查询词典 load with

They refer to the load-bearing and bracing components of non-reinforced, reinforced and prestressed concrete with a close-grained texture.

2这里指的是有细晶粒结构的无钢筋加固，有钢筋加固和预应力混凝土制作的承载和支撑部件。

The results show that the friction coefficient of the steel in dry sliding friction decreases with increment of load and speed.

结果表明，摩擦系数是随着法向载荷和滑动速度的增加而降低。

The numerical results of static friction coefficient showed that it first increases and then decreases with the increase of load.

根据分形转变模型计算的静摩擦系数与载荷的规律是：随着载荷的增加，静摩擦系数先是增加，然后又减小。

Experiments were performed with this device to measure the static coefficient of friction for three kinds of material(45steel,HT35-61,QT80-2) in the same processing method,the same surface texture,the same load,dry friction and different surface roughness conditions respectively.

分别对材料(45钢、HT35-61、QT80-2)在相同加工方法、相同表面纹理、载荷恒定、干摩擦条件下，改变表面粗糙度时的静摩擦因数进行了测定。

In order to find the signs of chronic fatigue syndrome and study the relation of CFS and exercises, we researched the coenocyte＇ s gene expression in peripheral blood of women with chronic fatigue syndrome before and after exercises load.

为了寻找慢性疲劳综合症的标志物，并研究慢性疲劳综合症与身体锻炼之间的关系，对患有慢性疲劳综合症女性的运动前后外周血单核细胞基因表达谱进行了研究。

This method overcome the problems of many supposition conditions in theory and difficulty in searching critical slip surface in 3D limiting equilibrium analysis; It uses the 3D FEM\'s stress field directly, differs from the practical value of 3D FEM strength reduction method used hypothesized load, and differs from the characteristic of the FEM with limiting equilibrium theory still to need to divide the columniation, and suppose the critical slip surface in advance.

该方法克服了三维极限平衡分析方法在理论上引入较多假设条件，且搜索临界滑裂面困难的问题；它直接采用三维有限元应力场，不同于三维有限元强度折减法基于虚拟荷载上得出的实用价值；同时异于沿用极限平衡理论的有限元法仍需要进行条柱划分，并事先假设滑裂面形状及位置的缺点。

It is shown that the mechanical properties including Young's modulus, tensile strength, critical strain and stress under buckling can be enhanced with the decreasing of intershell spacing. The shear strength can be enhanced by 2-3 orders of magnitude when the intershell spacing is reduced to 20%, which is also dependent on commensuration. Zigzag-type carbon nanotubes have higher shear strength. The axial stress in tubes when the load transferring from outmost tube to inner tube is observed as well.

研究了单壁纳米管束横截面的六方化失稳现象，给出各种管径的面内压力－应变关系曲线；每条曲线都给出一个明显的拐点而且有很强的非线性；线弹性模量与参考构形有关，也受管直径的影响；分析了管束横截面的晶格不稳定性特征，表明晶格的缺陷能够明显的减小临界值；模拟了在不同应变下纳米管束对静水压的反应，发现不同压力下的截面形态不同，在很高压力下相邻管之间会形成化学键。

So it is the base of this article to research the traffic signal control for the commix traffic, combined with practical reality. Urban artery usually bears the main traffic load.

城市干道通常承担着城市的主要交通流量，解决好城市干道的协调控制问题，能大大缓解交通拥挤压力。

In order to drive a high impedance load such as HPM sources, it is necessary to commutate FCG's long pulse width, high-current and low voltage pulse to a short pulse with high voltage.

为用FCG驱动象HPM源这样较高阻抗的负载，必须使用脉冲功率调制电路把FCG产生的低电压、大电流、上升时间长的电压脉冲转化为高电压、上升时间短的脉冲。

Traditional load applying methods are simple with little automatization, and most are done only on the plane so that complex spatial joint experiment is hard to achieve.

结构试验是研究节点性能的有效方法，传统的建筑结构试验设备加载方式简单、自动化程度低，多数只能进行平面加载，难以进行比较复杂的空间结构节点试验。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。