查询词典 lift pump

High lift pump, but water is not applicable to

离心泵扬程较高，但出水量不大，适用于

This is the same impeller diameter, the vortex pump blades than any other reasons for the high lift pump.

这也是相同叶轮外径情况下，旋涡泵比其它叶片泵扬程高的原因。

Gas lift pump is a group composed of interconnected chamber fluid lifting system of wells.

气举升液泵是一组相互连通腔室组成的井液举升系统。

After determining the type of pump, it is necessary to consider their economic performance, with particular attention to the lift pump and the power flow and the related selection.

确定水泵类型后，要考虑其经济性能，特别要注意水泵的扬程和流量及其配套动力的选择。

Pump lift pump depends on the size of the structure such as the impeller diameter the size of the blades bend, and so on, the speed.

泵的扬程大小取决于泵的结构如叶轮直径的大小，叶片的弯曲情况等、转速。

This is the same diameter impeller circumstances, other than the vortex pump leaves the reasons for the high lift pump.

这也是相同叶轮外径情况下，旋涡泵比其它叶片泵扬程高的原因。

Also known as the centrifugal pump lift pump pressure head, the weight of fluid monomer is received by the pump energy.

离心泵的扬程又称为泵的压头，是指单体重量流体经泵所获得的能量。

The installation system for the election of the lift pump is another important performance data, the general need to enlarge 5 to 10 percent cushion to lift after the selection.

装置系统所需的扬程是选泵的又一重要性能数据，一般要用放大5%—10%余量后扬程来选型。

Nadequate flow of reasons: the actual lift pump lift more than allowed; speed does not support or belt slip, low speed; axial flow pump blade installation angle is too small; smoke way too high; at the end of valve, pipe and impeller Impeller partially plugged or defect; water possession of a serious leak.

SW卧式管道离心泵流量不足原因： IS、IR卧式单级单吸清水离心泵实际扬程超过允许扬程；转速不配套或皮带打滑、转速偏低；轴流泵叶片安装角太小；吸程过高；底阀、管路及叶轮局部堵塞或叶轮缺损；出水管漏水严重。

Nadequate flow of reasons: the actual lift pump lift more than allowed; speed does not support or belt slip low speed; axial flow pump blade installation angle is too small; smoke way too high; at the end of valve pipe and impeller Impeller partially plugged or defect; water possession of a serious leak.

SW卧式管道离心泵流量不足原因：IS、IR卧式单级单吸清水离心泵实际扬程超过答应扬程；转速不配套或皮带打滑、转速偏低；轴流泵叶片安装角太小；吸程过高；底阀、管路及叶轮局部堵塞或叶轮缺损；出水管漏水严重。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。