英语人>网络例句>leading coefficient 相关的网络例句
leading coefficient相关的网络例句

查询词典 leading coefficient

与 leading coefficient 相关的网络例句 [注:此内容来源于网络,仅供参考]

In SLDMINV the invariance of the Krylov subspace is invoked, making the main computation reduced into almost real arithmetic, and thus lowering the computation amount markedly. In the meantime, the iteration is performed in the Krylov subspace generated from the inverse of the coefficient matrix and so the convergent speed is enhanced greatly, leading to two orders of the magnitude improvement over standard SLDM.

SLDMINV中运用了Krylov子空间不变性技巧,这使得计算基本化为实运算,显著降低了计算量;同时在由系数矩阵的逆构成的子空间上进行迭代,收敛速度大大加快,较之SLDM提高两个量级。

A thick wing, full-length leading-edge slats and trailing edge "Junker" type flaperons develop a maximum wing lift coefficient of 3.10, while maintaining a short wing-span of less than 31 feet.

厚荣,完整长度的领先优势的缝翼和尾缘"克"型flaperons发展的最高机翼升力系数的3.10 ,同时保持在短期内永大跨度少于三十一英尺。

In the condition of the lower submergence depth, gas affecting is the principal factor leading to the low displacement coefficient.

在低沉没度条件下,气液比是导致抽油泵排量因数低的主要原因。

The Mahler measure of a polynomial P is the absolute value of the product of all roots of P that have modulus at least 1 multiplied by the leading coefficient.

中文摘要:多项式的Mahler测度指的是它的所有模大于1的根与其首项系数的乘积的绝对值。

In terms of order of industrial development, this thesis uses industrial engineering theory, establishes relevant coefficient matrix of leading industry choosing criterion and correlative effect matrix, calculates leading industry of Hebei province.

在工业行业发展序列的选择上,运用工业工程理论,建立主导产业选择基准相关系数矩阵和关联效应矩阵,测算比选出河北省工业主导产业。

Then we use Cramer\'s rule to obtain an estimate of the degree in q~(1/2) of the leading coefficient of the recurrence.

而后利用Cramer法则得到迭代关系首项系数中q~(1/2)的次数的一个估计。

Firstly, we prove a proposition : the leading coefficient regarded as a polynomial in q~n, q~(1/2 of the recurrence is not equal to zero for all n ≥ [m/2] + 1, where m is the degree in q~(1/2) of the leading coefficient.

首先,我们证明了一个命题:迭代关系的首项系数关于q~n,q~(1/2的多项式对所有的n≥1[m/2]+1均不为零,其中m为首项系数中q~(1/2)的次数。

In this paper, optimization of coupled coefficient for the leading wheelsets and trailing wheelsets of bogie is researched with genetic algorithms and the optimal matching law of coupled coefficient for leading and trailing wheelsets has been found when a vehicle negotiates all kinds of radii curve.

为了考察线路条件的变化对轮对耦合度取值大小的影响,本文采用遗传算法对磁流变耦合轮对车辆通过不同半径曲线时转向架前后轮对耦合度的匹配关系进行了优化研究。

For a given Sturm-Liouville equation with positive leading coefficient function, by use of the monotonicity results of its natural loops, limit of boundary conditions and eigenvalues in the space of self-adjoint boundary conditions, a proof of the equalities among eigenvalues for coupled boundary conditions and those for separated boundary conditions is made.

内蒙古工业大学理学院副教授 2。对于给定的首相系数函数为正的 Sturm-Liouville方程,利用在自伴边界条件空间上自然圈、边界条件的极限和特征值的单调性的几个结果,给出了在偶合边界条件与分离边界条件下的特征值间的一些等式的证明。

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80~100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100~300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能,且合金内的V元素会向表面富集,因此,钛合金真空热处理和表面涂层的烧结温度不能过高,即应低于其相转变点;通过对生物活性梯度涂层的组成和结构的设计,分析和计算了梯度涂层内的应力大小和分布,结果表明:对于本研究,当成分分布系数n=1.5时,可以获得较合理的涂层力学性能,即在沉积开始时,采用富含BG颗粒的悬浮液,以便在钛合金侧获得同底层BG有良好过渡的富BG涂层;梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定,改变成分分布系数,只能改变涂层内应力变化的趋势;涂层的厚薄不影响涂层内的应力分布规律,但涂层越薄,涂层内的应力变化越快,但这并不意味着涂层越厚越好,因为涂层越厚,涂层允许的变形越小,对于应用于弯曲受力部位的涂层而言,涂层应薄一点为好(50μm);而对于仅纯受剪切应力的部位,如牙根种植体,涂层可适当加厚(80~100μm);通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现,它们在水溶液体系中很难发生电沉积;在无水乙醇溶液中,HA颗粒带正电,可在阴极钛合金片上发生均匀的电泳沉积,而BG颗粒则带负电荷;利用复分解反应法,可以制得100~300nm的HA,通过诱导HA在BG颗粒表面结晶,可对BG颗粒进行表面包覆,获得了被HA包覆的BG颗粒,改变了BG颗粒表面的带电特性,使BG和HA颗粒在无水乙醇中均带上正电荷,从而实现了HA和BG颗粒在阴极上的共沉积。

第1/3页 1 2 3 > 尾页
推荐网络例句

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气,收缩臀部肌肉;拱起身体,尽量抬起头来,右腿伸直朝向天花板(膝微屈,以避免肌肉紧张)。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化,但却比去年同期高8%。

However, to get a true quote, you will need to provide detailed personal and financial information.

然而,要让一个真正的引用,你需要提供详细的个人和财务信息。