查询词典 load up

So the main study contents of this thesis are as follows: the load distribution pattern along the length beam and the cross beam in the place of node、 the appropriate matching rigidity of the length and cross beams in the action of same anchorage force and the affection pattern discuss on sloping surfaces dip angle、 beam rigidity 、 anchor-rope angle as well as the position of load which affect the load distribution ratio on length and cross beams. In the end it brings forward lattice beam internal force calculated method on the basis of double parameter groundsill model.

鉴于此，本文主要的研究内容是格构梁节点处荷载沿纵横梁的分配规律、同一锚固力作用下纵横梁合理的匹配刚度以及对格构梁纵横梁荷载分配比值可能存在影响的坡面倾角、梁刚度、锚索夹角、加载位置等因素的影响规律探讨，最后提出基于双参数地基模型的格构梁内力计算方法。

According to the features of load forecasting of small region,a decoupling mechanism based error analysis model and corresponding forecasting mechanism are proposed in which the short-term load forecasting is divided into two parts,namely load level forecasting and per unit curve forecasting.

针对小地区短期负荷预测的特点，提出了基于解耦机制的误差分析模型和预测机制，将短期负荷预测分为负荷水平预测和标幺曲线预测两部分。

Electric load ; load curve ; seasonal load

电力负荷；负荷曲线；季节性负荷

Load Factor The load factor is the ratio of the average load to the generator set power rating.

负荷系数负荷系数指的是机组的平均负荷与额定功率之间的比率。

This design after determination frame layout, has carried on the level first the load generation of tabular value computation, extracts the wind load with the D value law the function, then uses the bending moment two methods of distribution to calculate the vertical load under the function structure endogenic force, and discovers most disadvantageous group of or a several group of endogenic force combination.

本设计在确定框架布局之后，先进行了层间荷载代表值的计算，用D值法求出风荷载的作用，接着用弯矩二次分配法计算出竖向荷载作用下的结构内力，并找出最不利的一组或几组内力组合。

This design after determining the frame layout, has carried on the level the first load generation of tabular value computation, extracts the wind load with the D value law the function, then uses the bending moment two methods of distribution to calculate the vertical load under the function structure endogenic force, and discovers most disadvantageous group or a several group of endogenic force combination.

本设计在确定框架布局之后，先进行了层间荷载代表值的计算，用D值法求出风荷载的作用，接着用弯矩二次分配法计算出竖向荷载作用下的结构内力，并找出最不利的一组或几组内力组合。

There are great differences between the axle load used in the pavement design and the load moving at the actual pavement. The difference affects the degree of pavement damage due to axle load and the pavement life.

路面上实际行驶的车辆其荷载的大小与路面设计时所采用的理论值有一定的偏差，偏差的大小直接影响车辆对路面的损害程度和路面的使用寿命。

Combined prototype tests with numberical tests, the invalid load, strengthen load and critical load are determined.

首次得到了随着锻炼载荷等级的不断提高，结构在高载荷下的过载寿命先增加而后降低的结论，即锻炼后寿命与锻炼载荷的函数关系可表为一元二次多项式。

Then, we can simulate its transient, static process with no load, full load, shock load and parametric change using MATLAB Artificial Toolbox and the M－File. Also, we can analyze and discuss the gained oscillogram.

本设计完成了在机组空载运行、满载运行、突加负载和突卸负载运行时，以及在改变系统参数的情况下的计算机仿真研究，并讨论了参数对系统的影响。

No matter axial pressing or small eccentricity pressing of CFSTRC, it can be concluded such conclusions as following.(1)Compared with normal concrete filled steel tube, the CFSTRC has better ductibility and limited load-carrying capacity. The outer reinforced concrete offers much help to yield load and limited load.

可以得出，无论是轴心受压还是小偏心受压：(1)钢管高强混凝土核心柱比普通钢管混凝土柱具有更好的延性和承载能力，核心柱外围钢筋混凝土对屈服荷载和极限荷载的贡献较大。

" I' d like to get some rough idea about music in the baroque ear, please."

请简要介绍一下巴罗克时期的音乐，好吗？

The results showed that the peak latency and pattern of SEPs elicited by electrical needling in LI-l1 and MP were similar. The amplitude of SEPs elicited by electrical needling in LI-l1 was higher than that of MP. There was no obvious SEPs generation when MM was electrical needling.

结果显示，电针刺激曲池穴和其邻近桡侧伸腕长肌运动点诱发性脑电波的波形和波峰时间是类似的，只是穴位的诱发性脑电波波幅较大，而电针刺激非穴位点并没有明显的诱发性脑电位。