查询词典 load

In the paper, the common expression of the non-uniform load shareing factor was deduced, and a function parameter--forc-arm factor and the concept of ideal centre position were presented and their solutions were given, which makes it possible that the dimensions and the capability of load equilibrium of the mechanism could be determined. The criteria of optimum load balancing mechanisms selection were set up with consideration of the effects of frictions and turning pair clearances.

本文通过对平面连杆式均载机构的功能指标—载荷不均匀系数的推导和分析，提出了力臂系数、理想中心位置这样一些能反映均载机构功能与运动结构关系的参数与概念，并给出其求解方法，它们还可以用来确定平面连杆式均载机构各构件的最佳长度尺寸。

In a cellular mobile network, whether a user can be served by a particular base station depends on the distance of the user and the base station. If we can make balance between the load of high-load base station and low-load base station in a block, then the base station can allow more users to get into and provide service.

在蜂巢式网路架构中，基地台的负载量是不相同的，如果能让高负载的基地台和低负载的基地台做负载平衡，基地台将能容纳更多的使用者，提供更多的服务。

Through model test,it analyzes damage mode of adding batten plate under vertical load,strain relation of load with flexibility、load with steel bar and carbon cloth are given,it obtains dangerous section of span beam when researched damage mechanism,which make structure can reach prospective effect.

通过模型试验，对附加缀板式这种新型结构加固后在竖向荷载作用的破坏形式进行了分析，给出了荷载与挠度、荷载与钢筋及碳纤维应变的关系，并对结构破坏机理进行了研究，得出各跨梁的危险截面，使该结构达到了预期的加固效果。

In this thesis, the influence of column force, joint hoop reinforcement, and repeat load on the stress and sheer bearing capability of inclined pressure bar is analyzed utilizing finite element software. In the case study, the column axial force's influence on the inclined pressure bar's equivalent width, stress and sheer bearing capability of RCFEN is obtained by changing the column force when modeling the RCFEN with ANSYS. In the former model, the joint hoop reinforcement influence on the equivalent width inclined pressure bar and the strength of RCFEN is achieved by changing the quantity of joint hoop reinforcement; the inclined pressure bar's equivalent width and the strength variation of RCFEN under cyclic load are gained by applying low frequency cyclic load on the inflection point of column and the middle of beam.

针对上述算例中的框架外节点采用ANSYS进行建模，运用有限元软件分析了柱轴力、节点箍筋、反复荷载对外节点斜压杆承载力、抗剪承载力的影响：改变柱轴力，研究了柱轴力对斜压杆的等效宽度、框架外节点斜压杆承载力、框架外节点斜压杆抗剪承载力的影响；在上述模型中，改变节点箍筋的数量，分析了节点箍筋对斜压杆的等效宽度、框架外节点强度的影响；在上述模型中，在柱反弯点和梁中点均进行低周反复加载，讨论了在反复荷载作用下，框架外节点的斜压杆的等效宽度、框架外节点强度的变化情况。

In order to improve the tower crane working efficiency, windlass mechanism has a set of gear change mechanism, are devided into high speed,mid speed and low speed, the gear change mechanism gained three speed through connecting 2 DLM5-40A and 1 DLM5-63A brake, control 3 brake by LHK switch,when it with the function of low-speed heavy-load, get through the model DLM5-63A brake; when it with the function of mid-speed mid-load and high-speed light-load, get through the model two DLM4-40A brake, and the operator can choice the good position as the weight of the goods, when change the speed, must be cut off the motor, 26 FUSAN CONSTRUCTION MACHINERY CO.,LTD PDF 文件使用"pdfFactory Pro"试用版本创建 www.fineprint.cn FUSHAN TOWER CRANE OPERATINGINSTRUCTIONS-QTZ125G(FS6016) no change speed when driving it.

为了提高塔机的工作效率，卷扬机构设有一套变速装置，分重，中，轻三档，变档装置是通过分别接通两个 DLM5-40A 和一个 DLM5-63A 电磁离合器来获得三种速度。用转换开关 LHK 控制三个电磁离合器，重载低速时，接通 DLM5-63A 电磁离合器，中载中速和轻载高速时，分别接通其余两个 DLM5-40A 电磁离合器，司机可根据物品的重量选择合适的档位，换档时，必须使电机断电，不允许在电机运行过程中换档。

Experiment Study on the Long-Term Stability of Bearing Load Cell in large turbine-generator sets;2. Study on the Assembly Shearing Bridge Load Cell for Two Pad Tilting Pad Bearing;3. D FEM analysis of a load cell with on 2 pad tilting pad bridge bearing in large turbine generator sets has been made.

本文对大型汽轮发电机组剪切桥式两可倾瓦轴承负荷传感器结构进行了二维有限元分析，研究了不同边界条件对传感器结构应力场的影响，计算与试验结果对比表明：所建立的有限元模型基本是正确的，可将其用于两可心倾瓦轴承负荷传感器结构设计。

Trundle type chain link conveyer is on the load bearing chain link, between each adds on a high load bearing roller appendix to come the load bearing cargo again.

是在承载链条上，每节之间再加上一较高的承载滚子附件来承载货物。

Draft gear is used to reduce the bump between the vehicles when the train runs or shunts, whose form of load is mainly impact load, and as for viscoelastic material such as the rubber, whose stress is not only relate to strain but also relate to the time, so under the action of impact load, the viscoelastic material's capabilities is very different from the common elastic material.

由于缓冲器是用于缓和列车运行及调车作业时车辆之间的冲撞，其所受载荷形式主要是冲击载荷，而对于橡胶这种粘弹性材料来说，由于其应力不仅是应变的函数，还是时间历程的函数，所以在受冲击载荷作用下的特性和普通的弹性材料的特性有很大的不同。

At last, the fundamental viscoelastic parameters are calculated according to the data of the electrostatic experiment and a three-element solid inversion model. Draft gear is used to reduce the bump between the vehicles when the train runs or shunts, whose form of load is mainly impact load, and as for viscoelastic material such as the rubber, whose stress is not only relate to strain but also relate to the time, so under the action of impact load, the viscoelastic material's capabilities is very different from the common elastic material.

由于缓冲器是用于缓和列车运行及调车作业时车辆之间的冲撞，其所受载荷形式主要是冲击载荷，而对于橡胶这种粘弹性材料来说，由于其应力不仅是应变的函数，还是时间历程的函数，所以在受冲击载荷作用下的特性和普通的弹性材料的特性有很大的不同。

Finite-element analysis of quadrangular drill tower under wind load ;2. Curvature variation rule of cable and membrane structures subject to the wind load ;3. Then the wire strands and catway of Zhoushan Xihoumen bridge applied wind load in main cable construction are studied.

探讨了西堠门大桥主缆架设期间不同工况中索股在各级风载下的横向变形规律，结合猫道在不同级风载作用下的横向变形，通过索股和猫道相对横向变形量确定出猫道上可供主缆架设施工的风速。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。