查询词典 load with

Methods: Eleven healthy young male volunteers enrolled in this study. Testing MVC of back extensor before the experiment. The experiment collected sEMG signal at which T12-L1 segment lumbar multifidus and L5-S1 erector spinae in different directions, with different load ways, different load levels and different road conditions.

10名健康青年男性志愿者，实验前测试其背伸肌最大随意收缩力，采集被试在不同方向上的躯干运动时与不同负荷方式、负荷等级及路面条件下行走时T12-L1节段左右侧竖脊肌与L5-S1节段左右侧多裂肌的sEMG信号。

There are single load model and double -load model with multispeed mechanism .Optional drive mode includes sidle drive , pneumatic drive , Frequency conversion motor drive and servo motor drive .

轻型横走式机械手 Light weight sidle robots TYA系列适用于250吨至50吨卧式注塑机产品及水口取出，有单截式和倍速机构双截式，可选购横行驱动方式，气动驱动，双频马达驱动，伺服马达驱动。

In the buckling question under nonconservation force,a simply example( the dynamic stability question under the uniformly follower forces with small deformation % linear elastic, straight normal.) is considered.The variational equation of braid composite cylindrical shells subjectd to uniformly follower forces is deduced based on the variation principle of quasinatural frequency of elastic nonconservative system self-excited vibration.The calculated formulas of the flutter load and quasinatural frequency of shells are obtained. The program for calculating the flutter load is developed.The numerical example is given and some useful conclusions are obtained.

对非保守力作用下的屈曲问题，具体研究了圆柱壳在比较简单的情况，即小变形、线弹性、直法线假设下在随动力作用下的壳屈曲问题，由拟固有频率变分原理推出了圆柱壳受随从力作用的变分方程，得到了颤振载荷与壳弯曲的固有频率的计算公式，编制了相应的计算机程序，并给出了具体算例，得到了一些有益的结论。

In this paper,based an the Monte-Carlo method,the outher has really analysed the distribution and statistical parameter of the effect of crane load in one-story industrial buildings with further consideration of the random position and combination of crane load .

本文充分考虑了吊车荷载的随机位置和多台吊车组合情况，采用Monte—Carlo方法分析了吊车荷载效应的分布及其统计参数，得出一些有意义的结论。

The state-of-the-art combination transformer recently developed by us, namely ZFS10-H combination transformer, has been provincially certified in 2000, inheriting the advantages of the American and European box transformers, with such structural features as being innovative , compact and unique, composed of wholly sealed power transformer, high-voltage ring net load switch, terminal load switch, backup fuse and inserted fuse, etc.

新型组合变压器——我公司新研制的ZFS10-H组合式变压器于2000年通过省级鉴定，该产品吸收了美式箱变和欧式箱变的技术优点，结构新颖、紧凑、独特、由全密封变压器、高压环网负荷开关、终端负荷开关，后备保护熔断器及插入式熔断器等组成。

After flow and transient stability calculating of the 330kV grid, we got the over-load and hazard lines set. Then we gained the redundant network needed to be built according to the increasing power supply and load in 2010. Adopting regradation step-by-step algorithm by which we can improve the calculation efficiency , we compared the validity of every line, deleted lines with low validity until no redundant line is in the network. At last we got the target network framework adopting the improved ant colony algorithm. Flow distribution, construction investment assessment and target framework of Gansu long-term planning all be considered, from the viewpoint of to be economic and reliability the feasibility of the improved ant colony algorithm is discussed.

在对2006年该网架结构进行了潮流计算与暂态稳定计算分析后，得出了系统的过负荷与危险线路集，并针对2010年新增的电源和负荷点确定了冗余的待建网架，然后利用逐步倒推法比较各待选线路在系统中的有效性，逐步去除有效性低的线路，直到网络中没有冗余线路为止，以此来以提高优化算法的计算效率，最后利用改进后的蚁群算法确定优化后的目标网架结构，并从潮流分布、建设投资估算等方面与甘肃电网远期规划中确定的目标网架进行了比较，从可靠性和经济性角度论证了改进蚁群算法在网架优化中的可行性。

On the base of practical transformer substation main connection, electric components and system circuit model are first formed in the paper; analyze vacuum arc characteristic and medium resume are analyzed, then, according to vacuum chamber physical process of switching AC arc, resume process are divided into three stages: sheath development, neutral particles diffusion and static characteristic, with that, calculating model of medium resume strength is erected and applied in the computing of vacuum circuit breaker interrupting transform overvoltage; In the paper, Saber software is used to simulate a whole switching process; As follows, overvoltage characteristic of vacuum circuit breaker switching no load and load transformers, kinds of influence factors are analyzed in detail; At last, vacuum circuit breaker switching capacitance group overvoltage formative causes and electrode refining for lessening reignition are discuss.

