英语人>网络例句>load with 相关的网络例句
load with相关的网络例句

查询词典 load with

与 load with 相关的网络例句 [注:此内容来源于网络,仅供参考]

Since the voltage not only has relationship with both the reactive power and the balance of reactive load, but also relies on the structure of network and capability of voltage regulation, the system takes all the factors above into consideration and adopts the methods as follows: realizing grading control and management according to the voltage level and region partition, realizing jointly regulation and information pool by the application of advanced software in local and central station, realizing the optimal control of reactive voltage based on the measurement data from the regulative automation system and the angle of the whole system, realizing the exact application of reactive compensator and the on-load tap appropriate changer for voltage regulation transformers , and realizing the balance of reactive voltage in local site.

随着调度自动化系统的日益普及,以及越来越多的电网中的有载调压分接开关和电容器补偿装置投入使用,本课题研究开发基于分级递阶的地调/中心站模式无功电压控制系统,由于电压既与无功功率和无功负荷平衡有关,又与电网结构、调压能力有关,所以系统考虑电压等级、按区域实施分级控制、分级管理,利用中心站和地调的电力系统高级应用软件的作用实现众多装置的联合调整,信息共享。

The results indicate that weight factor had significantly effect on gait speed, steps per minute, gait cycle time, the ratio of stance time and swing time, maximal flexion angle of knee joint and the range of motion of elbow joint. Shelf height had significantly effects on hip flexion and elbow ROM. Box size factor had significantly effect on stride length, gait cycle time, the ratio of stance time and swing time, knee joint elbow ROM. For the muscle activity levels with EMG, load weight and shelf height both affected the %MVC significantly. When the subjects carrying a load of 14kg, the muscle activity and the subjective body part discomfort rating are both higher than that of 7kg. The box size had effect on the body part discomfort rating of upper extremity and back. For the kinetic and kinematics analysis, the shelf height around elbow height was better than the other two height levels.

研究结果显示,对步态时间与空间参数而言,重量因子显著影响步速、步频、步态周期时间与站立期摆荡期比值,箱型因子显著影响步长、步态周期时间与站立期摆荡期比值;关节活动度而言,重量显著影响膝关节最大弯曲角度、肘关节屈伸角度范围,高度因子显著影响髋关节前后倾角度、肘关节活动各变项,箱型因子影响膝关节弯曲最大最小值以及肘关节活动各变项,对肌肉活动度而言,重量与高度因子皆显著影响MVC%值,14公斤重者肌肉活动度与主观不舒适程度皆较7公斤者高,箱型因子虽无明显影响肌肉活动度,但是在主观不舒适程度上却明显影响上肢与背部,终点放置高度应设在肘高附近为佳。

Through analysis to the pumping unit's load characteristic, the relationship between the position of the suspension point load's peak value and the oil well's parameters has been obtained and a new method about the transforming of the pumping unit with downward beam balance weight is proposed.

分析常规游梁式抽油机的载荷特性,得出悬点载荷的峰值出现的位置与井况参数的关系,提出一种下偏杠铃抽油机改造方法,依据油井抽汲参数调节下偏杠铃的角度,使其最大力臂与悬点最大载荷对应,提高抽油机的平衡效果。

The results show that:(1)the low-noise source-follower circuit can be effectively used to measure the output of PVDF thin film;(2)the piezoelectric coefficient D33 of the PVDF is very sensitive on temperatures;(3)the value of D33 intensively fluctuate in initial loading stage,this means that a pre-load is needed in practice application to keep a constant piezoelectric coefficient D33 of the PVDF;(4)when the compressive load is imposed on the surface of the PVDF along a incline direction,D33 value is obvious changed with changing incline angle,and(5)the frequency bandwidth of the PVDF thin film is very wide,it is more suitable to measure strike or impact loading at various loading conditions.

