查询词典 load-on

One is transverse load, which is perpendicular to middle plane, one is longitudinal load, which acts in middle plane.

当薄板受有一般载荷时，总可以把每一个载荷分解为两个分量，一个是垂直于中面的横向载荷，另一个是作用于中面之内的纵向载荷。

Twin pillow blocks have the same dynamic load rating as the doubles and are a good choice when using only one pillow block per shaft or in applications used to cantilever load or moment.

双人枕头块具有相同的动态负载率为双打是一个很好的选择时，只用一个枕头每块轴或申请使用悬臂式负荷或时刻。

In this thesis, various conventional and ill-conditioned load flow calculation methods have been fully analyzed and evaluated in the aspect of convergence, and the relationship between the convergence and the Jacobian matrix of polar type load flow equation has been discussed and evaluated.

本文对常规潮流算法和常用病态潮流计算方法进行了全面的算法、收敛性分析、评价、比较。

To determine district cooling system design load and optimize their chillers' operation strategy, the variation law and prediction of hourly cooling load in a DCS were studied.

摘 要：为了正确选择区域供冷系统设计负荷并优化其主机运行策略，对某区域供冷系统的逐时实际冷负荷变化规律及数值预测进行研究。

The Predictor Corrector Primary Dual Interior Point Method is used to solve the OPF model. The effectiveness of load shedding is confirmed using the Q-V mode analysis method, which can be applied to compute eigenvalues of a reduced Jacobian matrix. The numerical results of 2 IEEE standard test systems demonstrate that the proposed OPF model is very effective since it automatically identifies the weak buses and circuits and calculates minimum load shedding.

论文采用了预测-校正原对偶内点法求解该模型，并通过Q-V模态分析研究切负荷前后系统降阶雅可比矩阵的特征值变化情况，评估切负荷控制措施的有效性。2个IEEE标准试验系统的仿真结果表明，该模型直接针对系统薄弱环节，自动辩识切负荷节点和最小切负荷量，具有很好的效果。

Constant primary winding current independent of load level is inherent in the proposed system so that power could be transmitted from power source to load in a stable manner.

额定频率下系统一次侧线圈电流保持恒定而与负载大小无关，保证电能由电源向负载的稳定传输。

This thesis DESign steel wire tension control system of Steel Billet Grinding Machine, and establish mathematical model of every component in electro-hydraulic proportional valve control dissymmetry hydraulic cylinder servosystem and the load with large inertia and flexibility system of Grinding Machine. Through the medium of matlab/simulink simulation, this thesis mostly analyses Pre-load impact of steel wire stress. Compare with the emulation result of non-feedback, force feedback, displacement feedback, thereby educe reliable conclusion.

本文设计了钢坯修磨机钢丝绳张力控制系统，并且对电液比例阀控非对称液压缸伺服系统的所有液压元件和修磨机柔性负载系统进行了建模，通过MATLAB／SIMULINK仿真，主要分析了预紧力对钢丝绳受力的影响，而且对开环无反馈、力环反馈、位移反馈的仿真结果进行了比较、得出了可靠的结论。

To a module of single output, its load is rated load.

单路输出的变换器，其输出负载就是其额定负载。

In this case the 225/45R17 91W Standard Load size's rated load capacity of 1,477 lbs.

在这种情况下， 225/45R17 91W标准负荷大小的额定负载能力1477英镑。

When is tested,testing shall be performed with rated load current of firstly, and then with load current of inverter.

在测试时（仅限 Power 测试），的额定负载电流，后带的负载电流。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。