查询词典 layer
- 与 layer 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The mixing layer meteorologically is one kind of the atmospheric boundary layer.
所谓&混合层&在气象学上系指近地面1000m附近,气流受地表扰动及热对流效应影响,具有充份的上下混合效应之一大气边界层。
-
Three hypotheses is put forward, based on microexamination about sample evaporation during determaination of isotope abundance by thermal ionization:1. Only atoms uncovered by outer layer atoms can be vapoured; 2. Atoms covered by outer layer atoms can diffuse but cannot vapoure; 3. The probability of diffusion of isotope atoms is in direct proportion to its probability of evaporation.
根据对热表面电离源同位素丰度测量过程中样品蒸发的微观研究,提出如下三条假设:(1 )未被外层原子覆盖的原子才能蒸发;(2 )被外层原子覆盖的原子只能扩散不能蒸发;(3 )同位素原子的扩散几率与蒸发几率成正比。
-
The characteristic of machined surface of high speed machining aluminum alloy 7050-T7451 is researched by micrographic experiments and analysis. The formation mechanics of machined metamorphism layer has been analyzed and studied. The dislocation-energy model in machined metamorphism layer was established and applied to explain the micrographic mechanics work-hardening using the thermo-mechanical coupling deformation theory and dislocation theory. The experimental results show that the interaction of high dislocation density effect on hardening is more remarkable than that of thermal stress in high speed machining.
利用显微观察方法对铝合金7050-T7451高速铣削加工的工件表面断面和不同深度的表层的微观形貌特征进行系统的研究,确定了高速切削加工铝合金7050-T7451的表面变质层深度为30~35μm;应用位错能量研究了高速铣削加工过程的热力耦合对变质层的影响机理,并通过微观形貌观察证明:与普通切削相比,高速铣削表层塑性变形的能量和位错密度更高;建立了位错密度的加工硬化的动力学模型,研究了加工硬化的热-力耦合形成机理;对微观裂纹的形成机理进行了理论分析,证明位错密度高的高速切削过程中较低速加工更容易产生明显的微裂纹,从分子级乃至原子级的水平进一步揭示高速切削加工表面变质层的形成特征。
-
Glomeruli layer and granules layer of accessory olfactory bulb exist significant difference in the Cricetulus barabensis and Microtus mandarinus.
黑线仓鼠和棕色田鼠副嗅球中嗅小球层和颗粒层也存在明显的差异。
-
The results show that the2 0~ 40 cm and40~ 60 cm layers for the red loessial soil and2 0~ 40 cm layer for the red loessial soil had a large amount of easily mineralizable nitrogen besides the0~ 2 0 cm layer, but the easily mineralizable nitrogen was little...
总体上看,红油土中氮素的矿化和硝化作用强于红垆土。铵态氮肥在粘粒含量少、有机质含量高土层中的迅速减少主要归咎于硝化,而在粘粒含量多、有机质含量少的土层,主要取决于矿物固定
-
The results of the simulation showed that the GMI ratio for a sandwich structured film sandwiching high conductive metal layer was several times lager than that for a monofilm, and the maximum impedance change ratio occurred at the frequency of about 10 MHz which was lower than that of single layer film.
模拟的结果表明,中间夹高导电性材料的F/M/F型三明治薄膜的巨磁阻抗效应比同样厚度的单层磁性薄膜的巨磁阻抗效应要大很多,而且三明治薄膜出现阻抗最大变化时的频率大概在10MHz左右,比单层薄膜要低得多。
-
The majority of the insects feeding on or parasitizing in Picea crassifolia were monophagous or oligophagous; the minority of them were polyphagous. The insects feeding on or parasitizing in the bush layer and grass layer were largely polyphagous, a few were oligophagous, the oligophagous insects were very few.
在青海云杉寄生或取食的昆虫多数种类为单食性或寡食性,少数种类为多食性,取食或寄生于林下灌木层和草本层的昆虫大多数为多食性,少数种类为寡食性,较少为单食性。
-
The protection layer is a layer of polyvinyl alcohol oxygen, mainly to the oceans that oxygen on monosomic or oligmer inhibition.
爱护层是聚乙烯醇隔氧层,次给是用于隔绝氧不对单体或齐聚物的阻聚功用。
-
VxWorks provides the MUX interface to support independence between the network protocol layer and the data link layer.
VxWorks 提供了 MUX 接口支持网络层和数据链路层之间的独立性。
-
Likewise, when a driver in the data link layer needs to access the network layer, it calls the appropriate MUX routine.
同样的,当数据链路层需要访问网络层的时候,它也调用一个合适的 MUX 接口函数。
- 相关中文对照歌词
- Thin Layer
- 推荐网络例句
-
Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.
最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势,并设计了一款彩色夜视摄像机。
-
Only person height weeds and the fierce looks stone idles were there.
只有半人深的荒草和龇牙咧嘴的神像。
-
This dramatic range, steeper than the Himalayas, is the upturned rim of the eastern edge of Tibet, a plateau that has risen to 5 km in response to the slow but un stoppable collision of India with Asia that began about 55 million years ago and which continues unabated today.
这一引人注目的地域范围,比喜马拉雅山更加陡峭,是处于西藏东部边缘的朝上翻的边框地带。响应启始于约5500万年前的、缓慢的但却不可阻挡的印度与亚洲地壳板块碰撞,高原已上升至五千米,这种碰撞持续至今,毫无衰退。