查询词典 load

The shipper would need to either floor load it evenly across side to side and front to back by not stacking high or , load it in then block and brace .

该托运人需要将货物平均装载在地板上，使每块地方平均受力(货柜的侧面连着另一个的侧面，前面连着另一个的后面)，不能堆积太高，装载时用石块和柱子支撑。

In accordance with axle load and speed and average deceleration on the basis of stopping brake energy and average axle braking power,it is calculated and compared braking heat load of different railway cars.

文中根据轴重、速度和紧急制动能力，对不同客货车辆的制动热负荷从停车制动能量和平均轴制动功率两方面进行了计算比较。

Aiming at this problem, firstly, calculation formulae of utilization adhesion coefficient after installment of retarder were detailedly deduced. Then braking force distribution ratio , braking intensity and vehicle full-load parameters were taken as variables and inequalities which are about of retarder braking force , braking force distribution ratio , braking intensity and vehicle full-load parameters were established based on the ECE Law. The range of corresponding to any , as well as the most optimal matching between them, were obtained by solving these inequalities.

为此，论文在推导了安装缓速器后前、后轴利用附着系数、的计算公式基础上，基于ECE法规要求，以制动力分配比、制动强度及车辆满载参数为变量，建立了缓速器制动力关于车辆制动力分配比、制动强度和满载参数之间的多元不等式组，通过求解多元不等式组获得缓速器制动力与制动力分配比之间的取值关系，并从中得到二者之间的最优匹配。

DETERMINATION OF BREAKING LOAD AND KNOT BREAKING LOAD OF NETTING YARNS.

鱼网用线的断裂强度和打结处的断裂强度的测定方法

Depending on the class society there are differentsafety factors between SWL Proof load and Breaking load points.

定现有的绑扎件的破断负荷是在同一水平上的所得到的安全工作负荷也是不同的。

Determination of the breaking load and elongation at the breaking load.

断裂强度和断裂伸长率的测定

For sizes 30 thru 175 metric tons,breaking load is 5.4 times the working load limit.

注释：最大验证负荷为2倍工作极限 30t-175t破断负荷为5 4倍工作极限负荷；。

Note: 1. Except for basic load, we also produce JF35 series tie downs with breaking load of 2000kg.

注：1。除基本型负荷外，还生产破断负荷2000kg的JF35系列捆绑带。

Breaking Load—Load which causes fracture in a tensile, compression, flexure or Torsion

断裂负荷—在拉伸、压缩、弯曲或扭转试验中引起断裂的力。

Limit;for alloy steel hooks(S-320A)30t-60t:breaking load is 5 times the working load limit.

30t-60t安全系数为4倍工作负荷。

Through comparing with the results by simulation to study the effects of theprojectile"s final velocity, the angle of rotation and the ballistic trajectory"s migration withdifferent projectile"s rotating speeds, different target"s moving speeds and differentpenetration angles.

通过比较数值模拟的结果来研究不同弹头转速、目标速度、侵彻角对侵彻过程中弹头最终速度、翻转角度和弹道偏移的影响。

I love stationery and all the accoutrement of writing.

我爱文具以及所有的书写的工具装备。