查询词典 load-on

To adopt finite meta method analyzes stress strain action of Al-plastic compound pipe under Analog load status and studies the influence of load capacity by variation of diameter of medium Al layer and change of joint part length lap joints.

采用有限元方法分析了铝塑复合管在模拟承载状态下的应力应变行为，研究了中间铝层的直径变化以及搭接接头搭接部分长度的变化对承载行为的影响。

As for hydraulic excavator routine three lever power models,pump engine match principles and realization methods are expounded,then the characteristics of load sense system are analyzed,and the conflict between load sense control and pump engine match is clarified.

就液压挖掘机中常见的三档功率模式，详细地阐述了泵与发动机的匹配原理及其实现方法，分析了负荷传感系统的特点，阐明了负荷传感控制与泵、发动机匹配相矛盾的实质，提出了在保留泵与发动机匹配时应舍弃负荷传感控制的论点，对于泵与发动机匹配时的液压回路进行了较深的探讨，提出了由计算机依据泵与发动机匹配的原则，通过主阀自动调节和分配各执行器流量和功率的新的学术思想，推导了相关的公式。

Erection parameters in the literature [9] nonlinear analysis method used to calculate some of the variables erection capacity limit, but no major erection of some other variables, such as the level of the top-Ligan excess of the limit load length the impact of, and the top model Ligan more displacement constraints, and the actual situation of access to a certain extent; literature [7] space will be just as Falsework framework erection of the main parameters of the critical load, and The literature [10] scaffold for the ultimate strength estimation method for calculating the results of the amendment.

在搭设参数方面，文献[9]采用非线性分析方法，计算了部分搭设变量下的极限承载力，但是没有分析另外一些主要搭设变量如立杆超出顶层水平杆长度对极限承载力的影响，而且计算模型的顶部立杆位移约束较多，和实际情况有一定的出入；文献[7]将模板支架视为空间刚框架，分析了主要搭设参数下的临界荷载，并采用文献[10]提出的用于外脚手架极限承载力的估算方法对计算结果进行了修正。

The cracking load , ultimate load and failure process of masonries are analyzed , which in contrast with the normal cement mortar .

进行了粉煤灰砌筑干粉砌体的抗压性能试验研究，分析了砌体的开裂荷载，极限荷载及其破坏过程，并与普通水泥砂浆砌体进行了对比。

The mid-span deflection relative to a straight reference line joining the points of support shall be measured for each value of the load and 5 minutes after removal of the load.

中期跨度挠度相对直参考线连接点的支持，应衡量每个价值负荷， 5分钟后移除负载。

With this in mind, the researchers then reanalysed data from knowingly HIV-positive heterosexual subjects in Uganda and Zambia who had HIV-negative sexual partners. Those with a viral load of one million particles per millilitre were more than ten times more likely to accidentally infect their partners each year than those with a load of one thousand.But when the researchers calculated the transmission potential over the entire predicted asymptomatic period, those with viral loads between ten thousand and a hundred thousand copies per millilitre of blood were the most likely to infect their partners. HIV-positive subjects with viral counts of 50,000 infected roughly twice as many people as those with counts of one million.

伦敦帝国学院流行病学家Christophe Fraser和他的同事对收集于1982年到1993年之间的100多例HIV阳性的男性同性恋者的数据进行分析，并结合分析来自乌干达和赞比亚的已知有HIV阴性性伴侣的HIV阳性异性恋受调查者的资料，他们发现中度病毒负荷而无症状的HIV携带者更易播散HIV，这是因为中度病毒负荷的HIV携带者的无症状期较长，而那些高病毒负荷而无症状的HIV携带者虽然传染性稍强，但其传染的持续时间却很短，并且在未经治疗的HIV携带者个体中中度病毒负荷是最常见的人群。

Stack with step-lapped mitred joints,the fulx distribution at joint area is considerably improved,so effectively reduce the no-load loss,the no-load current and noise,bring benefits to the users/the environ-ment.

硅钢片采用45O全斜接缝，单片、七步进、纵向阶梯叠铁方式。铁芯的截面为多级圆形，应用我公司的新型钢拉带与钢拉板两项专利技术，铁轭无需开孔，保证了铁轭中冷轧取向晶粒结构的完好。

With the increase of the electric network scale, the power system analysis personnel attach importance to the load modeling of Wide Area Power System, the single load modeling method can not meet the demand of WAPS modeling.

随着当前电网规模的日益增大，广域电力系统的负荷建模引起了电力系统分析人员的重视，单一的负荷建模方法已无法适应当前广域电网建模的需求。

To achieve the aim of water quality programming in the year of 2010 in the upper Suzhou creek, the CODcr cut amount of 2593 tuns will be deducted per year in runoff load , of which the village and rice field load cut amount per year were larger than others, however, the cut amount of village and town for a grid was high in the upper valley of Suzhou creek, the total cut amount in fish ponds per year was not too high, but the cut amount for grid was high.

但无论在苏州河的上游和中下游，均以村和镇的单位网格削减量为最高，精养鱼塘虽然年削减量不高，但单位网格削减量却较高。

Most of these parameters are relate to distance of tower,arc weight,ice-load,wind-load and admissible pulling force at suspension point.

这些特性参数中的大多数都与杆塔距离、弧重要求、冰荷、风荷和悬挂点的允许拉力有关。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