查询词典 leading edge

Outside from the inside and outside the tangent way to cut into the curved outer edge to the APEX point, then along the outer edge of the exit turn driving directions ...

外内外的切线方式就是由弯道外沿向APEX点切入，再沿着弯道外沿驶出的驾驶路线。。。。

The lower edge of a sail.the overhang at the lower edge of a roof.

位于屋顶的最低的边缘的上方的突出部分。

It used static edge that was tilted slightly with respect to the columns of fibre to achieve different value of different row. This method replaced scanning in conventional test and it was not necessary to ensure that edge was parallel strictly to array .

这种方法对静止刀口成像，利用刀口与光锥纤维列间的一定倾斜角度，在垂直于刀口的不同行之间形成不同的值，代替了传统刀口扫描中的扫描装置，并无需保证刀口与阵列的平行，相应地减小了测量误差。

The outside vane of the double layered shutter inlet port or the vane of the single shutter inlet port can be parallel either to the long edge or to the short edge, which is being to adjusted to the needs of customers.

双层百叶风口的外层叶片或单层百叶风口的叶片可以平行于长边，也可以平行于短边，可以根据客户的要求来选择。

According to the feature, the blurred edge of the target in the superposition region can be detected, and the target edge parallel to the motion blur direction is detected by a Canny operator.

基于该灰度变化特征检测运动模糊方向上的目标边缘，并利用Canny算子检测平行于模糊方向的边缘，两部分边缘进行求或运算并进行形态学处理，从而分割得到完整的目标模糊图像。

The main features of the aircraft, such as the use of non-wings to fly the end of the distribution, control surface layout of the wing trailing edge or trailing edge parallel to the use of carbon fiber composite body manufactured, and so on, are conducive to the reduction in RCS.

该机的主要特点，例如采用无尾飞翼布局、控制面布置在机翼后缘或与后缘平行、采用碳纤维复合材料制造的机体等，都有利于缩减RCS。

The measured object can be found within a few milliseconds in the raster-scan image. 4 . Two lines delay for the processed image is implemented using two 128×8 shift registers with the configurable logic block in FPGA. A new fully pipelined bit parallel hardware architecture for Sobel edge detection is implemented with FPGA. Furthermore, it takes no more than 2ms to complete the edge detection of an image with 128×128 pixels.

视觉检测信号的前端处理技术 1、系统地分析了视觉检测算法层次性特点和计算特点，提出了提高视觉检测信号处理速度的基本方案：采用前端处理系统，自动识别被测物体在获取图像中的位置，并将真正有用的被测物体的边缘坐标值，提供给计算机，作进一步的高精度处理； 2、系统研究了实时图像硬件处理的设计基本方法，提出了基于FPGA的视觉检测信号的低级处理算法硬件实现模块化模型； 3、提出了一种新的基于FPGA的模板匹配并行模块化结构，解决了二维图像处理高带宽要求，在几毫秒内就可以在按扫描顺序输入图像中找到检测目标物体的位置； 4、采用FPGA内部的可配置逻辑块实现了128×8移位寄存器的设计，解决了大容量移位寄存器与FPGA内部寄存器数量之间的矛盾，实现了两行图像的延迟。

Fold back the edge of the hem 1.0cm(3/8 inch); pick up one thread of the hem, keeping the needle parallel to the edge; and then pick up one thread of the garment 1.0cm(3/8 inch) away. The thread of the finished hem should have an even tension.

折叠底边1.0cm(3／8英寸)，挑起底边上的一根线，针与底边保持平行，然后间隔1.0cm(3／8英寸)，挑起衣片面料上的一根线，缝后的底边上的线应有均等的拉力。

Finally, according to the characters that the inner and outer edge of double-layer eyelid are approximate parallel and the gray distribution changes sharply on the edge of inner eyelid, take the fitting curve acquired in first eyelid location as a template, and shift it down parallel to detect the position where gray value changes abruptly.

最后，根据双层眼睑的内外层边缘近似平行、而且在内层眼睑边缘处出现灰度跳变这一特点，以第一次定位所得拟合曲线为模版，平行下移搜索灰度跳变位置，完成对双层眼睑的二次定位。

As the edge pixel value varies from non-edge pels value largely, which resulted that it can't satisfy the condition of building GM(1,1,C) and the error of GM(1,1,C) whiterization value is large.

依据边缘像素点其亮度与非边缘像素点亮度相差大而不满足GM(1，1，C)建模条件，从而导致边缘像素点白化值误差大的特点，实现边缘检测。

Methods Clinical data of 3 cases of bile duct injury during laparoscopic cholecystectomy were analyzed retrospectively.

回顾总结3例LC术中胆管损伤的临床资料，分析3例胆管损伤的原因及对策。

These techniques are applied to the gobang.

本文将这些技术用于五子棋中。