查询词典 leaching sulfide

Results show that, following the leaching time extending, the leaching concentrations of heavy metals and lixiviate toxicity of heavy metals increase in the fly ash. When the ratio of liquid and solid add, the leaching concentrations of heavy metals obviously become big, and the Cd's leaching concentration is the biggest, when the ratio of liquid and solid is 90, the Cd's leaching ratio exceed the percent of 70. At the time pH is about 7, the leaching concentrations of heavy metals are the lowest. When the grain size is the bigger or little, the leaching concentrations of heavy metals are lower, however when the grain size is 250-900 μm, the concentrations are higher. After fly ash melt in the high temperature, the lixiviate toxicity of heavy metals greatly reduce, which explains that the effect of melting on heavy metals' stabilization is very good.

结果表明，随着浸出时间的增加，飞灰绝大部分重金属的浸出浓度增高，浸出毒性增强；液固比增加，大部分重金属的浸出率大大提高，其中重金属Cd的浸出率最大，在液固比为90时，飞灰中的Cd的浸出率达到70%以上；pH为中性左右的时候，医疗垃圾飞灰中的大部分重金属的浸出液浓度最低；颗粒尺寸在较大或者较小时，医疗垃圾飞灰中的大部分重金属浸出浓度较小，大部分重金属在颗粒尺寸250～900 μm时，重金属的浸出浓度较高；飞灰高温熔融后，重金属的浸出毒性大大降低，说明熔融对重金属有很好的固化效果。

A method for the analysis of zinc oxide phase content in sulfide ore was studied. On the basis of the characteristics of each phase component, the sulfide ore sample was leached twice with NaOH and acetic acid-ascorbic acid, respectively, so that the oxide mineral and zinc oxide were dissolved completely. The leaching rate of zinc oxide phase was up to 98 Vo. Moreover, the dissolution of zinc sulfide phase was effectively inhibited, solving the problems of selective leaching and determination for zinc oxide.

研究了硫化矿中氧化锌相含量的分析方法，根据硫化矿中各物相组分特点，提出了用氢氧化钠溶液和乙酸－抗坏血酸溶液二次浸取硫化矿，使锌氧化矿、氧化锌充分溶解，氧化锌相的浸取率达到98%以上，同时有效地抑制了硫化锌相的溶解，较好地解决了氧化锌相选择溶解测定的问题。

Na2S-leaching process,microbe-leaching process and mechanochemistry directly leaching process were introduced and compared,the result showed that Mo leaching ratio could reach 99% by mechanochemistry directly leaching process for wulfenite,in which process energy consumption was the lowest,and least equipment was needed,the newly developed process was the best way to recover Mo from wulfenite.

硫化钠浸出工艺、生物浸出工艺、机械化学直接浸出工艺三种工艺的比较结果显示，机械化学直接浸出工艺具有能耗低、设备少、钼浸出率高等优点，是处理钼铅矿的最理想的方法，钼的浸出率可达到99%以上。

Sulfide layer was made on the surface of high speed steel (W6Mo5Cr4V2) by means of low temperature ion sulfurization. The tribological properties of the sulfide layer under dry sliding were investigated on an MM 200 friction and wear test rig. An atomic force microscope and a scanning electron microscope equipped with an energy dispersive spectrometer attachment were adopted to analyze the morphologies and compositions of the original and worn surfaces of the sulfide layer. The phase structure of the sulfide layer was determined by X ray diffraction.

采用低温离子渗硫工艺在 W6 Mo5 Cr4 V2高速钢表面制备了硫化物固体润滑层，在 MM- 2 0 0型摩擦磨损试验机上对渗硫层的摩擦学性能进行了干摩擦试验研究，用原子力显微镜及扫描电子显微镜和 X射线光电子能谱分析渗层表面、截面、磨面的形貌及成分，用 X射线衍射仪分析了渗硫层相结构。

To Dabaoshan copper ore, at slurry concentration of 10%, lixivium pH of 2. 0, with the domesticated bacterial, copper extraction could reach 27. 84% after 25 days leaching in sample 1〓, in which low grade copper sulfide ore is the main component; in sample 2〓, hypo-sulfide ore is the main component, copper extraction could reach 77. 78% after 10 days leaching.

