查询词典 load displacement

The conclusions provides practical significance for engineering practice.The side displacement of the glass plate center is larger or less than the glass plate thickness,for the 3D geometric size of the glass plate and the lateral load vary in a wide range. In other words,the mechanic analysis of glass plate belongs to large deflection or small deflection theory in thin plate theory.

由于幕墙玻璃的三向几何尺寸和横向荷载集度可在较大的范围内变动，玻璃板中心的侧向位移，有可能小于或大于玻璃板的厚度，也就是说，幕墙玻璃的力学分析，既可能属于薄板理论中的小挠度问题，也可能属于大挠度问题。

New ideas and methods in the paper:1 The formulas on perforated casing collapse strength were deducted, which offereda convenient method to analyze the relationship between casing collapse strength and perforation;2 The stress and displacement formulas on the system of casing, cement anddeformation under the non-uniform load were deducted, which offered the theoretical found for designing optimally casing string;3 The relationship between structure in-situ field of whole oil field and casing failurewere studied, which offered the scheme for the prediction of casing failure. The process of study in the paper:1 For simulating the relationship between the structure in-situ field and the casingfailure in the oil-deformation, the tests of the uniaxial tensile, compress, tnaxial compress and dilatability were made on the samples of the drill cores from deformation of casing failure position in Yuejing II oil field.

本文的主要创新： 1推导出了射孔套管抗挤强度的解析式，为分析射孔与套管强度的变化关系提供了简便的方法； 2推导出了非均匀地层载荷作用下套管、水泥环和地层组合体的应力和位移解析式，并非均匀作用下套管柱优化设计提供了理论依据； 3研究整个油田区块构造应力场与套管损坏关系，为预测套管损坏提供了可行方案；本文的研究过程如下： 1为模拟构造应力场与油层段套管损坏关系，做了大量的岩石单轴抗拉、单轴抗压、三轴试验以及岩石遇水膨胀试验，获得了研究区块岩石的弹性模量、泊松比、内聚力、内摩擦角以及岩石的线膨胀系数，这此数据为本文研究油层段套管损坏机理研究的理论分析和有限元法提供了实验数据。

The stress and displacement have a direct proportion to the load.

应力和位移的大小与所受载荷力的大小成正比。

By using this method, it can evaluate the displacement and the load of any section at any time.

运用此方法，能计算出抽油杆柱在任意时刻，任意截面的位移和载荷。

Typically, changes in output are achieved by varying the displacement of the engine (often through use of a arrangement), or by changing the quantity of working fluid, or by altering the piston/displacer phase angle, or in some cases simply by altering the engine load.

通常情况下，改变输出所取得的位移不同的引擎（通常是通过使用一种安排），或改变的数量，工作液，或通过改变活塞/置换相角，或在某些情况下只需通过改变发动机负荷。

In the problem of how to judge distortional buckling, a good method is use load-axial displacement curve.

在畸变屈曲的判断标准的问题上，可以采用荷载—轴向位移法，亦可以采用荷载—横向应变法。

Therefore, the conclusion is acquired that effect of different earthquake waves to dynamic stability of frames is little, that is, ultimate displacement of frame is independent of dynamic load type.

由此，得出了不同地震波的作用对框架结构的动力稳定性影响不大的结论，即框架结构的极限位移与所施加的地震荷载类型无关。

According to theory analysis and example computation, the following conclusions are obtained.1. During the analysis on the cable shape in the suspension bridge"s completion state, the pre-displacement of saddle and the case that the cable and stiff girder commonly bear the second-stage dead load should be considered.2. When supposing the construction ideal initial state in the first time, if the initial state model is established according the cable"s span central sag in the bridge"s completion state, and the reasonable correction formulation is created in the iteration process, the result can converges fast.3. The cable shape in the bridge"s completion state is not parabolic, nor catenary. It is between parabola and catenary. Actually it is funicular polygon closer to the catenary.

通过理论分析和实例的计算表明：1在悬索桥主缆成桥线形分析过程中，须考虑主塔鞍座的偏位以及二期恒载由主缆和加劲梁共同承担的实际情况；2在第一次假设施工理想初态时，以成桥状态已知的主缆跨中垂度建立施工理想初态模型，同时在迭代计算的过程中，建立合理的修正公式，才能使收敛的速度快：3在成桥状态时主缆的线形既不是抛物线，也不是悬链线，而是介于抛物线与悬链线之间，更接近于悬链线的索多边形。

Owing to the fact that hydraulic fluid is essentially incompressible, very little actual displacement is involved in the operation of the load cell (some movement, however, is inevitable, as it is nearly impossible to remove all the air from the hydraulic system, in particular, the gauge).

由于这一事实，即液压油基本上是不可，很少实际位移是在操作上所涉及的负载细胞（一些运动，不过，是无可避免的，因为它几乎是不可能的，以消除所有的空气从液压系统，特别是，计）。

The analytic expressions for the displacement components and stresses at any point of an infinite micropolar orthotropic elastic medium with an overlying elastic half space as a result of moving inclined load of arbitrary orientation were obtained.

在无限大微极正交各向异性弹性介质上覆盖弹性介质的弹性半空间的任意点上，作用着任意方向倾斜的移动荷载，给出了位移分量和应力的解析表达式·假设倾斜荷载是法向荷载和切向荷载的线性组合·利用Fourier变换采用特征值方法，并利用数值技术反演了Fourier变换·给出了铝环氧树脂复合材料的数值结果图形

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。