查询词典 load-on

The optical displacement and the MTS load measurement systems are synchronized and thus the relationship between the load and the displacement can be easily established.

光学位移和多边贸易体制的负荷量测系统是同步的，因而关系之间的负荷和位移，可以很容易建立。

The load factor is the ratio of the average load to the generator set power rating.

负荷系数负荷系数指的是机组的平均负荷与额定功率之间的比率。

The results obtained indicate that the load models describe the actual behavior of the load with high accuracy.

所取得的成果表明，该负荷模型描述的实际行为的负载，精度高。

This design first gives the system logical circuit and all load parameter according to the project description, the analysis load trend of development.

本次设计首先根据任务书上所给系统与线路及所有负荷的参数，分析负荷发展趋势。

First acts according to in the project description to give the system logical circuit and all load parameter, the analysis load trend of development.

首先根据任务书上所给系统与线路及所有负荷的参数，分析负荷发展趋势。

The paper studies UFLS with several times accelerating shedding load function, analyzes dynamic frequency characteristic of power system during UFLS, derives the formula which is served as setting rate of frequency change for criterion of accelerating shedding load, and designs the logical diagram expressing UFLS operation.

研究了同时依据频率和频率变化率两个变量，在每个频率定值处设置加速减载功能的低频减载方案。文中详细分析了低频减载过程中频率的动态特性，推导了作为加速减载判据的频率变化率整定值的计算公式。

The paper studies UFLS with severaltimes accelerating shedding load function, analyzes dynamic frequencycharacteristic of power system during UFLS, derivesthe formula which is served as setting rate of frequency change for criterionof accelerating shedding load, and designs the logical diagram expressing UFLSoperation.

研究了同时依据频率和频率变化率两个变量，在每个频率定值处设置加速减载功能的低频减载方案。文中详细分析了低频减载过程中频率的动态特性，推导了作为加速减载判据的频率变化率整定值的计算公式。

The main dimensions are calculated by magnetic track, then the fields of load and without load are computed by 2-d FEM and references of the motor are obtained, so the structure of the motor can be adjusted.

用磁路设计法确定电机的主要尺寸，然后用二维有限元法计算电机的空载和负载磁场分布，得到电机的参数和性能，根据性能要求对电机结构尺寸调整。

2TheMax GPX750 PSU for the desktop computer features total output of 750W, rated supply voltage of 115V to 230V auto range, rated mains frequency of 47 to 63 Hz, rated input of 115V at 10A or 230V at 5A, efficiency of 85% minimum at typical load, holdup time of 16.6ms at nominal line under full load condition, power good signal between 100ms to 500ms, over current protection at 110% to 150% individual output power, over voltage protection for +5V is between 5.8V to 6.3V,+12V from 14V to 17V, 3.3V from 3.6V to 4.2V, air flow by DC fan, operating temperature of 0°C to 50°C and operating humidity of 20% to 90% non-condensing.

2themax gpx750电源为桌上型电脑的功能总产量750瓦特，额定电源电压115v到230v汽车范围，额定工频47至63赫兹，额定输入的115v在10 A条或230v在5 ，效率85 ％，最低在典型负载，持的时间16.6ms的名义在网上下，满负荷条件下，电源良好信号之间的100 ms到500ms ，过电流保护在110 ％至150 ％个别的输出功率，过电压保护，为5 V是之间的5.8 V至6.3v ，+12 V的从14v至17v ，电压为3.3 V从V到3.6 V至4.2 V ，空气流量由直流风扇，操作温度0° C到50 ° C和运作中的湿度为20 ％至90 ％，非冷凝。

Integrate the load transfer principle and shearing displacement method to set up the load transfer equation between the pile of soil, using the discrete and fitting methods to solve the equation so as to educe the pile displacement of arbitrary section as well as the analytical solution. Comparing the results with the soil settlement solved by the Mair equation, the relative displacement can be gained.

1结合荷载传递原理和剪切位移法的思想建立隧道开挖作用下的桩土荷载传递方程，采用离散和拟合两种方法来对该一元二次非齐次微分方程进行求解，可分别得到桩身任意截面处的桩体位移以及桩身位移的解析解，并与基于Mair公式求得的地面下任意深度处的土体沉降进行比较，即可求出桩与桩侧土之间的相对位移。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。