大宝山铜矿石细菌浸出工艺条件试验研究表明，对于以低品位硫化矿为主的1〓矿，当矿浆浓度为10％、浸出液pH2.0，采用驯化的菌种浸出25天，Cu浸出率可达27.84％；在相同浸出条件下，对于以次生硫化矿为主的2〓矿，浸出10天，Cu浸出率可达77.78％。

Compared the result of experiment with single leaching, multi leaching of cross current and continuous counter current leaching, in the light of characteristic of waste and inferior tobacco leaves, a special leacher of continuous counter current is devised, and the efficiency of leaching by the operating condition tested too.

对单级浸取、多级错流浸取和连续逆流浸取进行了试验比较，并结合废次烟叶浸取的特点，设计出一种连续逆流浸取器，并研究了该装置的操作参数对浸取率的影响。

Pyrometallurgy and hydrometallurgy are introduced in this article,pyrometallurgy,ammoniacal leaching and high-pressured acid leaching has obvious disadvantage.Craft simply,energy consumption low,the operation easy to control,investment low are the merits of the constant-pressured acid leaching.It is belived that constant-pressured acid leaching w...

本文介绍的红土镍矿处理工艺有火法工艺和湿法工艺，其中火法工艺和湿法工艺中的氨浸法、高压酸浸法存在明显缺点，而常压酸浸法有工艺简单、能耗低、操作易于控制、投资少等优点，将会有很好的发展前景。

The results from laboratory research indicated that the max rate of dry leaching is 4%;The rate of wet leaching of vitriol is higher than hydrochloric acid, when the concentration of vitriol is 40%, measuring Ratio of Solid to Liquid of serpentine and vitriol is 4:1.,and joined helper leaching agent: HF (The amount put in is 1.2%-1.5% of the 40% vitriol), the rate of leaching of magnesia could over 98%. After using ammonia to trash extraction, basic magnesium carbonate is acquired by ammonium hydrocarbonate.

经过实验室研究，干法氧化镁的浸出率未超过4％；湿法硫酸的浸出率高于盐酸，在硫酸浓度为40％，硫酸与蛇纹石的液固比为4：1时，加入助浸剂HF(加入量为40％硫酸质量的1.2％-1.5％)后氧化镁的浸出率为98％以上。

The process of three-step countercurrentleaching is presented, in the first leaching step Fe as leading impurity inthe matte is leached priorly, Co and Ni are enriched in the residue of thefirst step and then are leached in the second leaching step with a lowconcentration acid, the residue from the second step containing hardleaching Fe, Co and Ni are leached with a high concentration sulfuricacid in the third step, and Cu stays in the final resude, the leachate of thethird leaching step is diluted and divided into two parts as the leachantsto the first and second leaching step.

在此基础上，提出了三段逆流选择性浸出技术：即第一段用低酸优先浸出钴冰铜中杂质铁，将钴镍富集到第一段的浸出渣中，第二段再用低酸浸出渣中部分钴镍，第三段用高酸浸出第二段渣中难浸的钴镍铁，将铜留在最终的浸出渣中，第三段浸出液经稀释，分流，分别返回至第一段，第二段作低酸浸出介质。

The results show that the optimal parameters of this technique are as time of 3 h, temperature of 150 ℃, ratio of liquor to solid of 1.21, H2SO4 additions of 25%, 85% material granularity of 0.095 mm. The one-step leaching percent of vanadium can reach 77%, the leaching percent obtain 90% after two-step countercurrent leaching. The vanadium leaching percent have growth and decline relation to occupation ratio of vanadium in in-soluble silicoaluminate mineral.

结果表明：该工艺的最佳工艺参数如下，即时间3 h、温度150 ℃、液固比1.21、硫酸用量25%、85%矿石粒度粒经小于0.095 mm；在此条件下，钒的一段浸出率为77%左右，而矿石经过两段逆流浸出后，钒浸出率可达90%；钒浸出率与矿石中难溶硅铝酸盐相中的钒占有率呈现消长关系。

Finally it offers the analysis of the fault-tolerance system as well as its test verification.

这样，运行于空间环境中的系统的设计目标就是在保证系统实时性

However, it is still difficult to find out the real reason of the increase of the keratinized gingiva during the orthodontic extrusion whether it is due to the proliferation of the gingival tissue or to its elastic nature, that is because the proliferation of the fibroblasts as well as the connective tissue changes in volume and the intra-fibers spaces were all immeasurable in most of the studies.

然而，仍然难以找到真正的原因增加的角化牙龈在正畸挤压它是否是由于扩散的牙龈组织或其弹性性质，这是因为增殖的成纤维细胞以及作为结缔组织的变化量和内部纤维空格都是不可估量的，大多数的研究。