查询词典 load with

However, in designing the beamless slabs with equivalent frame method, the stress is an average values along the depth of section, which varies with the normal service state. Compared with the results by finite element method, the results gained by equivalent frame method cannot satisfy the requirement under the normal service state. Therefore, the tendons of beamless slabs should be designed and arranged based on the results of FEM taking account into vertical load and prestressed load.

本文通过分析，认为采用等代框架法进行无梁板设计时，其内力是基于截面平均的结果，在正常使用状态与实际受力状态有很大的不同，通过对比等代框架法和有限元计算的正常使用极限状态应力可知，按等代框架法设计的预应力布置并不能保证其正常使用极限状态的要求，据此提出了应根据无梁板在竖向荷载和预应力共同作用下弹性有限元分析结果进行预应力筋布置的建议。

The results show that the ultimate stability bearing load by nonlinear analysis is close to the test load, they only have 10% deviation. For steel bridge towers, the correlation of the panels in the section of rectangle with chamfers is more obvious than that in the section of rectangle. If the four angles of the rectangle section were cut off, a panel with the smaller ratio of width to thickness forms, which can supply effective constraint to other weak panels with the larger ratio of width to thickness.

结果表明：第2类稳定计算得到的失稳极限荷载与实测荷载较为接近，两者相差10%；带切角矩形截面钢桥塔较矩形截面钢桥塔板件间的相关作用更加明显，对矩形截面钢桥塔进行切角，形成宽厚比较小的壁板，可以对宽厚比较大的弱板提供有效约束。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 16 81.1 231.3 14.61 20.85 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with...

载荷钢球圈列数 DN值预压预压方法预压负荷 2列 2.50圈 70000 有定位置预压 4370 导轨型号丝杠轴加工方式球保持器轴的花键部分中空轴滚珠精密无无无轴承支撑座固定侧的推荐方式轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球无无双螺帽右螺纹，左螺纹，左右螺纹无轴方向刚性。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 6 29 99 3.42 11.31 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ atta...

载荷钢球圈列数 DN值预压预压方法预压负荷 1row 2.50圈 70000 有定位置预压 765 导轨型号丝杠轴加工方式球保持器轴的花键部分中空轴滚珠精密无无无轴承支撑座固定侧的推荐方式轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球 BK30，FK30 BF30， FF30 双螺帽右螺纹，左螺纹，左右螺纹无轴方向刚性。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 5 23.7 84.7 1.69 9.06 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ att...

载荷钢球圈列数 DN值预压预压方法导轨型号 2列 1.50圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 BK30，FK30 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性 BF30， FF30 单一螺帽右螺纹，左螺纹，左右螺纹无 400.0 螺纹条数。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 10 52.7 141.1 6.16 8.22 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ...

载荷钢球圈列数 DN值预压预压方法预压负荷 2列 2.50圈 70000 有定位置预压 3080 导轨型号丝杠轴加工方式球保持器轴的花键部分中空轴滚珠精密无无无轴承支撑座固定侧的推荐方式轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球 BK30，FK30 BF30， FF30 双螺帽右螺纹，左螺纹，左右螺纹无轴方向刚。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 20 90.1 294 12.68 35.81 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ a...

载荷钢球圈列数 DN值预压预压方法导轨型号 3列 2.50圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无无轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹，左螺纹，左右螺纹无 1860.0 螺纹条数防尘措施。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 1 0.59 0.93 0.02 0.07 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ a...

载荷钢球圈列数 DN值预压预压方法导轨型号 1row 3.70圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK4， FK4 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹无 52.9 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置配用 1 无。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 10 26.1 56.2 2.2 4.98 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ att...

载荷钢球圈列数 DN值预压预压方法导轨型号 1row 3.50圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 BK20，EK20，FK20 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性 BF20， EF20， FF20 单一螺帽右螺纹，左螺纹，左右螺纹无 440.0 螺。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 4 5.1 10.5 0.32 1.35 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ atta...

载荷钢球圈列数 DN值预压预压方法导轨型号 1row 2.50圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 BK12，EK12，FK12 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性 BF12， EF12， FF12 单一螺帽右螺纹，左螺纹，左右螺纹无 190.0 螺。。。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。