查询词典 load-on

The results showed that the two synthesized compounds have good thermal stability; two synthesized compounds as additives in 5 cst possess rather good antiwear property and load-carrying capacity, and the antiwear ability of the additive loma is stronger than that of the additive boma; there is a pronounced synergism between the additives loma/boma and zddp in terms of the anti-wear property and load-carrying capacity.

发现两种化合物有很好的热稳定性；两种化合物作为润滑油添加剂在5 mm2/s基础油中有相当好的抗磨性能和承载能力，其中含有三嗪环的抗磨添加剂比不含三嗪环的抗磨能力好；两种抗磨添加剂均与zddp有很好的协同抗磨减摩作用。

In this paper, single phase bridge controlled rectifier circuit with resistance load and with resistance and inductance load had been simulated and analyzed in MATLAB.

本文使用MATLAB软件对带电阻负载和带阻感负载的单相桥式全控整流电路进行了仿真分析。

Of the UPS output load should not be with SCR, thyristor rectifier bridge or half-wave rectifier load

4在 UPS 的输出端不宜带可控硅负载、可控硅桥式整流或半波整流式负载

As the development of our country's national economy and the highway transportation business , the highway transportation appeared the characteristics of "heavy load, great flow and canalization traffic", heavy trucks and overload vehicles'number are rising,it caused a sharply increase in the times of actual total amount of standard axle load.

长安大学，道路与铁道工程，2008年，博士随着我国国民经济和公路运输事业的告诉发展，公路运输出现了"重载、大流量和渠化交通"的特点，重型货车及超载车辆急剧上升，引起实际累计标准轴次的急剧增加。

If the DC load is very demanding of a smooth supply voltage, a 稳压器 may be used either instead of, or in addition to, the capacitor-input filter; this serves both to remove the last of the ripple and to deal with variations in supply and load characteristics.

是否要求非常严格的顺利供应电压直流负载而不是或除了到电容输入筛选器，就可使用一个稳压器；这是同时删除纹波的最后一个，应付供应变化和负载特性。

The Wrap Pack II is a fully automatic Wrap-Around Caser, which will accumulate the product, load the accumulated pattern onto a flat corrugated blank, form the blank around the load and seal it into a shippable container.

Wrap Pack II 是一款全自动化的卷绕的包装机，累积产品，装在存储样品到缩成皱纹的扁坯上，在装载物周围形成半成品，然后将它封在可运输的集装箱内。

The results show: the most sensitive Chinese area to acid deposition is Podzolic soil area, then follow Latosol, Dark brown forest soil and Black soil areas; Ferraisol and Yellow-brown earth area in southern China can buffer about 0.8-1. 6 g Sm〓yr〓 sulfur deposition; the least sensitive areas to acid deposition are mainly Xerosol area in northwest China, Alpine soil area in the Qingzang Plateau, and Dark loessial soil and Chernozem areas; the main reason for lower critical load in northeastern areas and higher critical load in Ferralsol and Yellow-brown earth areas in China can be attributed to the obvious difference in temperature, humidity and soil properties.

研究表明：我国土壤对酸沉降最敏感的区域是漂灰土带，其次是砖红壤土区、暗棕壤带和黑土区，南部富铝土区域大致可接受O.8-1.6 g Sm〓yr〓的硫沉降，对酸沉降最不敏感的区域主要集中在西北干旱土和青藏高原的高山土区域以及黑垆土和黑钙土带；导致我国东北地区酸沉降临界负荷偏低和富铝土区域酸沉降临界负荷偏高的重要原因，是这些地区的气温、湿度和土壤质地存在显著差异。

The circular disk is somewhat easier to machine and to load than the tensile 3 specimen; moreover, if required, several calibration points can be obtained from a single load.

基於试片加工与负载的方便性，而且可以只从单一负载就可取得多点资料，所以圆盘试片受上下压力实验法是比较被推荐使用的方法。

The removal of CODcr: During the period of high temperature, when the hydraulic load increases gradually from 4.92 ml/L-d to 39.39 ml/L-d, the water quality of the effluent doesnt changes too much and the removal ratio stabilizes above 70% mostly; During the period of low temperature, the removal ratio of CODo can only reach 40% even if the hydraulic load is as low as 4.92 ml/L-d.

COD_的去除：高温时期，当水力负荷在4.92～39.39ml／L·d的范围内逐渐增加时，出水水质变化不大，去除率基本稳定在70％以上；低温时期，即使采用4.92ml／L·d的低水力负荷进水，COD_的去除率也只能达到40％左右。

The results indicate that as the value of fractal dimension is increased, the interfacial static friction coefficient first increases and then decreases; the interfacial static friction coefficient decreases as the fractal roughness parameter increases; while the inter-facial static friction coefficient increases as the material property or total normal load increases; the curve of static friction coefficient versus dimensionless total normal load is convex when the fractal dimension becomes smaller or fractal roughness parameter is larger or material property becomes smaller.

研究结果表明：界面的静摩擦因数首先随分形维数的增加而增加，然后随分形维数的增加而减小；界面的静摩擦因数随分形粗糙度参数的增加而减小，但随材料特性的增加而增加，也随总法向载荷的增加而增加；当分形维数较小或分形粗糙度参数较大或材料特性较小时，静摩擦因数－量纲一的总法向载荷曲线为凸弧。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。