本文针对中低压变电站的实际主接线建立各电气元件及系统的电路模型；在真空电弧的特点及间隙的介质恢复特性上，依据真空断路器灭弧室分断电弧的物理过程，将真空电弧熄灭后的恢复过程分为鞘层发展、中性粒子扩散和静态特性三个阶段，建立了相应的介质恢复强度的计算模型，应用到切除变压器操作过电压的计算中；采用Saber仿真软件模拟计算真空断路器切除变压器操作过电压；并分别对真空断路器切除空载及负载变压器操作过电压的特点与影响操作过电压的各种因素做了详细的分析；最后简要分析了真空断路器开断电容器组过电压的形成原因及为减少重燃的电极老炼措施。

In the paper,vacuum circuit breaker switchingtransformers process is simulated with Saber software and parameters are analyzed Theresults indicate that overvoltage peak value of switching no load transformers is not muchhigh,especially for switching load transformers.Yet,reignition overvoltage might doharm to transformer coils by cumulative effects for its surge steepness.The measures liesin setting parallel connection capacitance in practice working.

本文利用Saber仿真软件对真空断路器切除变压器的一个完整过程进行了仿真计算，并详细分析了各种参数对过电压的影响，结果表明，尽管实际中切除空载变压器过电压的幅值并不是很高，特别是带负载变压器的情况，但重燃过电压的陡度较大，对变压器绕组的纵绝缘有累积作用，在实际工作中应以并联电容为基础的限压装置。

On the base of practical transformer substation main connection,electriccomponents and system circuit model are first formed in the paper;analyze vacuum arccharacteristic and medium resume are analyzed,then,according to vacuum chamberphysical process of switching AC arc,resume process are divided into three stages:sheathdevelopment,neutral particles diffusion and static characteristic,with that,calculatingmodel of medium resume strength is erected and applied in the computing of vacuumcircuit breaker interrupting transform overvoltage;In the paper,Saber software is used tosimulate a whole switching process;As follows,overvoltage characteristic of vacuumcircuit breaker switching no load and load transformers,kinds of influence factors areanalyzed in detail;At last,vacuum circuit breaker switching capacitance groupovervoltage formative causes and electrode refining for lessening reignition are discuss.

本文针对中低压变电站的实际主接线建立各电气元件及系统的电路模型；在真空电弧的特点及间隙的介质恢复特性上，依据真空断路器灭弧室分断电弧的物理过程，将真空电弧熄灭后的恢复过程分为鞘层发展、中性粒子扩散和静态特性三个阶段，建立了相应的介质恢复强度的计算模型，应用到切除变压器作过电压的计算中；采用Saber仿真软件模拟计算真空断路器切除变压器作过电压；并分别对真空断路器切除空载及负载变压器作过电压的特点与影响作过电压的各种因素做了详细的分析；最后简要分析了真空断路器开断电容器组过电压的形成原因及为减少重燃的电极老炼措施。

On the base of practical transformer substation main connection,electriccomponents and system circuit model are first formed in the paper;analyze vacuum arccharacteristic and medium resume are analyzed,then,according to vacuum chamberphysical process of switching AC arc,resume process are divided into three stages:sheathdevelopment,neutral particles diffusion and static characteristic,with that,calculatingmodel of medium resume strength is erected and applied in the computing of vacuumcircuit breaker interrupting transform overvoltage;In the paper,Saber software is used tosimulate a whole switching process;As follows,overvoltage characteristic of vacuumcircuit breaker switching no load and load transformers,kinds of influence factors areanalyzed in detail;At last,vacuum circuit breaker switching capacitance groupovervoltage formative causes and electrode refining for lessening reignition are discuss.

本文针对中低压变电站的实际主接线建立各电气元件及系统的电路模型；在真空电弧的特点及间隙的介质恢复特性上，依据真空断路器灭弧室分断电弧的物理过程，将真空电弧熄灭后的恢复过程分为鞘层发展、中性粒子扩散和静态特性三个阶段，建立了相应的介质恢复强度的计算模型，应用到切除变压器操作过电压的计算中；采用Saber仿真软件模拟计算真空断路器切除变压器操作过电压；并分别对真空断路器切除空载及负载变压器操作过电压的特点与影响操作过电压的各种因素做了详细的分析；最后简要分析了真空断路器开断电容器组过电压的形成原因及为减少重燃的电极老炼措施。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。