大而增大，由于大坝工程上常将倒垂线锚固在岩基深处，并认为该倒垂线测值为绝对位移。

The utility model has the advantages of novel structure, fixing the load transducer on the glide cushion block of the hydraulic rope adjusting device of the wire rope of the elevator, directly reflecting the actual load of wire rope and ensuring the authenticity, reliability and stability of the signal of the transducer.

优点在于：结构新颖，将载荷传感器固定在提升机钢丝绳液压调绳装置的滑动垫块上，能直接反映钢丝绳的实际载荷，保证了传感器信号的真实性及其工作的稳定性和可靠性。

The effect of pole-arc coefficient、 air-gap、 damper winding and magnet circuit saturation for no-load property of harmonic winding by it . So, in this article, we bring forward a new idea and method to analyze no-load property of harmonic winding of synchronous generator by third harmonic excitation.

根据三段法，分析了极弧系数、气隙、阻尼绕组和磁路饱和等因素对谐波空载特性的影响，为分析谐波励磁同步发电机谐波绕组空载特性提供了一种新的思路和分析方法。

With reference to the indoor test, in order to obtain the breakage of bridge deck overlay under the car"s breaking, it take the worst load condition as the test object, and then impose dynamic repeated load to different loading types of bonding layer, gather the strain information of the specimen"s different location.

在室内试验方面，以桥面铺装在荷载作用下的层间破坏为出发点，模拟汽车刹车情况，采用桥面铺装最不利受力情况为试验对象，针对铺装层结构的不同受力工况进行动态重复加载，采集应变响应。

Nowadays, most of research are to build a transmutative Petri Nets through adding controlling place sets, controlling arc sets and controlling policy to the basic Petri Nets, while the Controlled Petri Nets could be used to argue many controlling theory problems conveniently and to induce many logically and physically supervisory and solve the Event Feedback Controlling Problems and State Feedback Controlling Problem in DEDS supervisory theory.

目前大多数的研究表现为在变形后的受控Petri网基础上，利用各种方法求得各种逻辑型、结构型控制器，解决DEDS监控理论中的事件反馈控制问题与状态反馈控制问题。

On one hand, there are discussions with the works council and union about extension of short time working up to the end of September.

一方面，有讨论，工程理事会和联盟关于延长工作时间短至9月底。