查询词典 load displacement

After carries on the load computation and the component section estimate, selected a pin frame to carry on the computation, the computation content including the frame beam column section size selection and the line rigidity computation; Dead load, live load, under earthquake function Liang Duan, column end moment, shearing force computation; Frame endogenic force combination; The frame beam column matches the muscle computation; The staircase matches the muscle computation and the foundation matches the muscle computation.

在进行荷载计算和构件截面估算后，选取了一榀框架进行计算，计算内容包括框架梁柱截面尺寸的选取及线刚度的计算；恒载、活载、地震作用下梁端、柱端弯矩、剪力的计算；框架内力组合；框架梁柱配筋计算；楼梯配筋计算及基础配筋计算。

The results show that in the applied load range of 10250 N, the mass loss rate of coated AZ91D alloy can be identified to three stages, which are related with whether the coating is worn out. Abrasion is the main mechanism for the coated alloy. The friction coefficient of the coated alloy during sliding wear appears oscillation before it reaches a constant value, which is close to the μ value of the matrix alloy. The mass loss rate of coated alloy increases slightly with increasing applied load when the applied load is more than 150 N because of high plastic deformation accommodation on the matrix alloy surface.

结果表明：根据载荷大小，涂层处理后AZ91D镁合金的磨损行为明显分为3个阶段，这些阶段同陶瓷层是否磨穿密切相关；微弧氧化涂层AZ91D镁合金的磨损机理主要是磨粒磨损；受表面状况的影响，陶瓷涂层的摩擦因数在 0.20~0.45 间波动；在较高载荷下，涂层被磨穿后，涂层的摩擦因数趋于基体合金的摩擦因数，涂层合金的表面变形能力提高，该阶段质量磨损速率随载荷增加，趋势变得缓慢。

Five suitable load models for the Taipower system are adopted here in order to discuss the effect of the load characteristics on the setting of the overcurrent relay at the time of the incident, as a basis for setting the system coordination:(1) Static ZIP model;(2) Dynamic Motor model;(3) Composite load model;(4) PTI IEEE model;(5) Exponential model.

采用五种适於台电系统之负载模型：(1)静态ZIP模型、(2)动态Motor模型、(3)复合模型、(4)PTI IEEE模型、(5)指数模型，探讨当发生事故时负载特性对过电流电驿设定之影响，以作为系统保护协调设定之依据。

ABSTRACT: In order to analyze effect of summer weather factor on the peak load, adopting comfort index to analyze peak load is brought forward based on summarizing limitation of normal load characteristic analysis.

为更好地分析夏季气象因素对日峰荷的影响，在总结常规负荷特性分析缺陷的基础上，提出用人体舒适度作为综合气象指标来反映其对日峰荷的影响。

Load model is representation of the relationship between the power and bus voltage. Load characteristics of power system have a significant effect on power system analysis of power flow and stability that includes transient stability, voltage stability and dynamic stability. The accurate load characteristics will help engineer to analysis power flow and stability.

中文摘要负载模型可反映负载功率和电压之间的相互关系，电力系统的负载特性对系统负载潮流及稳定度包括暂态稳定度、电压稳定度及动态稳定度的分析皆有著重大的影响，准确的负载特性将有助於电力工程人员在负载潮流与稳定度之模拟分析。

Bellows Gate Valves However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。

However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。因此热力膨胀阀在变工况下供液量的调节方面需进一步改进。

Taking the demolition of a large sewage tank as an example, the design of blasting parameters, unit-area load, a reference-area for load and the principle of selecting total reference-area, the calculation of total load, charge structure, priming network and others are discussed.

以拆除一大型污水处理池为例，讨论了爆破参数的设计、单位面积装药量的确定、选取装药基准面和确定装药基准面总面积的原则、总装药量的计算，以及装药结构和起爆网路等；并简述了这种方法的爆破机理。

In this paper ,The inertia load disturbance is included in the double loop DC motor control system, Analysis of the load moment of inertia and The width of the linear area of nonlinear saturation relationship,use the method of "quasi-equivalent" modeling to model the nonlinear state space of the DLM with variable load,tested the speed response of the real system, and used an improved genetic algorithm to accurately identify the model's parameters.

本文将惯量负载的扰动纳入直流电机双闭环调速系统，分析了负载转动惯量与饱和非线性的线性域宽度λ的关系，运用&类等效&建模的方法，建立了变负载直流电机双闭环调速系统非线性状态空间模型。

Third, mensurated the front axles load-time history when truck was running on general tar-paved roads, mountainous roads and the proving ground enhancement roads, second sampled and pretreated to the load-time history with RPCⅢ software of MTS corporation, acquired the relationship of the frequence of the mean and amplitude load, obtained the zero mean equivalent loads using Goodman experiential fatigue equation, acquired the Weibull distributing functions of equivalent loads of respective roads.

第三，测定了汽车前桥在一般沥青公路、山区公路和试验场强化试验路面的载荷时间历程。对载荷时间历程进行了二次采样和数据预处理。采用雨流计数法得到了各路面的载荷均、幅值的频次关系，并根据Goodman经验疲劳公式，得到了零均值的等效载荷及相应的频次。利用数理统计的方法得到了各路面的等效载荷的Weibull分布函数。

Diabetes is a social disease that affects several million people worldwide.

糖尿病是一个社会性疾病，全世界有数百万人罹患此病。

I'll call you on Friday to see if we can reschedule our luncheon meeting at your convenience.

我星期五会给您打电话在您方便的时候我们重新安排我们的午餐约会。