查询词典 leakage magnetic flux

Experiment results indicate that the magnetic fluid flux has a direct relation with the magnetic field under the effect of traveling wave magnetic field. The bigger the magnetic field is, the more the flux is, when the structure of the magnetic fluid travellig pump and the saturation magnetization of magnetic fluid are constant. The volumes of the magnetic fluid from the travelling wave pump increase from 1.9 ml to 3.1 ml, when the magnetic field intensity increases from 25 900 A/m to 40 000 A/m. In addition, the change rate of the magnetic fluid decreases with the increase of the magnetic field due to the effect of magnetic field on magnetic fluid viscosity. The bigger the saturation magnetization of the magnetic fluid is, the more the flux is.

结果表明，行波磁场作用下的磁性流体流量与磁场的强度有直接关系：在磁性流体行波泵结构和磁性流体饱和磁化强度相同的条件下，磁场强度越强，其流量越大；当磁场强度从25900A/m增加到40000A/m时，单位时间内从行波泵内流出的磁性流体的体积由1.9 ml增加到3.1 ml；随着磁场强度的不断增加，磁性流体流量的变化率由于磁场对其粘度的影响而减小；而磁性流体的饱和磁化强度越大，其流量也越大。

The main magnetic bookmark, magnetic WordPad, magnetic darts, magnetic bottle opener, magnetic phone book, magnetic clasp, magnetic toys, magnetic refrigerator, the compass, magnetic stationery, magnetic jewelry, magnetic key chain, magnetic linkage, magnetic buttons and various magnetic gift.

其主要有磁性书签、磁性写字板、磁性飞镖、磁性开瓶器、磁性电话本、磁力扣、磁性玩具、磁性冰箱贴、指南针、磁性文具、磁性首饰、磁性钥匙扣、磁性挂钩、磁性钮扣及各种磁性礼品。

Ordinary solder materials, lead-free solder, the lead-free solder wire, solder paste, solder, the solder wire , high temperature tin, the low-temperature tin-line, lead-free tin-silver, the lead-free tin-silver line, low-temperature lead-free tin line, welding aluminum tin, the tin-aluminum welding wire, welding wire stainless steel tin, aluminum welding flux not stainless steel flux, environmental flux, welding of stainless steel, nickel, special aluminum solder, aluminum flux, aluminum brazing soft agent, paint remover, paint stripping powder (high-temperature paint stripping enameled wire a few seconds), copper aluminum welding, aluminum and aluminum welding, wire flux of new environmental protection (smoke-free and tasteless, non-volatile non-flammable) peaks of water-soluble flux, no-clean rosin flux, no-clean flux, thinners, cleaning agents, plate washer water , clean water machine, special purposes, such as water-soluble flux.

普通焊锡材料，无铅焊锡条、无铅焊锡线、焊锡膏，焊锡条、焊锡线、高温锡条、低温锡线、无铅含银锡条、无铅含银锡线、无铅低温锡线、焊铝锡条，焊铝锡线、焊不绣钢锡线、焊铝助焊剂、不绣钢助焊剂、环保助焊剂、焊不锈钢、镍、铝特种焊料、铝助焊剂、铝的软钎剂、脱漆剂、脱漆粉、铝铜焊接、铝与铝焊接、环保新型线材助焊剂(无烟无味、不挥发不易燃)水溶性波峰助焊剂、免清洗松香助焊剂、免清洗助焊剂、稀释剂、清洗剂、洗板水、抹机水、特殊用途水溶性助焊剂等。

Firstly, the relationship between the magnetic pole state of active magnetic pole and the running state of passive magnetic pole was analyzed. The electromagnet's four magnetic pole state and switch sequence, which can drive permanent magnet rotate, were ascertained. Secondly, taking one of magnetic pole state NS (N denotes electromagnet's left magnetic pole and S right magnetic pole) as an example, the distribution of space magnetic field was studied. In addition, the mathematical model of space magnetic field was set up based on the magnetic circuit fundamental and using the method of magnetic analysis and modeling. Lastly, the four states' mathematical model of space magnetic field was solved by using the MATLAB.

首先，分析系统主动磁极磁极状态和从动磁极转动状态之间的关系，确定驱动永磁体转动的电磁体4个磁极状态及切换顺序；其次，基于磁路基本原理，通过磁场分析和建模，以电磁体4个磁极状态之一的NS（N表示其左极、S为右极）为例，对电磁体的空间磁场分布进行研究并建立空间磁场数学模型；最后，以MATLAB为平台对4个磁极状态的空间磁场数学模型进行求解，将求解结果与实验数据进行对比。

Leakage in the initial observation to determine the basis of the leakage site, and then manually set car observation, if the leakage were no significant changes in static and dynamic sealing ring problem; such as the disk when there are significant changes in leakage can be concluded that the dynamic , static friction ring problems; such as leakage of medium along the jet axis, while moving most of Central ring problems, leakage to the surrounding medium or from the water spray cooling holes in the leakage, the seal ring for static failure.

在初步观察泄漏量、判断泄漏部位的基础上，再手动盘车观察，若泄漏量无明显变化则静、动环密封圈有问题；如盘车时泄漏量有明显变化则可断定是动、静环摩擦副存在问题；如泄漏介质沿轴向喷射，则动环密封圈存在问题居多，泄漏介质向四周喷射或从水冷却孔中漏出，则多为静环密封圈失效。

Leakage in the initial observation to determine the basis of the leakage site, and then manually set car observation, if the leakage were no significant changes in static and dynamic sealing ring problem; such as the disk when there are significant changes in leakage can be concluded that the dynamic , static friction ring problems; such as leakage of medium along the jet axis, while moving most of Central ring problems, leakage to the surrounding medium or from the water spray cooling holes in the leakage, the seal ring for static failure.