结果表明:(1)低噪声源跟随电路可有效测量PVDF 薄膜输出;(2)PVDF压电薄膜的压电系数D33对温度很敏感;(3)D33值在加载初始阶段波动很大,所以实际应用中应给PVDF提供一个预压载荷,以确保有一恒定的压电系数D33;(4)当压载荷沿倾斜方向作用在PVDF 表面时,由于有剪切力作用,D33 值会随着倾斜角的变化发生显著改变;(5)PVDF 薄膜具有很宽的频响,更适用于测定不同载荷条件下的侵彻或冲击等动态载荷。

The system uses PID controller and fuzzy controller to design automatic control loops, a study of fuzzy three-element feed-water control system for a CFB municipal waste incinerator is introduced. The incinerator is faced with problems such as large-scale fluctuation of furnace heat load and low regulation resolution of main control feed-water valve. The fuzzy logic control system is applied to modulate PI control parameters according to steam drum water level to fit fluctuated heat load, the inner and outer control loops are realized in an asynchronous way to effectively decrease regulation time and improve regulation precision.

针对垃圾炉炉膛负荷波动较大,同时给水调节阀门执行机构的调节精度较低的现状,在传统三冲量串级汽包水位控制方式的基础上,采用模糊控制策略对内、外串级回路的PI控制参数进行分区域调整,强调了PI参数在被控参量处于不同范围时的分离作用,同时内、外控制回路采用异步控制方式,浙江大学硕士学位论文从而有效地减小了被控参量的调节时间,提高调节精度,使水位波动控制在△为士12~范围内。

Integral in the design of three-dimensional structure of the storage shelves, with particular attention to the following two of the most adverse combination of loads: the role of wind load at the time of a state-wide database of no-load power; when the level of seismic action of the whole library full of force.

在设计整体式立体仓库的货架结构时,尤其注意下列两种最不利的荷载的组合:风载起作用时的全库空载状态下的受力;水平地震作用时全库满载下的受力。

The influence of self-explanation as questions or questions with answers on cognitive load and achievement have no significant difference.(9) Though the management of cognitive load by multimedia instructional design, material character and learners\' individual differences have significant moderate effect.

9在通过多媒体教学设计控制认知负荷的过程中,学习材料和学习者个体差异在其中起着重要的调节作用,因此,多媒体学习中认知负荷是由教学设计、材料和学习者三者共同作用的结果。

Moreover, the column deflection of hull saddle shaped steel plate caused by dead load is calculated using the ANSYS system, and the date base of the calculation of dead load forming for hull saddle shaped steel plate with varying the plate thickness is established.

根据在大连造船新厂的调查和分析可知,在全部展开外板中,平板自重成型率占1 0 %左右,具有较小横向曲率的外板自重成型率占1 5 %左右,其余的外板需经不同程度的水火弯曲加工而达到成型的目的。

The means 9 are formed as a switch and load activations circuit comprising means for communication with the load.

装置9被形成为开关和负载激活电路,其包括用于与负载通信的装置。

The cutting pattern and load curves of cutting process of the two cutting heads were given by computer simulation, which showed that the cutting performance of the cutting head with pick arrangement based on equal-rise-angle spiral line was good because of its reasonable pick cut, its uniform cutting pattern and the small value and the fluctuation of its load.

为了评价利用等螺旋升角进行截齿排列设计的截割头的截割性能,选用了一个实际的截割头进行比较,通过计算机仿真获得两个截割头截割过程的切屑图和载荷曲线,经比较分析表明,用等螺旋升角排列截齿的截割头截槽合理,各段切屑图均匀,载荷大小及其波动较小,截割性能良好,所以用等螺旋升角排列截齿是一种高效、实用的截齿排列方法。

第28/100页 首页 < ... 24 25 26 27 28 29 30 31 32 ... > 尾页
推荐网络例句

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。

There is no differences of cell proliferation vitality between labeled and unlabeled NSCs.

双标记神经干细胞的增殖、分化活力与未标记神经干细胞相比无改变。