查询词典 length

The choice for material of iron core, all the structure design and the method of collimation for the magnet were also described. Simulation results of Opera show that when the length of the core is 220 mm, the effective magnetic length is about 302 mm and the maximal magnetic density is around 0.215 T at four interior angles. Corresponding field uniformity is within 0.8% in the area of 133 mm×200 mm.

根据磁铁的设计指标，给出了磁铁设计要求铁芯材料选择方法、整体的结构设计以及如何对磁铁进行定位和准直，并采用Opera程序进行模拟计算，结果表明：当铁芯长度为220 mm时，磁有效长度大约为302 mm；磁感应密度最大的地方在4个内角上，约为0.215 T；在133 mm×200 mm的平面范围内，磁场均匀性优于±0.8%。

With the basal stem of short spike L.brevitaba and its coterminous stolon, clonal ramet taken from grasslands which were non-degraded, light-degraded, moderate-degraded and heavy-degraded as the materials, the differences of stolon number and its length and the dry weight per unit of length of short spike L.brevitaba stolon from different degraded grassland were studied.

方法］以未退化、轻度退化、中度退化、重度退化草地上挖取的短穗兔耳草基茎及与其相连的匍匐茎和无性系分株为材料，研究不同退化草地上短穗兔耳草匍匐茎的数量、长度和单位长度匍匐茎干重的差异。

The following information is typically needed for each SKU: Item length, width, height, and weight Active picking location for the item Case quantity and dimensions (length, width, height, and weight) for items stored by the case Pallet quantity (or cases/tier and tiers/pallet) for items stored by the pallet Vendor if items are to be stored in vendor groupings Family group if items are to be stored by product groupings Special storage conditions, if applicable (flammable, refrigeration, etc.) Maximum stacking height or crushability factor, if applicable Items that are often sold together, if applicable.

下列信息通常需要为每个sku：项目长度，宽度，高度，体重活跃采摘地点为案例项目数量和尺寸(长度，宽度，高度，和重量)项所储存的案例托盘数量(或个案/层与层/pallet)用于存放物品的托盘如果卖方的项目将被储存在卖主集团77家，如果项目要储存产品gr oupings特别贮存条件下，如果适用最大堆叠高度或crushability因素，如果适用项目，常常一起出售，如果适用。

Considered that the confined crystallization behavior is relevantto both the soft and the hard segment average length, a ratio of the two segment length, defined as ζ, is used to characterize the crystallizability of the hard segmentsunder a limited environment.

这个最低的硬链段含量随软链段分子量增加而稍有下降，但是对应的硬链段长度却是线性增加的。

Because I only make rods of one length from each culm, I cut each culm to length before splitting.

因为我只会使棒的一个长度从每个秆，我将每个秆长度之前分裂。

The results are as follows: the dwarf mutant A846 pertain to half-dwarf type, which height is about 38.64 cm on average, preponderating over the half-height of the wild-type, the elongation stage of the mutant represent dwarf character, internode elongation patterns of caulis are similarly the sh-type dwarf mutant, in which the first internode shows specific reduction, the elongation of these cells in the elongation zone immediately above the IM was dissimilar to the wild-type, longitudinal length of parenchyma cells were curtate, also the first internode exhibit markedly, which average is under the corresponding internode of the wild-type, the differentiation of the IM of each internodes of stem was similar to wild-type, as well as the number of internodes and the length of sheath of flag leaf.

结果表明：突变体A846平均株高38.64cm，大于野生型株高的一半，为半矮秆类型；其矮生性在拔节期显著表现；主茎茎秆各节间收缩比例不一，穗下第一节间显著缩短，与sh-型突变体类似；茎秆各节间居间分生组织细胞分化正常，由居间分生组织分化的细胞延伸受到不同程度的阻碍；各节间基本组织细胞纵向长度相应缩短，穗下第一节间缩短比例最大，其平均值小于野生型的一半；主茎节间数目与旗叶的叶鞘长类似于野生型。

First,image structure vector field is derived from source luminance orthonormal vector sets. Andusing neighbor vectors to improve the weak gradient fields produces the structure vectorfield that is needed by LIC rendering. Then, LIC convolution step-length is adjustedaccording to local curvature in the structure vector field. LIC convolution length iscalculated according to the local statistical characteristics of the texture image. Finally, thealgorithm transfers the reference image\'s color characteristics to the rendering result tomake it full of rich color like oil paintings.

该算法通过计算源图像亮度分量的切矢量产生图像的结构矢量场，并对弱矢量区域进行邻域填充处理，获得LIC绘制所需的结构矢量场；然后，根据结构矢量场的局部曲率特征调整LIC的积分步长，并根据纹理参考图像的局部统计特征，自适应地改变LIC的积分长度；最后，将颜色传输算法引入LIC绘制结果，对绘制效果颜色进行渲染。

Paper feeding length is 1/3 of the cutting plane length

按 进纸长度为切割面长度的1/3

Press . Paper withdrawing length is 1/3 of the cutting plane length

按 退纸长度为切割面长度的1/3

Press . Paper feeding length is the cutting plane length

按 进纸长度为切割面长度

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