在初步察看泄漏量、断定泄露部位的基本上，再手动盘车视察，若泄漏量无显明变更则静、动环密封圈有问题；如盘车时泄漏量有显著变更则可判断是动、静环摩擦副存在问题；如泄漏介质沿轴向喷射，则动环密封圈存在问题居多，泄漏介质向四周喷射或从水冷却孔中漏出，则多为静环密封圈失效。

Leakage in the initial observation to determine the basis of the leakage site, and then manually set car observation, if the leakage were no significant changes in static and dynamic sealing ring problem; such as the disk when there are significant changes in leakage can be concluded that the dynamic , static friction ring problems; such as leakage of medium along the jet axis, w你好le moving most of Central ring problems, leakage to the surrounding medium or from the water spray cooling holes in the leakage, the seal ring for static failure.

杂质泵安装静试时泄漏机械弥缝安装调试好后，一般要进行静试，察看泄漏量如泄漏量较小，多为动环或静环弥缝圈存在问题；泄漏量较大时，则表白动、静环磨擦副间存在问题在开端察看泄漏量、判断泄漏部位的根蒂根基上，再手动盘车察看，若泄漏量无明显变化则静、动环弥缝圈有问题；如盘车时泄漏量有明显变化则可下定论是动、静环磨擦副存在问题；如泄漏介质沿轴向喷洒，则动环弥缝圈存在问题居多，泄漏介质向四周喷洒或从水冷却孔中漏出，则多为静环弥缝圈失效此外，泄漏通道也可同时存在，但一般有主次区分，只要察看细致，认识结构，一定能正确判断

In this system,the VVVF(variable voltage variable frequency) control method based on magnetic flux trajectory is applied.In the system,it is the target for the magnetic flux linkage polygon to be greatly approximate to the ideal magnetic flux circle.Considering such limitations as the low speed torque ripple,high speed real time and the working frequency of switching element,through the subsection synchronization control method by applying different numbers of magnetic flux linkage polygon for different frequency range,the perfect precision specifications for speed can be obtained.

系统采用基于磁通轨迹法的他控式变频调速方案，以磁链多边形尽量逼近理想磁通圆为目标，并考虑低速转矩脉动、高速实时性和开关元件的工作频率限制等约束条件，通过采用分段同步控制方式，在不同的频段采用不同的磁链多边形边数，使系统获得了优异的转速精度指标。

Faraday's law is that when the flux in the conductor loop changes, it produces electromotive force in the conductor loop, and obeys to contour integral law , Maxwell Curl Theory is that when the magnetic intensity of a certain point in ether space changes, there produces electric field at that point in ether space, which is the field mutual production theory of "electric field produces magnetic field and magnetic field produces electric field" in the free space which everybody is familiar with, and it obeys differential law , Lorentz magnetic force is that when metal electrons cut magnetic lines, metal electrons forced by move along the conductor to form inductive current, in fact, it doesn't matter whether coil moves or magnet moves, only if there exists relative motion between magnetic field and conductor, metal electrons must cut magnetic lines, which is,"coil stills while magnet moves to the left" and "magnet stills while coil moves to the right" these two situations are the same, which both belong to metal electrons having cut magnetic lines.

法拉第定律指导体环路里的磁通量发生变化时，在导体环路上产生电动势，而且服从围线积分律；麦克斯韦旋度理论指以太空间某点的磁场强度发生变化时，在以太空间的该点产生电场，即大家熟知的自由空间里"电场生磁场与磁场生电场"之互生场理论，而且服从微分律；洛伦兹磁力指金属电子切割磁力线时，金属电子受力沿着导体漂移而形成感应电流，其实，无论线圈运动或是磁铁运动，只要磁场与导体存在相对运动，则金属电子必然切割磁力线，即，"线圈静止而磁铁向左运动"与"磁铁静止而线圈向右运动"这两种情况是一样的，都属于金属电子切割了磁力线。

The method includes the following steps: depositing a non-magnetic layer (3) of sufficient thickness; anisotropically etching the non-magnetic layer to form a steep wall of suitable dimensions at the required position of a flux guide; depositing a magnetic material to form a magnetic layer (9) on the wall in such a manner that the magnetic layer has a thickness corresponding to the required track width; removing undesired deposits of magnetic material but maintaining the magnetic layer on the wall; depositing an insulating material (19a) to cover the magnetic layer.

该方法包括下列步骤：淀积足够厚度的一个非磁层(3)；非均质地蚀刻该非磁层以便在磁通引导的要求位置形成适宜尺寸的阶跃内壁；淀积一个磁性材料，以便在该内壁上形成一个磁层(9)，使得该磁层具有对应于该要求的磁迹宽度的一个厚度；去除不希望的淀积的磁性材料而保持在该内壁上的磁层；淀积一个绝缘材料(19a)以便覆盖该磁层。

The circulation, consumption and reproduction of the trilogy have not only testified to its historical significance and literariness, but also invested it with new meanings.

该三部曲的流通、消费与再生产不仅验证了其历史意义及文学性，而切还赋予它以新的意义。

If he thought that he could buy me off, he would be wrong.

如果他认为他可以收买我，那他就大错特错了。