查询词典 load-on

Stress distribution at cross section of transverse uniformly distributed load and non-uniformly distributed load applied to concrete cylinder by finite element method is analyzed.

采用有限元的方法计算分析了混凝土圆柱体在受横向均匀线荷载和非均匀线荷载时其横截面上的应力状况。

Torsion would be produced when curve beam under self-weight load, and, torsion and radial force would be produced when structure under prestress load. Such forces would brought prominent side reactions.

在施工阶段和运营阶段，就曾发生过梁体侧向倾覆、支座脱空，墩柱开裂、梁体体侧移以及腹板侧向崩裂等曲线梁结构侧向效应病害，这是技术人员对曲线桥特性把握不够造成的。

Tension Control of the book's introduction, from the tension control Uncoiler principle, characteristics, classification, function and implementation are described; vector transformation from the basic principles of control, inverter control technology boards T400 model and outlines the aspects of how to control the tension the problem; In addition to the tension control roller load balancing and analysis were summarized, the principle of load balancing, sorting and implementation.

有关开卷机张力控制的介绍，从开卷机张力控制的原理、特点、分类、作用及实现进行了阐述；从矢量变换控制的基本原理、变频器的控制模式及T400工艺板方面概括了张力如何控制的问题；另外对张力辊的负荷平衡控制进行了总结和分析，有关负荷平衡的原理、分类和实现。

The variable load operating mode of the rotary table and swivel was transformed equivalently into stable load operating mode, and the equations for calculating the equivalent weig...

即将转盘和水龙头主轴承由变载荷工况向稳定载荷工况作等效转换，从而导出等效当量动载荷Pm 的计算式及主轴承寿命估算公式，并以 40 0 0m深井钻机水龙头主轴承为例，进行了疲劳寿命的估算

Through analysis to the pumping unit's load characteristic, the relationship between the position of the suspension point load's peak value and the oil well's parameters has been obtained and a new method about the transforming of the pumping unit with downward beam balance weight is proposed.

分析常规游梁式抽油机的载荷特性，得出悬点载荷的峰值出现的位置与井况参数的关系，提出一种下偏杠铃抽油机改造方法，依据油井抽汲参数调节下偏杠铃的角度，使其最大力臂与悬点最大载荷对应，提高抽油机的平衡效果。

The strain of sheet mainly occurs in loading end in the initial load. With the increase of load, the strain extends to the remote end; the bond stress gradually reduces from the loading end to the remote end; the peak bond stress locates slightly away from the loading end. For 16.3% moisture content, the effective bond length between BFRP and wood is 100 mm.

结果表明，加载初期，纤维布上的应变主要存在于加载端附近，当荷载逐渐增加时，应变也向加载远端增大；随着与加载点距离的增加，粘结应力逐渐降低；随着荷载的增加，粘结应力峰值位置向远离加载点方向稍有移动；在含水率为16.3%条件下，BFRP与木材的有效粘结长度为100mm。

The system uses PID controller and fuzzy controller to design automatic control loops, a study of fuzzy three-element feed-water control system for a CFB municipal waste incinerator is introduced. The incinerator is faced with problems such as large-scale fluctuation of furnace heat load and low regulation resolution of main control feed-water valve. The fuzzy logic control system is applied to modulate PI control parameters according to steam drum water level to fit fluctuated heat load, the inner and outer control loops are realized in an asynchronous way to effectively decrease regulation time and improve regulation precision.

针对垃圾炉炉膛负荷波动较大，同时给水调节阀门执行机构的调节精度较低的现状，在传统三冲量串级汽包水位控制方式的基础上，采用模糊控制策略对内、外串级回路的PI控制参数进行分区域调整，强调了PI参数在被控参量处于不同范围时的分离作用，同时内、外控制回路采用异步控制方式，浙江大学硕士学位论文从而有效地减小了被控参量的调节时间，提高调节精度，使水位波动控制在△为士12~范围内。

Integral in the design of three-dimensional structure of the storage shelves, with particular attention to the following two of the most adverse combination of loads: the role of wind load at the time of a state-wide database of no-load power; when the level of seismic action of the whole library full of force.

在设计整体式立体仓库的货架结构时，尤其注意下列两种最不利的荷载的组合：风载起作用时的全库空载状态下的受力；水平地震作用时全库满载下的受力。

Moreover, the author analyzed and researched dynamic load of the needle valve spring by adopting the method of characteristic line and proposed to design the needle valve spring using its dynamic load.

运用特征线法研究和分析针阀弹簧的动力负荷，推导出采用动载法设计针阀弹簧的方法，从而提高设计的稳健性。高压共轨喷油器精度和技术要求高，加工难度大。

It comprises an A.C three-phase asynchronous motor, an electromagnetic slip coupling and controller. It is usually used under a constant torque load and is particularly suitable for the use under the load with a decreasing torque such as the centrifugal pump and blower, etc. featuring evident energy-saving efficiency.

它由Y系列三相交流电动机、电磁转差离合器和控制器组成，电磁调速电动机广泛用于恒转矩负载场合，特殊适宜在递减转矩负载中使用，有较明显节电效果。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。